General Electric Dishwasher Insulations

Your Price

$7.54

In Stock

VENT PAD

★★★★★

(2)

PartSelect Number PS259749

Manufacturer Part Number WD1X1467

Installation Instructions

Tim from San Pedro, CA

Timer would not allow water to unit

Disconnected power to dishwasher removed the seven screws that hold inside liner to door, and placed liner to the side.
Disconnected power leads to timer then removed the two screws that held the timer in place.
Installed new timer in revers order.
Also replaced the door gasket, one door liner screw, and the vent pad.
The most difficult part was keeping the door latch mechanisim in place when reinstalling the door liner. Read more...

Your Price

$8.50

On Order

Mastic Door

PartSelect Number PS1481837

Manufacturer Part Number WD01X10337

This dishwasher mastic door is sold with a blue film. This can be removed prior to installation.

Installation Instructions

Jim from Kingwood, TX

Power surge after hurricane Ike

First I must say that several appliance service companies told me it would be cheaper to buy new versus repair. Average quote was for $100 as a service call to check it out. I removed the front door coverge and determined it was the controller. Cheched with an Ohmeter ($9.00 unit) for shorts and found none. The new controller was installed together with the other parts and I now have a unit like new that would have cost $1,400.00 to replace. The schematics and parts diagram were invaluable. You also saved about $50.00 over the GE website. Thanks. Read more...

Your Price

$47.29

On Order

INSULATION TUB BLANKET

PartSelect Number PS3505444

Manufacturer Part Number WD01X10448

Your Price

$46.89

In Stock

Tub Insulation

★★★★★

(1)

PartSelect Number PS2374234

Manufacturer Part Number WD01X10419

Installation Instructions

Scott from GREENSBORO, NC

Water Not Draining.

There are videos on YouTube that demonstrate the repair process better than I can type. I will say I'm not certain why the dishwasher wasn't draining other than when I removed the chamber collection and repositioned the ball filter it would work as it should until the next time. Replacing the sump, chamber collection, and ball filter was a shot in the dark. The tub insulation was an improvement on noise. The first cycle seemed to be draining water better. Overall the removal and installation of the parts was not difficult. Read more...

Your Price

$28.15

In Stock

Dishwasher Tub Insulating Blanket

★★★★★

(1)

PartSelect Number PS958842

Manufacturer Part Number WD01X10262

Fixes these symptoms

Noisy
See more...

Your Price

$25.78

On Order

Noise Damper with Adhesive Backing

PartSelect Number PS259751

Manufacturer Part Number WD1X1469

This part dampens the sound of the dishwasher by absorbing the sounds and vibration.

Fixes these symptoms

Noisy
See more...

Installation Instructions

Jim from Kingwood, TX

Power surge after hurricane Ike

First I must say that several appliance service companies told me it would be cheaper to buy new versus repair. Average quote was for $100 as a service call to check it out. I removed the front door coverge and determined it was the controller. Cheched with an Ohmeter ($9.00 unit) for shorts and found none. The new controller was installed together with the other parts and I now have a unit like new that would have cost $1,400.00 to replace. The schematics and parts diagram were invaluable. You also saved about $50.00 over the GE website. Thanks. Read more...

Your Price

$51.46

In Stock

INSULATION TUB BLANKET

PartSelect Number PS8756106

Manufacturer Part Number WD01X10612

Your Price

$69.33