EasyApplianceParts is now PartSelect! We've merged our sites to provide a better shopping experience for you.   Full Details
✖

Find Parts

Parts Departments

Top Model Types

Top Brands

Repair Help

Expert Repair Videos

Keep typing for more specific results...

Kenmore Refrigerator Electronics

Popular Kenmore Refrigerator Electronics

This capacitor (Refrigerator and Freezer Compressor Run Capacitor, Run Capacitor) provides the voltage or energy current required to start the compressor and keep it running. It allows the compressor in your appliance to easily cycle on and off. This capacitor mounts directly onto the compressor starting relay. If the capacitor is faulty the compressor may get unusually hot and draw excessive amperage. It the compressor overheats, it may fail to run until it cools down again. The compressor may also get noisy from overheating. If this part is totally electrically open, it is defective (often due to overheating) and needs to be replaced. The part measures 1 inch by 1-1/2 inches, and is constructed of plastic with two metal wire terminals. This item includes 1 capacitor, sold individually. This part comes in black.
This capacitor (Refrigerator and Freezer Compressor Run Capacitor, Run Capacitor) provides the voltage or energy current required to start the compressor and keep it running. It allows the compressor in your appliance to easily cycle on and off. This capacitor mounts directly onto the compressor starting relay. If the capacitor is faulty the compressor may get unusually hot and draw excessive amperage. It the compressor overheats, it may fail to run until it cools down again. The compressor may also get noisy from overheating. If this part is totally electrically open, it is defective (often due to overheating) and needs to be replaced. The part measures 1 inch by 1-1/2 inches, and is constructed of plastic with two metal wire terminals. This item includes 1 capacitor, sold individually. This part comes in black.
What this part fixes:
  • Clicking sound
  • Freezer not defrosting
  • Freezer section too warm
Installation Instructions
garth from forest lake, MN
My refrigerator stopped cooling and the freezer section stopped freezing
I knew the chances of all the freon leaking out was unlikely so I looked at the wiring to the compressor and there was a capacitor and a starter/overload so i figured I would start there. I went on line and found the parts at this site and they were less than the minimum service call charge for a service tech so I figured what the heck let's give her a shot so I did give it a shot. I ordered the parts and they were there in less time than a service tech could come out and i installed the parts and guess what for 90.00 in parts and 15 minutes in time I repaired my refrigerator. Thanks guys, It took less time to order the parts than it did to make the repair so thanks, your website rocks and is very well designed so my hat is off to you guys!
If your refrigerator is not cooling, a failed compressor run capacitor may be the cause. This OEM capacitor helps the compressor start and supports its operation in refrigerators and freezers. It has a capacitance of 15 MFD, so check fit against your appliance model before ordering. A quarter-inch socket or nut driver is listed for replacement.
If your refrigerator is not cooling, a failed compressor run capacitor may be the cause. This OEM capacitor helps the compressor start and supports its operation in refrigerators and freezers. It has a capacitance of 15 MFD, so check fit against your appliance model before ordering. A quarter-inch socket or nut driver is listed for replacement.
What this part fixes:
  • Clicking sound
  • Doesn’t stop running
  • Freezer section too warm
Installation Instructions
James from Navarre, FL
After getting wiring diagram off internet it was diagnosed as freezer stuck in defrost mode, temp alarm on, but fan running.
Turned gray knob on defrost timer (located bottom left back of freezer) past defrost position to verify compressor would run...it would not, but fan would run. Tested run capacitor...found borderline defective (weak, wrong value ohm meter kick). Just to be sure, removed interior shelves and interior rear and gasket to check heater at 20 ohms as OK and removed thermostat and verified contact closure after exposure in another freezer....re-installed, hooked heater back up and re-installed interior rear panel. Replaced defrost timer by unplugging 4-pin connector, then removed 2 screws that hold it to the bracket. Installed new one in reverse order. Then removed wire bail holding run capacitor to compressor plug assembly, removed run capacitor, plugged in new one. Turned on freezer......now making ice and holding cold temperature and cycling properly between freeze and defrost modes. Two problems made this repair a bit more difficult. This is the second time that defrost timer has failed...only got 3 years from last one.
Steady compressor operation relies on the electrical support provided by this refrigerator run capacitor. It creates a phase shift in the motor circuit to help the compressor run as designed while circulating refrigerant through the cooling system. A failed capacitor may contribute to unusual humming, difficulty starting, or reduced cooling performance. Replacing a faulty capacitor helps restore proper electrical conditions for compressor operation. The component stores electrical energy and can retain a charge after power is disconnected, requiring care during handling and replacement. This is an OEM part sourced directly from the manufacturer.
Steady compressor operation relies on the electrical support provided by this refrigerator run capacitor. It creates a phase shift in the motor circuit to help the compressor run as designed while circulating refrigerant through the cooling system. A failed capacitor may contribute to unusual humming, difficulty starting, or reduced cooling performance. Replacing a faulty capacitor helps restore proper electrical conditions for compressor operation. The component stores electrical energy and can retain a charge after power is disconnected, requiring care during handling and replacement. This is an OEM part sourced directly from the manufacturer.
