General Electric Dishwasher Switches

Videos!

Your Price

$53.93

General Electric Dishwasher Flood Switch

★★★★★

56 Reviews

PartSelect Number PS8690623

Manufacturer Part Number WD21X10519

This is a flood switch assembly for your washer. The flood switch controls the hot and cold water filling your washer tub to ensure the proper amount of water. You may need to replace this part if your washer is overfilling or underfilling with water. It is about 5.5 inches in length, and mostly black in color with a green tip.

Fixes these symptoms

Leaking
Not cleaning dishes properly
Not draining
See more...

Installation Instructions

Jeff from AUBURNDALE, MA

No water flowing into dishwasher

We tried cleaning out the filter and it clogged with a huge amount of gunk. We removed the gunk, scrubbed the filter, and tried running the dishwasher, but still no water. That took over an hour (not counting the time the dishwasher spent running). Then we tried your diagnosis center and it pointed to the flood switch or the water valve. I extracted the flood switch (another 30-60 minutes) to check it, and it also contained gunk and (significantly) did not rattle, which made me suspect the flood switch was the problem, so I ordered one. Once the replacement arrived, I checked it and the flood switch rattled, confirming that it should work properly. I spent 30-45 minutes installing it, plus the filter assembly and racks I had to remove to access it. Ran the dishwasher and everything came out sparkling clean. I don't know where the gunk came from, but if you aren't getting water and the filter is full of gunk, check the flood switch. Read more...

Videos!

Your Price

$44.64

General Electric Dishwasher Drain Solenoid and Bracket Assembly

★★★★★

11 Reviews

PartSelect Number PS1481923

Manufacturer Part Number WD21X10268

This valve opens in order for the water to drain out of the dishwasher.

Fixes these symptoms

Leaking
Noisy
Not draining
See more...

Installation Instructions

Hector from West Melbourne, FL

Dishwasher water will not drain.

Very easy about 5 min replacement, Checked electrical conductivity to verify I had a bad solinoid, after I received the new part. I removed and replaced part by only removing and re-installed 2 screws and spring. Dishwasher worked like new. Read more...

Videos!

Your Price

$27.45

General Electric Dishwasher Interlock Switch

★★★★★

18 Reviews

PartSelect Number PS1481922

Manufacturer Part Number WD21X10261

The interlock switch may also be referred to as a belt switch. This part is a simple on/off mechanism that prohibits the appliance from operating when the door is open. This is a part for your dryer. The interlock switch senses the door is shut and the dryer can begin. This part might need to be replaced if your dryer is not starting or is in process while the door is open. The black rectangular part of the switch is approximately 2 inches long and a 1/2-inch wide with two gold plates on either end. This is a genuine OEM part that is sourced right from the manufacturer.

Fixes these symptoms

Door latch failure
Will Not Start
Won’t Start
See more...

Installation Instructions

Steven from EPHRATA, WA

interlock switch was bad. Prevents the dishwasher form running as it "thinks" the door is still open.

Opened door, removed screw holding down metal plate that presses against interlock switch when door is closed. Removed plastic cover thingy that is over interlock switches. Removed the interlock switch by pressing the plastic lock thingy away from switch. Pulled the wires off each end of the interlock switch. Removed new interlock switch from plastic bag and reversed above procedure. Done, shut door and the dishwasher works. Read more...

Videos!

Your Price

$20.84

General Electric Dishwasher Switch Interlock

★★★★★

8 Reviews

PartSelect Number PS1021382

Manufacturer Part Number WD21X10224

This switch interlock is found on your dishwasher door, and it must be actuated for the dishwasher to start. If your dishwasher door does not close properly, or if the machine will not start, you may have a problem with your switch interlock. This part is sold individually and is an OEM part, built specifically by the manufacturer.

Fixes these symptoms

Door latch failure
Will Not Start
See more...

Installation Instructions

MICHAEL from ORLEANS, IN

would not start

First I removed the 6 screws that hold the inside cover on the door.Then I remover the plastic cover over the switches,pulled out the switches and disconnected the 2 wires from each switch and connected connected them to the new switches exactly as they were on the old switches.Then reinstalled the switches in their holders.I then removed the plunger and spring from between the switches and installed the new spring and plunger exactly like the old one was installed.I reinstalled the door cover making sure everything was in it's place,I put the screws in the door cover and I was done.It was a very simple job. Mike Read more...

Videos!

Your Price

$7.49

General Electric Dishwasher Float Switch

PartSelect Number PS260235

Manufacturer Part Number WD21X479

Water that fills your dishwasher lifts this float, and when it reaches a certain level, it acts as a trigger for the float switch. The float triggers the float switch to shut off, thereby shutting off the flow of water into the dishwasher.

Fixes these symptoms

Leaking
Will not fill with water
See more...

Your Price

$30.68

General Electric Dishwasher SWITCH INTERLOCK Assembly

★★★★★

4 Reviews

PartSelect Number PS783632

Manufacturer Part Number WD21X10169

Fixes these symptoms

Door latch failure
Will Not Start
See more...

Installation Instructions

Anna from BRIDGEPORT, WA

Dishwasher was stopping mid-cycle and beeping every 15 seconds (as if the door had been opened)

I watched this video: https://www.youtube.com/watch?v=-k0iZGwMOGc
And then I did exactly what it said! It was easy. Plus, when I opened the panel I could see the old switch interlock assembly was melted on one side, so I knew I had gotten the right part! Read more...