Rinse-Aid Dispenser Cap

Hello Bonnie, Thank you for contacting us. Yes, the o ring comes with the rinse aid cap, part number PS11746426. Good luck with your repair!

Hi Kathy, Thank you for your question. I do not think your rinse aid cap would hinder your indicator. It sounds like you may have to replace your whole detergent dispenser assembly. I hope that helps. Good luck with your repair.

Hello Sol, thank you for contacting us. The heating element would be the main part that creates the heat. If you have a multimeter you can measure the resistance of your heating element which should read somewhere between 15 and 30 ohms. A reading above 30 means the element is faulty and will need to be replaced. If the resistance reading is OK then check the wiring and control board for damage. Hope this helps!

Hello Martin, thank you for your question. The rinse aid cap for your dispenser is part number WPW10524920. Please enter the part number into the site for current price and availability. Good luck with your repair!

Hi Marissa, Thank you for your question. The lights will blink on your dishwasher if your dishwasher detects an error. In this case there is a cleaning error. If the dishwasher is not cleaning the dishes correctly, you will need to check the chopper assembly, the spinner kit, the spray arm seal, the sump pump check valve, the spray arm seal, the impeller and seal kit, the heating element, the water inlet valve and the circulation pump. Also, the water may not be hot enough to dissolve the soap. Before running a cycle, turn the hot water on and let it run for a few minutes and then run a cycle and make sure there is good water pressure. If the dishes are not getting clean, the dishes may be loaded in a way that prevents all of the dishes from being cleaned. Try arranging them so that the water can reach all of them. Try varying the amount of soap used as well to see if that helps. I hope this helps. Thank you and have a great day!

Hello Ray, thank you for inquiring. The Rinse Aid Cap for your model is part PS11746426. It comes with the Gasket.

Hello Earl, Thank you for the question. This woudl be an issue with the Wax Motor on the back of the dispenser, PartSelect Number PS11750654 or the control board PartSelect Number PS11748221 not telling the dispenser to open the rinse aid. I suggest starting with the wax motor and test it to see if there is continuity and if so the board might be defective. Hope this helps!

Hello and thank you for writing. Yes, it should fir your unit. We hope this helps. Please contact us anytime if you require further assistance.

Hello Echoe, Thank you for your inquiry. We have researched your model and found a white rinse aid cap that will fit, part# PS421128. Hope this helps.

Hello Remo, thank you for your question. We have researched the model you have provided, and the cap is not sold separately. We would suggest the Detergent and Rinse Aid Dispenser, part number PS11746408. If you need help placing an order, our customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you!