Heat Gun Parts

This genuine item that is supplied by the original equipment manufacturer for use with Milwaukee equipment. It is an identical replacement for a missing or a faulty battery door that was installed on a new unit. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this component. Keep in mind this high-quality door is made of durable plastic and is sold individually. Note, the <a href="http://www.ereplacementparts.com/ejector-pin-p-720711.html" target=blank><u>#44-60-0235 Ejector Pin</u></a> is sold separately.

This is a genuine manufacturer-sourced part which is specially designed for Milwaukee equipment. The cord is hardwired to the tool to supply power from a standard U.S. outlet. Over time it may wear out or get damaged eventually requiring a replacement. Keep in mind this high-quality rubber insulated cord is sold individually. Refer to the appropriate diagrams for your model to ensure the proper repair procedure. Note, a screwdriver will be needed to take apart and reassembled the housing when replacing this cord.

This component is supplied by the original equipment manufacturer for use with Milwaukee heat guns. It is the special guard for the nose. Over time it may get damaged or lost eventually requiring a replacement. This part is made of high-quality plastic and is sold individually. Refer to the owner's manual and the parts diagrams to ensure the correct repair procedure.

This is a genuine Milwaukee replacement part. The strain relief is designed by the manufacturer for use in heat guns and sanders. This part is made of flexible rubber, and is used to protect the power cord from wearing against the machine housing. You may require a screwdriver when replacing this item. This product is sold individually.

This nozzle is supplied directly from the original equipment manufacturer. The nozzle is designed for use with the Makita DCG180Z 18V Cordless Caulking Gun, and is sold individually. Constructed of durable plastic, this component is fitted onto the end of holder (a). The nozzle allows the operator to efficiently dispense adhesive or caulk, securing project surfaces. No tools should be needed for the replacement. It is recommended to refer to the specific manual for further installation directions.

This part is an OEM from Milwaukee and is specially designed to be used with a Double insulated heat gun. This part is made of a high-quality plastic and is used to cover the rear of the housing assembly. When replacing this part no tools are needed. Remove the old part and snap the new one in place. This part is sold as an individual replacement part.

This is a genuine OEM sourced part used on several heat gun devices. The reflector is secured onto the nose of the heat gun for sealing and soldering projects. The metal reflector is sold individually, and no tools should be required for the installation. Please refer to the manual for safety and repair instructions.

This is an authentic manufacturer made replacement part which is specially designed for use with Milwaukee heat guns. The cord transfers power to the heat gun through the wires and circuits inside the cord. This part is made of flexible plastic and wire, it is also sold individually. For installation, you will need a screwdriver and a pair of needle nose pliers to aid you.