Kenmore Washer Pulleys

Videos!

Your Price

$38.96

Kenmore Washer Drive Pulley

★★★★★

23 Reviews

PartSelect Number PS10057144

Manufacturer Part Number W10721967

This splutch cam kit is a genuine replacement assembly designed for select Whirlpool, Maytag, and affiliated brand washing machines. It plays a critical role in the wash and spin cycles by engaging the drive motor to rotate the washer basket. The kit includes the clutch assembly, cam ring, spring, basket drive gear, pulley, and mounting nut. Replacing this component can resolve issues such as noisy operation, slow or failed spinning, poor agitation, and excessive moisture in clothes after a cycle. In some cases, a burning smell may also indicate a failing clutch. Installation requires basic tools and should be performed with the appliance disconnected from power. Compatibility should be confirmed using your washer’s model number.

Fixes these symptoms

Burning smell
Cycle Not Advancing
Noisy and Marks Left on Clothes
See more...

Installation Instructions

Jerry from WALLA WALLA, WA

Noise on bottom of Washer louder as time went on. 1 1/2 years

Well, first investigated and found loose nut on drive clutch. First take off the two screws with nut drive then cover off using a screwdriver blade to snap off the cover. Then socket ratchet to take off the nut on drive clutch. take off belt by slowly rotating the drive gear. two screws that hold the electronics to the upper drive clutch and put aside, so you can snap off the cover for drive clutch on upper part with screwdriver and off the parts come and install whole unit back as took it apart. Line up the new upper clutch so that is position as was before. (Using parts diagram helps a lot as www. partsselect.com has for you or Maytag.com.) Then put the electronic part board back on and the gear and nut. Make sure it is tight by several attempts to make sure it's snugged up good and then slowly roll belt back on the pulley and motor drive. Put your cover guard back on with two screws and done. Read more...

Videos!

Your Price

$100.40

Kenmore Washer Drum Drive Pulley

★★★★★

1 Review

PartSelect Number PS11745017

Manufacturer Part Number WP8182650

This drive pulley attaches to the back of the washers drum.

Fixes these symptoms

Spinning Issues
Will not agitate
See more...

Installation Instructions

Francis from Rochester, NY

Washer made loud banging noise during spin cycle

I first removed the back panel held on by about 10 screws. I removed the drive belt from the pulley, then removed the lock nut securing the pulley to the drum & removed the pulley. Attached the new pulley to the drum, tightened on the lock nut, attached the new belt & ran a spin cycle. When that went OK I replaced the back panel & the washer was back in service. Read more...