What this part fixes:
  • Clicking sound
  • Doesn’t stop running
  • Freezer section too warm
Installation Instructions
Jim Meeks from Wimberly, TX
The controller (current relay) burned up
1. Unhooked a retaining wire that secures the controller to the compressor terminal box. 2. removed destroyed part. 3. Got the model and serial numbers and got online. 4. Ordered part 5. Waited a couple of weeks to get part 6. Found that the manufacturer had daisy chained a bunch of components together with some funny deep socket plugs that by themselves are not routinely found so rather than buy a laundry list of unnecessary parts to get the aforementioned plus and make my customer wait a couple of more weeks I chose to connect the wires to a couple of high temperature female stainless steel quick connectors and feed the wires directly into the controller. Fortunately the controller had the polarity marked on the housing. (L for Line was the hot lead and C was for common the neutral lead) Failure to follow proper polarity will damage the part and could kill the compressors's start wimding.
Support steady compressor motor operation with this refrigerator run capacitor. It works with the motor windings to create the electrical conditions needed for efficient running. A weak or failed capacitor may cause humming, difficulty starting, interrupted compressor operation, or warmer storage temperatures. Replacing a faulty capacitor helps restore proper motor operation and cooling. Unplug the refrigerator before accessing the component. Capacitors can retain a dangerous electrical charge after power is disconnected, so avoid touching exposed terminals and follow the supplied service instructions for safe handling. This is an OEM part sourced directly from the manufacturer.
Support steady compressor motor operation with this refrigerator run capacitor. It works with the motor windings to create the electrical conditions needed for efficient running. A weak or failed capacitor may cause humming, difficulty starting, interrupted compressor operation, or warmer storage temperatures. Replacing a faulty capacitor helps restore proper motor operation and cooling. Unplug the refrigerator before accessing the component. Capacitors can retain a dangerous electrical charge after power is disconnected, so avoid touching exposed terminals and follow the supplied service instructions for safe handling. This is an OEM part sourced directly from the manufacturer.
What this part fixes:
  • Clicking sound
  • Freezer section too warm
  • Fridge and Freezer are too warm
Installation Instructions
Ken from HOLLAND, MI
Compressor would not run. My daughter was told that compressor was bad and needed to be replaced. Cost would be $550 labor plus parts. I could hear a clicking sound I believe was made by the starter relay. I ordered the parts from part select and had them in three days.
I took the screws out of back panel and slid water line and panel off to the right side while I removed the capacitor and starter relay. Relay was probably the only problem, but I replaced capacitor too while I was doing the repair. Finished removal and replacement in about 20 minutes. While I had panel off I cleaned coils that I could see from behind and then did the same on front side. Cost was $136 for both parts. I could have done it for $71 if I did not replace the capacitor too. Saved my daughter from being taken advantage of.
Support steady compressor operation with this refrigerator run capacitor. It provides the electrical phase shift needed for the compressor motor to run properly as the cooling system operates. A failing capacitor may contribute to humming, difficulty starting, interrupted compressor operation, or rising compartment temperatures. Visible swelling, leaking, or burned terminals may also indicate damage. Unplug the refrigerator before accessing the component. Capacitors can retain an electrical charge after power is disconnected, so follow approved discharge procedures and avoid touching or shorting the terminals. Record the wire positions before replacement. This is an OEM part sourced directly from the manufacturer.
Support steady compressor operation with this refrigerator run capacitor. It provides the electrical phase shift needed for the compressor motor to run properly as the cooling system operates. A failing capacitor may contribute to humming, difficulty starting, interrupted compressor operation, or rising compartment temperatures. Visible swelling, leaking, or burned terminals may also indicate damage. Unplug the refrigerator before accessing the component. Capacitors can retain an electrical charge after power is disconnected, so follow approved discharge procedures and avoid touching or shorting the terminals. Record the wire positions before replacement. This is an OEM part sourced directly from the manufacturer.
What this part fixes:
  • Clicking sound
  • Freezer section too warm
  • Fridge and Freezer are too warm
Installation Instructions
Christian from Kearneysville, WV
No power to the fan and compressor
I have a fridge in my garage. I have found that a glass of ice water or a cold drink outside is very important to me. When I discovered melting ice dripping onto the garage floor I was very upset. I spun the fridge and found that the compressor and fan weren't starting. I got out my multi-meter and discovered that power was not making it to these components. I did some research and found the wiring diagram online. There really isn't too much going on with a fridge and the most likely candidate seemed to be the run capacitor. I ordered the part, replaced it in a few minutes and the fridge began working again.
Original Equipment Manufacturer

