General Electric Dishwasher Dishracks

General Electric Appliance Parts
Shop By Part Type

Popular General Electric Dishwasher Dishracks

Your Price
$1.59
  In Stock
RACK SLIDE END CAP
★★★★★
★★★★★
(47)
PartSelect Number PS2370502
Manufacturer Part Number WD12X10304
The Rack Slide End Cap is a white one-inch plastic part which replaces the end cap for your dishwasher rack, preventing your rack from sliding too far. If you find the dish rack is causing the door to not close properly, it may be due to the part being worn out or damaged. All you need to complete this repair is a small flat blade screw driver. Simply pop out the cap with a smaller flat-blade screwdriver and snap the new one into place. If the rear cap needs to be replaced you will need to remove both front caps and slide the rack completely off for full access. It is important to note that this part is sold individually, and more than one may be required, depending on your repair. An inexpensive part, it can be a good idea to purchase several at a time to have on-hand when needed.
Fixes these symptoms
  • Door latch failure
  • Door won’t close
  • Not cleaning dishes properly
  • See more...
Installation Instructions
Joseph from Haymarket, VA
Worn/broken plastic parts were causing misery
Order arrived two days after being placed. Super easy to remove the old, worn, broken plastic parts and replace with new. Everything popped right on just as shown in the diagram. Our happiness with our dishwasher has increased 100%. BTW, thanks to the very helpful, friendly and knowledgeable staff at PartSelect.com -- next job, replace the ice maker in the freezer! Read more...
Your Price
$20.32
  In Stock
Silverware Basket
★★★★★
★★★★★
(56)
PartSelect Number PS959351
Manufacturer Part Number WD28X10128
This is a basket for washing flatware or silverware in your dishwasher.
Fixes these symptoms
Installation Instructions
Jack from PHOENIX, AZ
OLD ONE HAD HOLES IN IT AND SILVERWARE WAS SLIPPING THRUGH THE BASKET TO THE INTERIOR OF THE DISHWASHER
1. remove old basket. 2 Place new basket.. Done Read more...
Your Price
$3.44
  In Stock
END CAP
★★★★★
★★★★★
(17)
PartSelect Number PS7783360
Manufacturer Part Number WD12X10426
This is an end cap for a dishwasher rack. This part is about 2.5 inches long, is black, and is made of plastic. You may need to replaced this part if it is broken, or if your dishwasher rack continuously falls off the track or rail.
Installation Instructions
Wilson from MENIFEE, CA
upper and lower rack ASM showed sing of rust
Repair was simple, lower rack just remove and replaced with out any tools or disassemble required, for the upper rack installation, the end cap need to be removed out of the sliding tracks, slide old rack out and discard, clean the track with a suitable cloth and slide new rack in to the tracks, reinstall the old end caps, as a good preventing measure, order new end caps just in case they are need it if the old ones crack during removal.
save old rollers from old racks for future repairs
Read more...
Your Price
$162.11
  In Stock
Dishwasher Lower Dish rack with Wheels
★★★★★
★★★★★
(56)
PartSelect Number PS3486947
Manufacturer Part Number WD28X10284
Fixes these symptoms
Installation Instructions
michael from Bloomington, IN
lower dishrack rusted
replaced rack, no repairs required Read more...
Your Price
$160.14
  In Stock
Dishwasher Lower Dish Rack with Wheels - Gray
★★★★★
★★★★★
(23)
PartSelect Number PS8746204
Manufacturer Part Number WD28X10384
Fixes these symptoms
Installation Instructions
Alan from Surprise, AZ
Replaced the bottom washer rack.
Just took out the old rack and replaced it with the new one. Read more...
Your Price
$27.16
  In Stock
Silverware Basket with Lids
★★★★★
★★★★★
(16)
PartSelect Number PS1016011
Manufacturer Part Number WD28X10177
This is a basket for washing flatware or silverware in your dishwasher.
Fixes these symptoms
Installation Instructions
Gerald from Kearney, NE
Broken "small" silverware holding lid
Replaced the entire basket and lids. Read more...
Your Price
$5.82
  In Stock
Upper Rack End Cap
★★★★★
★★★★★
(1)
PartSelect Number PS958986
Manufacturer Part Number WD12X10184
This end cap is sold individually. It is the same end cap used on the right and left side, for both front and back. It attaches to the end of the upper rack slide rail, and prevents the rack from falling when being pulled out too far.
Installation Instructions
steve from ramsey, MN
Broken drawer slides
The repair was very easy, I just had to replace some bad bearing slides in the drawer pull. Remove the end cap, remove the top drawer, remove the old bearing slide from the drawer slide and snap the new one in. finally replacing the end caps.
Ordering the parts was easy and delivery was fast.
Read more...
Your Price
$24.71
  In Stock
Silverware Basket
★★★★★
★★★★★
(18)
PartSelect Number PS261346
Manufacturer Part Number WD28X265
The silverware basket, used for dishwashers, is in the bottom of the dishrack. The basket is used to hold eating utensils such as spoons, forks, and knives. If the basket is worn out or broken, you should replace it with this part. No tools are required as it is an easy replacement. If you need further guidance refer to the instructions provided by the manufacturer. For safety precautions make sure to unplug the dishwasher and wear gloves.
Fixes these symptoms
Installation Instructions
Joseph from Elmendorf, TX
Basket was lost
Opened package from Parts Select.
Removed Silverware basket from package.
Opened Dishwasher.
Inserted Silverware Basket in rack.
Closed Dishwasher.
Discarded shipping package.
Told wife I fixed Dishwasher.
Sat down & had a beer.
Read more...
RACK ROLLER Assembly LOWER
PartSelect Number PS8756482
Manufacturer Part Number WD28X10387
This dish rack is for dishwashers. Dish rack holds the dishes in place during the dish washing cycle.
Guide Rail Bracket Assembly
PartSelect Number PS1481873
Manufacturer Part Number WD12X10221
This guide rail bracket assembly, also known as the dishrack support roller, is made for your dishwasher. It connects to the tub, and allows the dishrack guide rail to move in and out. If the wheels on the bracket assembly become worn or damaged, the guide rail may not be able to slide in and out, and your dishrack will not roll out smoothly. In this case, you will need to replace the assembly.

Related Parts