Ask our experts a question about this model and we'll get back to you as soon as possible!
We may have answered a similar question already! Search questions and answers left by others using simple keywords like "fit", "broken", "easy", or "quality" to find questions that match.
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Sort by:
Prev
1
Next
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Ms - For model number RDE350AW
October 24, 2023
I need the support that holds the lint filter in place.
Hello Ms, thank you for reaching out. The lint filter support for your model is part number PS12582812. Glad to be of help!
Spins but no heat, would it be the heating element?
Hello Clifford, thank you for reaching out. Before replacing the heating element, we would suggest checking the cycling thermostat, part number PS12342930. It monitors and regulates the temperature inside the dryer. You may need to replace it to fix the issue. Glad to be of assistance!
Trying to see how to install the lint filter grille
Hello Nekia, thank you for contacting us. To install the lint filter grille, part number PS12582812, you will need to remove the screw on its each side. Remove the old one and screw the new one in place. We hope this helps.
Electric dryer will not shut off even when switch is turned to off or door is opened.
Hello Terry, thank you for the question. Based on our understanding of the issue, we would recommend checking the door switch by doing the continuity test. If the issue still occurs, you may need to replace the control board, part number PS12343004, to fix the issue. We hope this helps!
Hello Michael, thank you for reaching out. You may need to check the thermal fuse, part number PS12342923, to fix the issue. We hope this solves your problem!
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
unit would not run at all but would turn on
5 of 5 peoplefound this instruction helpful.
Stanley from Cooper City, FL
Easy
30 - 60 mins
Nutdriver, Screw drivers
They sent the wrong part even though I gave the unit model number and part number of the part.I described the part and gave the name used by the manufacture on the schematic from the back of the unit. The second person I spoke with to reorder the correct part took more time in understanding that a temp limiter is not the same as a temp se
... Read morensor. The part is located on the inside back wall of the dryer behind the drum. It all had to come apart to get to it but was very easy even without the service manual.Unplug the unit. Remove the 4 screws on the back that lock down the top and pop off the top prying against the spring clips, move it out of the way but remember that its still connected by wires on the inside of the back. disconnect the 2 wires going to the door switch. Remove the two screws holding the front panel on located on the top. Pull up on the panel lifting it off of the spade brackets. Reach in down below and remove the belt from the pulley and drum. Pull up on the drum about 1" and the drum will be free. remove the drum. In the upper right hand corner is where you will see the temp limiter. Remove the 2 screws and unplug the wires. Assembly is the reverse order except to install the belt remove the access panel on the lower left corner of the back of the unit to gain access to the belt for installation....
My Orders