MAKE THIS REPAIR A GUARANTEED WIN

OVER 2 MILLION PARTS TO ENSURE VICTORY

This refrigerator run capacitor supports compressor motor operation by helping create the electrical phase shift needed for efficient running. It works with the motor windings to maintain the rotating magnetic field that drives the compressor. A weak or failed capacitor may cause humming, difficulty starting, interrupted compressor operation, or warmer storage temperatures. Replacing a faulty capacitor helps restore proper motor operation and cooling. Unplug the refrigerator before access, and remember that capacitors can retain an electrical charge after power is disconnected. Avoid touching exposed terminals. This is an OEM part sourced directly from the manufacturer.
This refrigerator run capacitor supports compressor motor operation by helping create the electrical phase shift needed for efficient running. It works with the motor windings to maintain the rotating magnetic field that drives the compressor. A weak or failed capacitor may cause humming, difficulty starting, interrupted compressor operation, or warmer storage temperatures. Replacing a faulty capacitor helps restore proper motor operation and cooling. Unplug the refrigerator before access, and remember that capacitors can retain an electrical charge after power is disconnected. Avoid touching exposed terminals. This is an OEM part sourced directly from the manufacturer.
What this part fixes:
  • Clicking sound
  • Freezer section too warm
  • Fridge and Freezer are too warm
Installation Instructions
Gilbert from Clinton, MO
The compressor would not run.
I removed the screws in the lower back panel where the compressor is located. Then I unplugged the capacitor and plugged the new one in. I then checked to see if the compressor would start. It wouldn't so I replaced the overload relay with capacitor and that fixed the problem. The capacitor just plugs into the relay then plugs into the compressor. There are several screws but all in all it is easy.
This refrigerator run capacitor is a 220-volt, 12-microfarad component designed to support the compressor motor by providing continuous current to its windings. By regulating electrical flow, it helps the appliance maintain proper cooling performance and prevents issues such as excessive run time or temperature fluctuations. If your refrigerator or freezer is struggling to start or maintain its temperature, replacing the run capacitor may restore efficient operation. Always unplug the appliance before installation.
This refrigerator run capacitor is a 220-volt, 12-microfarad component designed to support the compressor motor by providing continuous current to its windings. By regulating electrical flow, it helps the appliance maintain proper cooling performance and prevents issues such as excessive run time or temperature fluctuations. If your refrigerator or freezer is struggling to start or maintain its temperature, replacing the run capacitor may restore efficient operation. Always unplug the appliance before installation.
What this part fixes:
  • Freezer section too warm
  • Fridge and Freezer are too warm
  • Fridge too warm
Installation Instructions
eric from inglewood, TN
Faulty Controller and Possibly Capacitor
After building a test box and determining the Controller was bad simply ordered parts and installed. Installation was a little difficult due to locking spades on electrical connections.

Unplug all power from freezer. Remove Bail wire from controller capacitor unit and remove from compressor by pulling STRAIGHT from compressor body to avoid bending contacts.

Use a very small instrumentation screwdriver to release locking spade on yellow and white wires. To unlock slide screwdriver in slot along wire entry to controller body while gently pulling on wire. Note position of wires and replace on new unit in same position/order. Plug new run capacitor into new controller being careful to orient capacitor to proper position (hole matches guide on controller unit). Plug newly installed controller and capacitor into condensor and replace bail wire.

Make sure timer is not in defrost mode - manually advance timer if necessary to ensure timer is in run mode. Turn temperature control to coldest setting. Plug in and hopefully enjoy the humming noise of your newly repaired and operational compressor and freezer.
$91.25
In Stock
This capacitor provides the electrical boost needed for motors or components to start and run smoothly. Proper capacitance supports efficient operation and reduces strain on the system. Replacing a failed capacitor restores reliable performance.
This capacitor provides the electrical boost needed for motors or components to start and run smoothly. Proper capacitance supports efficient operation and reduces strain on the system. Replacing a failed capacitor restores reliable performance.
$28.37
In Stock
$63.24
In Stock

More Kenmore Refrigerator Parts

People often need to fix these common parts