Whirlpool Washer Knobs

Whirlpool Appliance Parts
Shop By Part Type

Popular Whirlpool Washer Knobs

Your Price
$9.11
  In Stock
D-Shaped Knob Insert
★★★★★
★★★★★
(1)
PartSelect Number PS11746209
Manufacturer Part Number WP8536939
This insert is sold individually. Knob not included. Knob is sold separately.
Fixes these symptoms
  • Timer will not advance
  • Will not fill with water
  • Will Not Start
  • See more...
Your Price
$29.99
  In Stock
Control Knob
★★★★★
★★★★★
(19)
PartSelect Number PS11744940
Manufacturer Part Number WP8181859
This knob is light gray and is used on platinum-colored models. Sold individually and accepts a D-shaped shaft.
Fixes these symptoms
Installation Instructions
eric from Boulder, CO
Belt Wheel was broken at axle. Terrible noise.
Removed the top and back of dryer with screw socket. It was quite easy. Then, I removed the broken wheel by releasing the tension spring. I replaced the wheel. The toughest part was re-threading the belt. But, even that was simple. The dryer runs smoothly and quietly again! Read more...
Your Price
$9.11
  In Stock
Control Knob
★★★★★
★★★★★
(3)
PartSelect Number PS11757250
Manufacturer Part Number WPW10711289
This control knob is for dryers. Control knob lets you control cycle settings. Remove the knob by pulling it straight off its post.
Installation Instructions
JEFFREY from MODESTO, CA
The broke of the knob and had to replace the whole mother board and the knob
I had to remove the whole top of the washer and unplugged all the wire to the board. Getting the board out was the hardest thing to do because no screws it was clamped in place. Once I figured how to unclamped the thing without breaking it, it was relatively simple and to only 15 min to button it back up. Read more...
Your Price
$14.33
  In Stock
Push Button
PartSelect Number PS11754596
Manufacturer Part Number WPW10424308
This push button is just over three inches long. It is all black in color and is made of plastic.
Fixes these symptoms
Your Price
$32.46
  In Stock
KNOB
★★★★★
★★★★★
(5)
PartSelect Number PS11738143
Manufacturer Part Number W10875909
Your Price
$30.01
  In Stock
Control Knob - Pewter
★★★★★
★★★★★
(9)
PartSelect Number PS11744954
Manufacturer Part Number WP8182050
Sold individually. This knob accepts a D-shaped shaft.
Installation Instructions
John from Yorba Linda, CA
Broken timer knob
Was very simple repair, and just required pushing the new knob on by hand pressure. The part was ordered and it was delivered in two days, and I will not hesitate to order from this company again Read more...
Your Price
$27.21
  In Stock
Timer Knob
★★★★★
★★★★★
(17)
PartSelect Number PS11741244
Manufacturer Part Number WP3364291
This is an improved white timer knob with metal threads.
Fixes these symptoms
Installation Instructions
Joe from Covington, GA
Washer would not wash on "normal" cycle. Had to play with the knob to get it to run at all. Washer would not drain properly either.
I unplugged the washer from the electrical outlet.

I then removed the drain hose from the wall drain to allow me to turn the washer to gain access to the the back panel.

From the front, I then removed the plastic timer knob from the timer by unscrewing it. Then I pulled the plastic plate with the arrow on it to remove it. This exposed the screws that attached the timer to the control panel. I left them attached.

I then removed the two screws on the bottom of the front of the control panel (on each end) that attach the control panel to the washer.

I then went to the rear of the washer and removed the two screws on the top of the rear of the control panel.

I went back to the front and pulled the control panel forward and up to release it from the washer.

I then removed the two screws (that were under the plastic plate) that attached the timer to the panel and removed the timer from the panel.

Then I unplugged the wiring harness from the timer and removed the timer completely.

From there I reversed the procedure to install the new timer and knob.
Read more...
Your Price
$33.19
  In Stock
Hold to Start Button - Aqua
PartSelect Number PS11744942
Manufacturer Part Number WP8181861
Fixes these symptoms
Installation Instructions
Richard from FREDERICKSBRG, TX
The hold to start button would not start wash cycle
After disassembly per the video, I identified the plastic bracket holding the button had broken allowing the hold to start button to shift from pushing the red button on the circuit board to start the door latching cycle. I glued the plastic bracket with JB Weld after holding it in proper position with Gorilla Tape. After letting it dry over night, I reassembled and the original Hold to Start button worked fine. I did not need the replacement button as I originally thought. The disassembly process took 15 minutes. Take the time to break the front of the washer down per the video prior to ordering parts. Read more...
Your Price
$32.83
  On Order
Timer Knob Assembly - Stainless
★★★★★
★★★★★
(10)
PartSelect Number PS11748028
Manufacturer Part Number WPW10034750
This part is a replacement timer knob for your dryer. The knob is stainless steel and is approximately 3 inches in diameter. It is found on the control panel and allows you to turn your dryer on and to adjust the settings. If the timer will not advance, or you notice that the knob is damaged, you will need to replace it. To replace the knob, carefully slide it off its shaft, and replace with the new knob. It is sold individually and is a genuine OEM part from the manufacturer.
Fixes these symptoms
Timer Knob
PartSelect Number PS11741232
Manufacturer Part Number WP3362624
This replacement timer knob is black with a chrome center. Use this improved timer knob with its metal threads for your clothes washer. Colors Almond, Toast and Platinum are discontinued.

Related Parts