Kenmore Dishwasher Wire Plugs and Connectors
Popular Kenmore Dishwasher Wire Plugs and Connectors
Kenmore Dishwasher TERMINAL BOX
PartSelect Number PS8729475
Manufacturer Part Number 00640476
Fixes these symptoms
- Will Not Start
- See more...
Kenmore Dishwasher Wire Harness
PartSelect Number PS11770295
Manufacturer Part Number W11028004
This wire harness is for dishwashers and supplies power to electrical components in the dishwasher.
Kenmore Dishwasher Wire Harness
PartSelect Number PS11750079
Manufacturer Part Number WPW10195666
This wire harness is for dishwashers and supplies power to electrical components in the dishwasher.
Kenmore Dishwasher Ribbon Cable
PartSelect Number PS11746082
Manufacturer Part Number WP8524447
This part is used to connect the electronic control board and the touchpad control board.
Fixes these symptoms
- Will Not Start
- See more...
Installation Instructions
Norman from Weatherford, TX
Dishwasher would not start when Normal was selected. Would run fine if other option selected.
I began by opening the door to the dishwasher. The front panel on this unit is a custom wood panel held on by six screws. I removed the screws and the front panel. Then I unscrewed the two remaining screws holding the control panel onto the door. I also removed the two screws holding the door latch in position. With all screws removed the control panel simply slid off the top of the door. Inside the control panel, I used a small screw drive to pry the retainer clips back from the edge of the electronic control board. The control panel then snaps out. I disconnected the ribbon cable from both boards and reinstalled the new ribbon cable. I then reattached the ribbon cable to the new electronic control board and snapped the new control board into place. I reinstalled the control panel and tested the "Normal" position to insure the dishwasher would respond appropriately. After checking for proper operation, I reinstalled all screws,including the door latch and the front cover. Operation complete.
Read more...
Kenmore Dishwasher Wiring Harness
PartSelect Number PS11754425
Manufacturer Part Number WPW10413093
Installation Instructions
ROY from EASTON, PA
Mouse/Mice chewed through several wires below my dishwasher
Set the unit on its back, disconnected the door springs and slid it up off its hinges. Took off the inner door panel (about 8 hex screws) and then replaced each connection one at a time - removing the old and then connecting the new. Once door was done, reconnected the panel, slid it on its hinges, and then replaced the underside connections one at a time. Once all were done, reconnected door springs, set unit upright, reconnected water and drain, and started washing dishes.
Read more...
Related Kenmore Dishwasher Parts
- All Kenmore Dishwasher parts
- Kenmore Dishwasher Brackets and Flanges
- Kenmore Dishwasher Caps and Lids
- Kenmore Dishwasher Circuit Boards and Touch Pads
- Kenmore Dishwasher Dishracks
- Kenmore Dishwasher Dispensers
- Kenmore Dishwasher Doors
- Kenmore Dishwasher Ducts and Vents
- Kenmore Dishwasher Elements and Burners
- Kenmore Dishwasher Filters
- Kenmore Dishwasher Grilles and Kickplates
- Kenmore Dishwasher Handles
- Kenmore Dishwasher Hardware
- Kenmore Dishwasher Hinges
- Kenmore Dishwasher Hoses and Tubes
- Kenmore Dishwasher Insulations
- Kenmore Dishwasher Insulations
- Kenmore Dishwasher Knobs
- Kenmore Dishwasher Latches
- Kenmore Dishwasher Legs and Feet
- Kenmore Dishwasher Motors
- Kenmore Dishwasher Panels
- Kenmore Dishwasher Pumps
- Kenmore Dishwasher Racks
- Kenmore Dishwasher Seals and Gaskets
- Kenmore Dishwasher Sensors
- Kenmore Dishwasher Spray Arms
- Kenmore Dishwasher Springs and Shock Absorbers
- Kenmore Dishwasher Switches
- Kenmore Dishwasher Thermostats
- Kenmore Dishwasher Timers
- Kenmore Dishwasher Valves
- Kenmore Dishwasher Wheels and Rollers