Official Haier Parts | Order Today, Ships Today

Your Price

$8.15

Light Switch

★★★★★

(56)

PartSelect Number PS8758429

Manufacturer Part Number WR23X10725

The interior light of your refrigerator is controlled by a switch that is activated when the door is opened and closed. If your refrigerator light will not turn on, there could be an issue with the switch. The switch is spring loaded and is a generally closed type of switch meaning there should be no continuity when the button is depressed, and continuity through the switch when the button is not depressed. This plastic, white, OEM switch is sourced directly from the manufacturer, is sold individually and is easy to replace. The repair usually takes less than 15 minutes and requires a flat blade screwdriver and needle nose pliers.

Fixes these symptoms

Fridge too warm
Light not working
See more...

Installation Instructions

Jonathan from Lilburn, GA

Sticking Light Switch

I applied some tips learned by reading other reviews. So before I started I grabbed my trusty vise grip pliers and a small screw driver. I locked onto the switch actuator, the part that the refrigerator door pushes in, with the vise grips and pulled on it just hard enough to get the screw driver inserted in the right side to push in the catch clip so the switch could be pulled out further each time the catch clip was depressed to the next detent. Then I used the screw driver on the left site to encourage the switch past the detents on the left and very quickly the switch was out of the mount. The wires from the refrigerator pulled out with the old switch. I unplugged the old switch from the wires and plugged in the new switch and shoved the new switch back into the mount, wiggled it a couple of times to make sure it was secure and the job was done. Once I applied the vise gripes at first, the whole job took less than a minute. Read more...

Your Price

$54.36

Run Capacitor

★★★★★

(7)

PartSelect Number PS11764031

Manufacturer Part Number WR55X24064

This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer. This part has been updated by the manufacturer and may appear different than the original, but should function the same.

Fixes these symptoms

Clicking sound
Freezer section too warm
Fridge and Freezer are too warm
See more...

Installation Instructions

Christian from Kearneysville, WV

No power to the fan and compressor

I have a fridge in my garage. I have found that a glass of ice water or a cold drink outside is very important to me. When I discovered melting ice dripping onto the garage floor I was very upset. I spun the fridge and found that the compressor and fan weren't starting. I got out my multi-meter and discovered that power was not making it to these components. I did some research and found the wiring diagram online. There really isn't too much going on with a fridge and the most likely candidate seemed to be the run capacitor. I ordered the part, replaced it in a few minutes and the fridge began working again. Read more...

LOWER RACK ROLLER – Part Number: WD12X26146

Your Price

$12.68

LOWER RACK ROLLER

★★★★★

(18)

PartSelect Number PS16217024

Manufacturer Part Number WD12X26146

This is a lower rack roller for your dishwasher. It attaches in the lower roller assembly on the bottom of your rack to allow the rack to smoothly slide in and out. This replacement part is 1.5 inches in diameter and is charcoal in color. There are four rollers in total, please consider replacing your other rollers at the same time as they may be wearing at the same rate. Sold individually.

Installation Instructions

Dennis from CICERO, IN

Roller carrier got melted by heat coil

Replaced bad roller carrier with a new one. Read more...

LOWER SPRAY ARM ASSEMBLY – Part Number: WD22X27724

Your Price

$17.39

LOWER SPRAY ARM ASSEMBLY

★★★★★

(17)

PartSelect Number PS16542476

Manufacturer Part Number WD22X27724

Fixes these symptoms

Leaking
Noisy
Not cleaning dishes properly
See more...

Installation Instructions

James from DELAND, FL

Knocking sound during wash cycle

Replace all three spray arms and knocking sound disappeared.
Unscrewed counter clockwise old sprayer arms and lifted. Replaced with new sprayer arms and noise disappeared. Read more...

Your Price

$42.72

Door Latch

★★★★★

(47)

PartSelect Number PS6447681

Manufacturer Part Number WD21X10490

This is replacement door latch for your dishwasher. The door latch is attached to the tub frame, and connects to the door strike to keep your dishwasher door closed during operation. If you have a broken or faulty door latch, your dishwasher door may not stay closed, and this can prevent the dishwasher from running. This item is sold individually, and if your door strike is also damaged, you will need to replace that part separately. This is an OEM part sourced directly from the manufacturer.

Fixes these symptoms

Door latch failure
Door won’t close
Will Not Start
See more...

