Heater Parts

This is a Genuine OEM replacement parts used on certain Kerosene/Diesel Forced Air Heaters. This kit includes an air inlet filter, an outlet filter and a lint filter. Its purpose is to filter out dust and debris from contaminating and damaging the motor assembly.

This is an authentic Mr. Heater replacement part manufactured for use with heaters. The specialty gasket is used to form a seal between the burner and burner tile. It is recommended to replace the gasket when servicing the heater to ensure a proper seal when the parts are reassembled. This tile gasket is available as an individual replacement part.

This genuine OEM spark plug kit is a replacement kit for use in outdoor power equipment. It consists of the spark plug, mounting bolt, washer, and gasket. Over time, spark plugs can become fouled with carbon deposits, leading to misfires, reduced fuel efficiency, and poor engine performance. This all-in-one kit allows you to replace the old, worn-out spark plug with a new one, ensuring the engine continues to run smoothly and efficiently. If you are experiencing difficulties starting the equipment, and running it consistently, this is a sign that the spark plug should be tested and replaced. To replace the faulty spark plug, ensure the equipment is switched off/disconnected from power. Remove the mounting bolt and detach the spark plug. Clean the mounting surface and align the new spark plug with the mounting hole. Insert the new bolt and tighten it until the spark plug is stable and secure.

Restore power control to a compatible heater with this replacement on and off switch, the switch is sold individually and snaps into the control panel with side tabs, take a photo of the three wires before removal so they can be connected correctly, disconnect power and let the heater cool before installation, use the exact model number to confirm fit.

The burner tile is sold individually and has dimensions of 5.5"L x 4"W x 1"T.

This item is a genuine OEM sourced replacement part that is intended to be used with forced air heaters from Pro Temp, Heat-Stream, Heat Hog, and Master. The plastic fuel filter connects to the fuel line and is used to prevent contaminants from entering the motor assembly. This item is available as an individual replacement part.

This item is available as an individual replacement part. The main PCB assembly connects to the thermostat control knob and the fuse. This genuine item is supplied by the original equipment manufacturer for use with heaters made by Pro Temp, Heat Stream, Heat Hog, and Master. When replacing this part a screwdriver might be required during the installation process. It will need to be replaced if it breaks.

This authentic replacement rocker switch is supplied directly from original manufacturer. It is specially made for use with DeLonghi heaters. It controls the on/off functions of a unit. Switches are commonly replaced parts, over time, mechanical internals will wear out requiring replacement. This plastic switch is sold individually. To complete this repair you will need a screwdriver. • First make sure the tools is not plugged in • Then you want to remove the cover screws • Remove the old switch • Secure the new switch in place • Reassemble and test the unit

This is an authentic component which is supplied by the original equipment manufacturer for use with Broan and Nutone ceiling heaters. The thermostat is a special type of sensor that detects temperature. Unfortunately, over time it may begin to fail eventually requiring a replacement to ensure your equipment functions properly. Refer to the diagrams for your model when performing this repair. Keep in mind the thermostat for lamps is sold as an individual item. You may need a screwdriver to replace this component.