Kenmore Dryer Circuit Boards and Touch Pads

Kenmore Appliance Parts

Popular Kenmore Dryer Circuit Boards and Touch Pads

Your Price
$129.79
  In Stock
Kenmore Dryer Timer
★★★★★
★★★★★
36 Reviews
PartSelect Number PS11749831
Manufacturer Part Number WPW10185982
This dryer timer is used to control the unit's cycles by regulating the length of time that power is directed to each setting.
Fixes these symptoms
Installation Instructions
Eugene from CRUGER, MS
Dryer would not heat
Repair was very easy only took about ten minutes Read more...
Your Price
$129.65
  In Stock
Kenmore Dryer Timer
★★★★★
★★★★★
12 Reviews
PartSelect Number PS11749833
Manufacturer Part Number WPW10185992
This dryer timer is a genuine manufacturer replacement part that is specially designed to fit with dryers. You can locate the timer behind the control panel of your dryer. The timer controls the duration of the drying cycle. It allows users to set a specific amount of time for the dryer to run before automatically shutting off. This feature enables you to customize the drying process to your needs based on the type and amount of laundry you are drying. If the timer is faulty, the dryer may fail to start, stop running midcycle, or run indefinitely. You may also hear a clicking sound when you turn the timer knob or you may be unable to move the knob altogether.
Fixes these symptoms
Installation Instructions
Rodney from NEWNAN, GA
The Dryer had simply quit turning off: either by moiture sensor or by timer. The timer knob would no longer advance.
I looked up the likely causes on this website and came up with two most likely causes: bad fuse ($10) or a bad timer assembly ($85). Since I suspected the timer assembly might be more likely cause but the fuse was relatively cheap, I went ahead and purchased both of those so I'd likely be able to fix it. Got the parts in 2 days, First I installed the fuse assembly using the video from this site as a coach. Took me maybe 5 minutes to replace, quite easy actually. Put it back together and tested to see if it had fixed the problem. It had not. So I replaced the timer assembly. I used the youtube videos of that for some coaching preparation. Again it was easy as pie. Took me 5 minutes to remove the old one and replace with the new one. Put it all back together and tested it. SUCCESS! that fixed it! So.. for about $100 in parts, I fixed it. The service call alone would have cost $150 not including parts, so I saved at least $150 doing it myself! Your diagnostic help advise was absolutely vital to enabling me to diagnose and find the right replacement parts! THANK YOU! Read more...
Your Price
$160.67
  In Stock
Kenmore Dryer Timer
★★★★★
★★★★★
15 Reviews
PartSelect Number PS11749835
Manufacturer Part Number WPW10186032
Installation Instructions
Robert from SPRINGFIELD, OH
No heat.
Replaced the timer
.
Read more...
Your Price
$193.94
  In Stock
Kenmore Dryer Timer Control
★★★★★
★★★★★
8 Reviews
PartSelect Number PS11749830
Manufacturer Part Number WPW10185981
60hz
Installation Instructions
Joseph from LINCOLN, RI
timer control would get stuck
Bought the part and removed 10 screws unplugged the wiring and applied it to the new part. Reassembled, done.
Super easy, works great!
Read more...
Your Price
$186.69
  In Stock
Kenmore Dryer Timer
★★★★★
★★★★★
2 Reviews
PartSelect Number PS11754717
Manufacturer Part Number WPW10436303
Your Price
$234.98
  In Stock
Kenmore Dryer Timer - 60Hz
★★★★★
★★★★★
22 Reviews
PartSelect Number PS11746606
Manufacturer Part Number WP8566184
This dryer timer is used to control the unit's cycles by regulating the length of time that power is directed to each setting.
Installation Instructions
James from Nazareth, PA
Dryer stuck in middle of heat cycle.
Lets say the dryer ran all night thru the middle of the next day. It would stick on time dry and sensor dry cycle. Easy fix. Make sure you buy the right replacement timer. Remove the back cover of the control panel of the dryer. Make sure you unplug the dryer first. Two screws hold the timer in place. There are several wires connected to the timer. Take one off and place it on the new timer. Do this with all wires, it helps to use a needle nose pliers to pull the wires from the old timer. Install new timer with the two screws, replace the back panel, and plug the dryer back in. You're done. Pretty easy. Read more...
Your Price
$123.08
  In Stock
Kenmore Dryer Timer - 60Hz
★★★★★
★★★★★
2 Reviews
PartSelect Number PS11749825
Manufacturer Part Number WPW10185970
This dryer timer is used to control the unit's cycles by regulating the length of time that power is directed to each setting.
Installation Instructions
Steve from HICO, TX
Dryer would intermittently work on economy drying, never on timed dry. (Heat failed tumbler was always good)
Disconnect power cord. Removed upper and lower panels. Disconnected "push on" spade connectors and removed the single screw holding each device and removed same. Timer had a two multi wire plug and 2 screws. Reversed process and installed same. Was fairly sure only timer was bad. But due to age of dryer and posts found here, decided to just install fuse and cut out. Everything works perfect! Read more...
Your Price
$234.74
  In Stock
Kenmore Dryer Timer
★★★★★
★★★★★
4 Reviews
PartSelect Number PS11742167
Manufacturer Part Number WP3976576
This dryer timer is used to control the unit's cycles by regulating the length of time that power is directed to each setting.
Installation Instructions
erik from wasilla, AK
Timer not working
Repair was straightforward. When I got the old timer out, I found the problem. Two small screws secure the geardrive for the timer to the electrical part. One of the screws had vibrated loose and allowed the gearbox to float away from the electrical board, so the gears werent meshing and the little ground tab inside wasn't touching the metal geardrive housing. In short, I would recommend removing your old timer and diagnosing the problem. before spending $100 on a new one. If I had done that, I could have just tightened the screw back in and saved myself the $$. Just FYI Read more...
Your Price
$201.28
  In Stock
Kenmore Dryer Timer - 60 Hz.
★★★★★
★★★★★
2 Reviews
PartSelect Number PS11745797
Manufacturer Part Number WP8299779
This dryer timer is used to control the unit's cycles by regulating the length of time that power is directed to each setting.
Your Price
$141.50
  In Stock
Kenmore Dryer Timer - 230V 60Hz
★★★★★
★★★★★
4 Reviews
PartSelect Number PS11749829
Manufacturer Part Number WPW10185976
This dryer timer is used to control the unit's cycles by regulating the length of time that power is directed to each setting.
Installation Instructions
James from CANTON, GA
Dryer not heating.
Checked all possible items with a multimeter. Of course the last item I checked was the one that did not show a closed circuit.. the timer. Ordered the part with one day shipping and it arrived the next day. Install took just a few minutes and it was fixed. Online videos are a great tool for diagnosing and repair. Do yourself a favor and do it yourself and save a lot of money. Read more...

Related Kenmore Dryer Parts