Installation Instructions

James from ALBRIGHTSVLLE, PA

Door latch not functioning

1. Turn off breaker supplying power to dishwasher in electrical panel
2. Open dishwasher door
3. Unscrew the screws that secure the dishwasher to the counter.
4. Tip dishwasher forward. Identify the non-functioning door latch. It looks exactly like the replacement. Unclip the wire harness from the door latch.
5. On the inside of the dishwasher, there are 2 screws directly under the door latch. Unscrew them and carefully set aside.
6. Remove old door latch.
7. Set new door latch in place. Holding securely, replace screws removed in step 5. Toward the end they get a little tougher to screw in.
8. Plug wire harness into new door latch.
9. Re-align dishwasher and re-secure to counter in previous position.
10. Test latch to make sure it closes properly.
11. Turn on breaker in electrical panel.
The dishwasher should now function properly. Read more...

Your Price

$6.64

PLUG BTN WHT

PartSelect Number PS298887

Manufacturer Part Number WR2X8233

BASKET ASM SILVERWARE – Part Number: WD28X24469

Your Price

$33.47

BASKET ASM SILVERWARE

★★★★★

(61)

PartSelect Number PS12703061

Manufacturer Part Number WD28X24469

This basket is part of a silverware basket that has 3 sections. This is the middle section of the basket.

Fixes these symptoms

Leaking
Not cleaning dishes properly
See more...

Installation Instructions

Carrie from Naples, FL

wheels were broken;basket was broken

This worked great. Cheap and easy. Read more...

DETERGENT MODULE – Part Number: WD12X28238

Your Price

$36.84

DETERGENT MODULE

★★★★★

(31)

PartSelect Number PS16542427

Manufacturer Part Number WD12X28238

The detergent dispenser in your dishwasher stores the detergent until it is ready to be dispensed. If your dishes are not coming clean, or you notice the detergent is still in the dispenser at the end of the cycle, you may have a damaged or malfunctioning detergent dispenser. This detergent dispenser is not sold with a sensor. It is gray in color and is sold individually. This is an OEM part sourced directly from the manufacturer.

Fixes these symptoms

Door latch failure
Not cleaning dishes properly
Will not dispense detergent
See more...

Installation Instructions

Dennis from LAS VEGAS, NV

The detergent tray wouldn't open during wash cycle

1. Pull out dishwasher (not all the way) 2. Open the door. 3. Remove the white rope holding the door hinge (both sides) 4. Remove the door by pulling up when the door is open about 4-8 inches. 5. Lay the door on the floor ( put something under the door so not to scratch the front. 6. Remove the small bolt at the bottom of the door (both sides). 7. Slide the hinge back, up, then out. 8. Where the hinges were are another set of bolts, remove those (both sides) 9. Grab the top part of the door (the part with the buttons) and slide apart. 10. Remove the styrofoam carefully. 11. Disconnect the wiring harness. 12. Remove the 6 screws holding the Despenser tray in place. 13. Put in new Despenser tray and put everything back together. Read more...

Your Price

$12.68

END CAP

★★★★★

(21)

PartSelect Number PS7783360

Manufacturer Part Number WD12X10426

This is an end cap for a dishwasher rack. This part is about 2.5 inches long, is black, and is made of plastic. You may need to replaced this part if it is broken, or if your dishwasher rack continuously falls off the track or rail.

Installation Instructions

Wilson from MENIFEE, CA

upper and lower rack ASM showed sing of rust

Repair was simple, lower rack just remove and replaced with out any tools or disassemble required, for the upper rack installation, the end cap need to be removed out of the sliding tracks, slide old rack out and discard, clean the track with a suitable cloth and slide new rack in to the tracks, reinstall the old end caps, as a good preventing measure, order new end caps just in case they are need it if the old ones crack during removal.
save old rollers from old racks for future repairs Read more...

MID SPRAY ARM ASEMBLY – Part Number: WD22X27740

Your Price

$16.31

MID SPRAY ARM ASEMBLY

★★★★★

(6)

PartSelect Number PS16542477

Manufacturer Part Number WD22X27740

Fixes these symptoms

Noisy
Not cleaning dishes properly
See more...

Installation Instructions

James from DELAND, FL

Knocking sound during wash cycle

Replace all three spray arms and knocking sound disappeared.
Unscrewed counter clockwise old sprayer arms and lifted. Replaced with new sprayer arms and noise disappeared. Read more...

Haier Parts

Popular Haier Parts

Appliance Type

Popular Haier Models

Organize Your Home in a Snap!

Hello!

Haier Parts

Find your part

Popular Haier Parts

Appliance Type

Popular Haier Models

Organize Your Home in a Snap!