My Orders
Kenmore Washer Timers
GET YOUR OFFICIAL Kenmore PARTS TO ENSURE VICTORY
Popular Kenmore Washer Timers
To release knob - pull the tab at the backside of the timer.
To release knob - pull the tab at the backside of the timer.
The timer controls most of the operations of the washer: water level, tub filling and emptying, length of cycles, and cycle setting sequences.
The timer controls most of the operations of the washer: water level, tub filling and emptying, length of cycles, and cycle setting sequences.
This appliance timer controls the duration of operating cycles by regulating when specific functions start and stop. It helps ensure accurate timing for proper performance and is commonly replaced when cycles do not advance, stop too early, or continue running longer than intended.
This appliance timer controls the duration of operating cycles by regulating when specific functions start and stop. It helps ensure accurate timing for proper performance and is commonly replaced when cycles do not advance, stop too early, or continue running longer than intended.
MAKE THIS REPAIR A GUARANTEED WIN
OVER 2 MILLION PARTS TO ENSURE VICTORY
The timer controls most of the operations of the washer: water level, tub filling and emptying, length of cycles, and cycle setting sequences.
The timer controls most of the operations of the washer: water level, tub filling and emptying, length of cycles, and cycle setting sequences.
Installation Instructions
pasqual from Escondido, CA
had to go and buy tap&die set for the timer screws
had to make treads for the screws on the timer
Installation Instructions
Tom L from Austin, TX
Machine would fill but would not advance.
First removed the end caps that hid the two screws that attached the control panel to the main washer cabinet. Then removed a couple of other nuts that secured the back of the control panel. I was then able to lay the entire control panel on its face and access the timer which was attached with two screws. The knob screws on and is fre
... Read more
e wheeling unless it is pushed in, so I pushed it in and then was able to unscrew it from the timer. The timer had three plugable wiring harnesses attached which were easy to remove and replace. The entire job took about 35 minutes and would only take about 20 minutes if I had to do it again.
Read less