Kenmore Dishwasher Caps and Lids

Kenmore Appliance Parts
Shop By Part Type

Popular Kenmore Dishwasher Caps and Lids

Your Price
$6.68
  In Stock
Stop Clip
★★★★★
★★★★★
(3)
PartSelect Number PS11770481
Manufacturer Part Number 5304506510
This rail end cap, or dishrack stop clip, is a genuine OEM replacement part for your dishwasher. This part keeps the rack in your dishwasher from sliding out. This is a very easy repair, to complete it you only need a flat blade screwdriver. Use the screwdriver to pry the locking tab open on the cap, located at the front of your upper dishrack. Pull off the end cap and lock the new one into place.
Installation Instructions
Bobby from Austin, TX
Broken wheels, Caps and Brackets. Couldn't hold dishes or wash right.
Just use a hexagonal driver to remove the Upper rack roller, screw the new ones in, place caps on the rail ends, and pop the new wheel on with some pliers! Simple and fun! Read more...
Your Price
$25.03
  In Stock
Rinse-Aid Dispenser Cap
★★★★★
★★★★★
(39)
PartSelect Number PS11746426
Manufacturer Part Number WP8558307
The rinse aid cap (sometimes referred to as the dispenser cap), covers the rinse aid dispenser on the dishwasher door. If your dishwasher will not dispense detergent, or it is leaking detergent, there could be an issue with the rinse aid cap. Check the cap and its gasket for any damage or melting. If the cap has melted or it is not sealing the dispenser properly, the part should be replaced right away. This rinse aid cap comes with the gasket, so you should discard the existing gasket and rinse aid cap at the same time. The repair is relatively straightforward, and requires no tools.
Fixes these symptoms
  • Door latch failure
  • Leaking
  • Not cleaning dishes properly
  • See more...
Installation Instructions
James from Mesquite, TX
Cap came off and melted
Opened door and installed cap. Not much effort. But really got good service from Parts Select. Received order much faster than I had expected. Read more...
Your Price
$21.62
  In Stock
Rinse Aid Cap
★★★★★
★★★★★
(11)
PartSelect Number PS421128
Manufacturer Part Number 154388801
This is a replacement cap for the detergent/rinse aid dispenser. If the rinse aid cap is damaged or missing, you may notice too much rinse aid in the dishwasher. The cap simply screws into the dispenser, so if your cap is damaged you can simply screw it out, then screw in the new one. The rinse aid cap is approximately 2 inches in diameter and is sold individually. This is an OEM part, directly from the manufacturer.
Fixes these symptoms
  • Leaking
  • Not cleaning dishes properly
  • Not drying dishes properly
  • See more...
Installation Instructions
Jeffrey from Mildland, MI
Striker
Removed the 4 screws that held the dishwasher in place, tilted it out, removed 2 nut screws on striker, installed new striker and put it back together. Very simple.

Thank you for stocking the parts and shipping them as promised.
Read more...
Your Price
$8.56
  In Stock
Rinse Aid Cap
★★★★★
★★★★★
(13)
PartSelect Number PS11741341
Manufacturer Part Number WP3378134
This cap does not require the use of an O-ring seal. The wet agent assembly cap is clear in color and made of plastic. This is a part for your dishwasher. This part may need to be replaced if you notice that your dishwasher is not dispensing detergent, cleaning dishes properly, or has sprung a leak. The cap is found on the inside of your dishwasher door. This is an extremely simple repair that requires no tools. Simply open your dishwasher door, twist the old cap out of place, ensuring no pieces are left behind. Screw your new cap into place.
Fixes these symptoms
  • Leaking
  • Not cleaning dishes properly
  • Not drying dishes properly
  • See more...
Installation Instructions
Louis from Niceville, FL
Water dripped out from the bottom of door.
Diagnosing the problem, i.e. finding the source of the leak, was the hardest part. The best clue was the leak only occurred well into the cycle when the water was hot and steam was coming out the vent. I then assumed there was a bad seal and steam & condensed water was leaking down into the door. I replaced the vent duct & seal, a broken drip cover (an internal part in the door), and replaced a missing rinse aid cap. This stopped the leak. Read more...
Your Price
$24.43
  In Stock
Rinse Aid Cap
★★★★★
★★★★★
(13)
PartSelect Number PS11746567
Manufacturer Part Number WP8564929
This rinse aid cap or fill cap is for your dishwasher and it screws into the jet dry dispenser. Sometimes the cap can become loose and fall out, which can cause it to melt from the heater. If your cap is damaged or missing, this is the part you will need to replace it. It is made of white plastic and is a little more than an inch in diameter. This rinse aid cap is sold individually.
Fixes these symptoms
  • Leaking
  • Not cleaning dishes properly
  • Not drying dishes properly
  • See more...
Installation Instructions
Joan from Glendora, NJ
the rinse aid cap fell into the bottom of the dishwasher and got burnt by the coils. It was letting the rinse aid empty out every time I used the dishwasher because the seal was broken.
I just put the new cap on and that was it. Read more...
Your Price
$10.43
  In Stock
Tub Cap
★★★★★
★★★★★
(1)
PartSelect Number PS11703426
Manufacturer Part Number W10795980
Installation Instructions
Royce from GREENSBORO, NC
Dish rack slide arms losing ball bearings
Unscrewed mounting screws, pulled dishwasher out halfway, replaced arms, 4 screws each side .....very simple 30 min tops. Parts perfect and quick delivery! Read more...
Your Price
$9.16
  In Stock
LID
★★★★★
★★★★★
(3)
PartSelect Number PS8697157
Manufacturer Part Number 00166623
Fixes these symptoms
Installation Instructions
Sue E from CARMEL, IN
Rinse aid dispenser lid would not stay closed
Use a screwdriver flat blade to pry up one edge of closed lid. Put one side of lid into hinge and snapped other side into place. Very easy. Read more...
Your Price
$19.75
  In Stock
Dishwasher Rinse-Aid Dispenser Cap
★★★★★
★★★★★
(4)
PartSelect Number PS11731731
Manufacturer Part Number W10864394
Fixes these symptoms
Your Price
$23.82
  In Stock
Dispenser Cap
★★★★★
★★★★★
(3)
PartSelect Number PS11746156
Manufacturer Part Number WP8533380
This is the cap for your rinse aid dispenser.
Fixes these symptoms
Installation Instructions
Brian from Marion, IA
Couldn't find the part anywhere, but...
PartSelect found the right part for me on the first try. I had scoured the web looking for this particular drying agent cap. Even Sears said I'd have to order the entire dispenser assembly - $$$!

PartSelect found just the cap I needed at a much better price.

Fantastic service. Shipping was faster than promised. I can't say enough good things about them!
Read more...
Rinse Aid Fill Cap
PartSelect Number PS2351824
Manufacturer Part Number WD12X10284
This part helps keep the rinse aid the dispenser until its needed.

Related Parts