Whirlpool Washer Hoses and Tubes

Whirlpool Appliance Parts
Shop By Part Type

Popular Whirlpool Washer Hoses and Tubes

Your Price
$26.58
  In Stock
Drain Hose
★★★★★
★★★★★
(22)
PartSelect Number PS11753688
Manufacturer Part Number WPW10358149
It connects from the pump to the back panel. The clamp is not included.
Fixes these symptoms
Installation Instructions
Esther from Santa Ana, CA
Drain hose had a leak
The repair was so easy. The part came quickly and with easy to follow directions. I am a woman and a single parent; needless to say, I don't have time or money to waste. This repair cost me under $30 and under 30 minutes to fix. Thank you again! Read more...
Your Price
$37.17
  In Stock
Faucet Adapter
★★★★★
★★★★★
(16)
PartSelect Number PS11751238
Manufacturer Part Number WPW10254672
The faucet adapter for your portable dishwasher or washing machine attaches to the faucet and allows you to connect the machine to the tap. Before you install the faucet adapter on your taps, be sure that it fits the coupler on your dishwasher or washer. As per the factory, this is used for faucets with inside or outside threads. For female connection (outside) just remove the washers. This adapter is approximately 1 inch in length, and slightly less than one inch in diameter. This adapter comes with two different thicknesses of rubber washer. You will not need to use both so be sure to determine which thickness works best for your tap before installing it.
Fixes these symptoms
Installation Instructions
Stephen from Enfield, CT
faucet attachment would not sit correctly in hose connector to portable dishwasher. Received machine second hand. Could not find a replacement faucet adapter. So ordered new one and hose plus connector.
Turned machine on side. Removed two casters with Wonder Tool prybar. Then used it to remove plastic push screws holding cardboard bottom cover. Unscrewed water hose. Used screwdriver to remove clamp on drain hose. Stood machine upright, opened door. Unscrewed two screwsfrom tabs into woodblock top. Slid top forward and removed it. Cut plastic hose retainer. Removed hose assembly. Installed new hose by reversing steps. Used a new wire strap to hold hoses in place on top corner of machine. Read more...
Your Price
$22.52
  In Stock
Tub-to-Pump Hose Kit
★★★★★
★★★★★
(8)
PartSelect Number PS334685
Manufacturer Part Number 285871
This kit comes with the clamps.
Fixes these symptoms
Installation Instructions
Marc from Morton Grove, IL
Two leaking hoses in my washing machine
Put the machine on its side. Remove old hoses and screw new ones into place. Done in under 20 minutes. Read more...
Your Price
$21.03
  In Stock
Water Inlet Hose
★★★★★
★★★★★
(5)
PartSelect Number PS11741209
Manufacturer Part Number WP3357328
This part is the replacement water inlet hose for your washer. It is black in color, made of plastic, and is approximately 19 inches long. The water inlet hose connects the water inlet valve to the water fill nozzle. Over time the hose can become cracked and damaged, and this can cause it to leak. A damaged hose will need to be replaced. Be sure to disconnect the water supply to the washer before you begin this repair. You should also determine if any of the other parts that transport water into the washer are leaking, and if they need to be repaired as well. This part is sold individually and is a genuine OEM part.
Fixes these symptoms
Installation Instructions
Timothy from Springfield, VA
Cold water flowed slowly
First, be sure to take the washer apart properly! The first time I fixed my washer I took it apart the hard way to change the clutch, and believe me it took longer to put it back together!
This time I was replacing both the water inlet valve and the hose leading to the disperser.
First remove the two screws holding down the control panel. It then flips back and hangs out of the way behind the washer. Then remove the spring-clip holding the rear plate to the body of the washer, one on each side under the control panel.
Next you need to remove the screws holding the body down to the base at the rear of the machine.
I then tipped the body of the washer forward and let it rest on a bucket so I didn't have to take it completely off. Then it is easy to access the hose and the water inlet valve. Shut off the water and remove the supply hoses to the washer. Remove the two screws holding the water inlet valve to the rear of the washer using a nut driver. Next remove the wires to teh inlet valve, making sure to note which one is cold and hot, and which orientation they are. Mine was yellow on top and brown on bottom. Next remove the springs clamps holding the hose on. Replace the hose re-using the same clamps. Replace the water inlet valve reverse the process to re-assemble the washer. Tilt the body back on, put the screws in the base, clamp the back to the body, flip the contorl panel back over and insert the screws. Reattach the water supply lines and you are done!
Read more...
Your Price
$27.93
  In Stock
Pump Hose
★★★★★
★★★★★
(3)
PartSelect Number PS11755212
Manufacturer Part Number WPW10467168
This hose attaches to water pump assembly. NOTE: As per the manufacture if the washer has an Eco Ball, it's no longer needed when the new hose is installed.
Fixes these symptoms
Installation Instructions
Alexander from Miami, FL
Washer leaking
Opened the front panel with 3 crews T-25 or socket wrench. Panel comes off right away.

