Front Door Ice Wouldn't Work And Air Going Into Freezer
Thanks to the pictorial diagram, I was able to order correct parts. It was just a matter of removal of broken parts and replacing them. Ice maker now working and air is no longer getting into freeze...read more

The ice chute door didn't close all the timed
The door has nylon gear teeth that wore out and needed replaced. The ice chute came off very easy with 6 screws. I used a punch and pliers to remove the hinge pin. Then the door came off and the ne...read more

broke tab on cover bracket
removed old bracket and replaced with new one - two screws and it was done - simple...read more

Ice Maker Bucket would not rotate arm to dispense ice
This was a very easy repair. First, remove the Ice Bucket off the refrig door. Unfasten the white plastic shaft holder held in place by 2 hex head screws using a nut driver. Remove old shaft and inser...read more

Rust had corroded Front Plate and Drive Blade
Installation was completed by following the online Parts diagram. Had to completely remove all parts, including the blades in ice crusher, and re-assemble. Glad the online diagram was clear and easy...read more

Water dispenser hose tip broken.
The part to fix this was a $50.00 part.
I purchased this Bracket Dispenser for $6.00 and it fit on My fridge perfectly. I just used the screw hole that was a little higher on the water dispenser...read more

Plastic holder was cracked and broken
I removed the Ice container, removed the two screws that secure the holder, replaced the broken holder with the new one, replaced the screws, and put the ice container back in place. Total time, two m...read more

Kickplate support Clips failed
Replacing the support clips was simple. But since the replacements were the same as the ones that had failed, I modified them by epoxying metal strips on each side of the fingers which had failed. Wit...read more