Sanding Table Parts

It is a genuine manufacturer sourced replacement washer that is specially produced for use with power equipment. The purpose of a washer is to distribute the pressure evenly between two connected parts. This is a standard hardware which has multiple applications based on your equipment, please refer to appropriate diagrams for correct location and use of this hardware. This part is made from durable metal and it is sold individually.

It is an authentic item that is supplied directly from original equipment manufacturer for use with Delta power equipment. This replacement bearing helps to secure the spindle while allowing it to rotate with minimal friction. For correct location and use of this item make sure to check appropriate diagrams of your equipment. Please note this durable metal bearing is sold individually.

It is a genuine OEM component which is designed for Delta sanders. This is the gear that attaches to the camshaft. It helps to drive the spindle assembly. Unfortunately, over time it may wear out or get damaged eventually requiring a replacement to ensure your equipment operates properly. One durable plastic gear is included. To ensure the proper repair procedure, refer to the appropriate diagrams of your model. To perform this repair a screwdriver and a wrench set will be necessary to take the housing apart.

An authentic item that is supplied directly from the original equipment manufacturer for use with Delta and Bosch equipment. It is an identical replacement for a missing or damaged caster assembly that was originally installed on the new unit, over time components may wear out and begin to fail eventually requiring a replacement. This high-quality part is made of durable metal with plastic and is sold individually, please note the hardware to secure it is sold separately.

This is an authentic replacement part sourced from the original manufacturer for use with drum sanders made by Delta. Unfortunately, over time it may wear out or get damaged eventually requiring a replacement. It is recommended to review your models diagram to verify the parts compatibility. This spring is sold individually and made of durable material.

This genuine item is supplied by the original equipment manufacturer for use with Delta drum sanders. It is an identical replacement for a worn, a damaged or a missing belt that was installed on a new equipment. A new belt will usually be tighter on one side than the other. Frequent adjustments are normal for the first few hours due to belt stretch. Adjustments to belt tracking can also affect belt tension. One durable belt is included. Refer to the owner's manual for your model to ensure the correct repair procedure.

This handle is an OEM direct from Delta. The handle is made for use with a variety of power tools. The metal handle allows the operator to make the needed adjustments for projects. This handle is sold individually. A screwdriver, pliers, socket and wrench set are often required for the proper installation. Please refer to the specific manual for further repair instructions.

This is an OEM part sourced directly from the manufacturer. The gear cover is designed for use in Delta sanders. This part is made of high-quality plastic, and is attached to the motor to hold and cover the worm gear. You will require a screwdriver when replacing this part. This item is sold individually.