Look for the leak. Determined it was the hose. Use power pliers to remove the clamp.

The small clamp was easy. The big one I had to use my yoga to get to it. It probably would had been easy from the back panel but moving the machine requires brute force.

Once the hose was out I found some bra under wires which is what probably punctured the hose.

Removed the front filter and found a bunch of nails.

Assembly was much easier and placed clamps so that if needed it would be a lot easier to remove and replace.
Read more...
Your Price
$21.53
  In Stock
Break Hose
★★★★★
★★★★★
(6)
PartSelect Number PS11745951
Manufacturer Part Number WP8317926
This hose goes from valve to inlet.
Fixes these symptoms
Your Price
$12.88
  In Stock
Inlet Hose - 5 FT
★★★★★
★★★★★
(3)
PartSelect Number PS11746820
Manufacturer Part Number WP89503
This hose can handle hot or cold water and is five feet long.
Fixes these symptoms
Installation Instructions
Helen from NASHUA, NH
Leaking water inlet hoses.
Removed the old hoses and screwed on the new hoses. Read more...
Your Price
$29.90
  In Stock
Drain Hose
★★★★★
★★★★★
(5)
PartSelect Number PS11747970
Manufacturer Part Number WPW10003250
This hose goes from the drain pump to the back of the washer.
Fixes these symptoms
Installation Instructions
anthony from EASTPOINTE, MI
I was getting a sewer smell when the washer drained I did every cleaning technique and didn't solve the problem then I cleaned the inside drain hose and that helped so I replaced the hose and problem solved.
I removed the back panel to access the top end of the hose then I removed the lower front panel to access the lower end of the hose that attaches to the pump. The hose is secured with spring clamps and they were removed with pliers, the panels are secured with screws.

I replaced the hose and reinstalled the panels and I was done.
Read more...
Your Price
$37.36
  In Stock
Drain Hose
★★★★★
★★★★★
(14)
PartSelect Number PS11748248
Manufacturer Part Number WPW10096921
This drain hose is 42" long and includes the clamps.
Fixes these symptoms
Installation Instructions
Francis from Yuba City, CA
I bought a used washer from a friend and they had cut the drain hose short .
I got a pair of channel lock pliers and took off clamp on the hose, after laying wash machine on it's side, poped off a few little clips and replaced the hose, and now everything works perfect. Read more...
Your Price
$29.94
  In Stock
Water Pressure Hose - Cut-to-Fit
★★★★★
★★★★★
(2)
PartSelect Number PS11741846
Manufacturer Part Number WP353244
This is the hose that tells your appliance if your tub is at the desired water level.
Fixes these symptoms
Installation Instructions
Marni from Buhl, ID
water overflowing when filling
I ordered the parts at a minimal cost compared to the repairman's quote, they arrived in 3 days. I used the laptop and put it right next to where I was working so that I could follow the directions step-by-step. The instructions were easy to follow and showed you right what to do so I never had any questions. My washer had a slightly different configuration but I figured it out. Replacing the parts was simple, take one off, put the other on. Putting the washer front back on was a little tricky, I had to have my daughter help me hold it in place while I wiggled it around to make sure it was just right before I screwed it back together. It was easier than I thought it would be. I told my husband I loved the internet, I would never have been able to do this job without the instructional video. Thanks PartsSelect! Read more...

Related Parts