Drum Support Bearing 131825900

Lower Front Felt Seal with Adhesive

David from EDGEWOOD, NM
Difficulty Level:
Easy
Total Repair Time:
More than 2 hours
Tools:
Screw drivers

5 of 5 people found this instruction helpful.

Was this instruction helpful to you?

The drier was "screeching"

First of all, the folks at Part Select have been terrific. I balled up my address and they were great in correcting my error and getting the parts promptly to me. They provide directions with the parts. And You Tube, is a wealth of information too. The process is to remove the drum and replace the nylon busihing that supports the drum ... Read more

Read less

Other Parts Used:

Michel from CHICAGO, IL
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Pliers, Screw drivers

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

dryer had vibration after couple minutes of running

i read reviews and finally found a person that replace the motor, rear bearing, front top glides, and tension arm/pulley.. i had cleaned the fan motor with a tooth brush best i could the 1 time i had it apart. after the 4th time apart and reading a different review that said replace the fan motor housing/fan. i did and noise gone.

Other Parts Used:

Front Upper Felt Seal with Adhesive

Troy from ROYALTON, MN
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

DRYER MADE A LOT OF NOISE

Took the top dryer cabinet apart to replace all the above parts plus the dryer belt. Because of its age decide to replace all the parts from the above list.
Three major problems: none of the video reviews showed this type of dryer. Some parts were practically impossible to get back together. Difficult getting the top square. The top ... Read more

Read less

Other Parts Used:

Dryer Drum Bearing Bracket

Drum Glide - White

Heater Assembly

Lower Front Felt Seal with Adhesive

Jerry from ROCKWALL, TX
Difficulty Level:
Very Difficult
Total Repair Time:
More than 2 hours
Tools:
Nutdriver, Pliers, Screw drivers, Socket set, Wrench (Adjustable)

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Dryer heater broken

Removed top cover.
Lowered control assembly.
Removed front door assembly.
Removed drum.
Removed heater assembly.
Removed support bearing and bracket using existing bonding ball.
Re-assembled in reverse order.

Other Parts Used:

Dryer Drum Bearing Bracket

Heater Assembly

Johnny from PINEBLUFF, NC
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers

4 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Squeaky drum until drum would not turn.

Watched on-line video, then applied those steps.
1. Pop the front of the deck loose using putty knife to depress clips;
2. Disconnect wires from light and door switch;
(Before I disconnected wires from door switch and light, I made wiring sketches to make sure I reconnected in original manner.)
3. Remove lint filter ... Read more

Read less

Other Parts Used:

Doug from ODESSA, TX
Difficulty Level:
Easy
Total Repair Time:
1- 2 hours
Tools:
Nutdriver, Pliers, Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

Had a squelch/squeak coming from the rear of the unit

I looked up a YouTube video on my specific model. Found one that said “basic disassembly”. I watched that and had it apart and back together in no time. Very easy to take apart and put new parts back in it. Re-assembled and since the repair no squeaking.

Other Parts Used:

Stephen from HICKSVILLE, OH
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers, Socket set

1 person found this instruction helpful.

Was this instruction helpful to you?

dryer drum quit turning

followed the instructions video on the site had no problems just took about 2 hrs to complete

Other Parts Used:

Upper Drum Glide

Front Lower Drum Seal

FRANK from VERO BEACH, FL
Difficulty Level:
A Bit Difficult
Total Repair Time:
More than 2 hours
Tools:
Nutdriver, Screw drivers, Socket set, Wrench set

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Drum belt and bearing needed to be replaced.

Unplugged dryer, removed access panel on the back of dryer. Removed access panel on the front of the dryer. Removed the front panel of the dryer. Inside the drum, removed the three screws on the center bearings. Slide the bearing out of the bearing support. Replaced the bearing support. Then reassembled the drum. Replaced the belt a ... Read more

Read less

Other Parts Used:

Multi-Rib Drum Belt

Troy from GOTHENBURG, NE
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

Very noisy

Replaced rear drum bearing, drum support bearing & drum belt. Still very noisy. Will order new motor & see if that does the trick.

Other Parts Used:

Cherry from WATERVLIET, NY
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers, Screw drivers

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

< Prev
1
2
3
Next >

Questions and Answers

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

3 questions answered by our experts.

Sort by:

< Prev
1
Next >

Dave

October 15, 2017

Does this part come with lubricant? If not, please describe required high temp grease to use.Thanks.

For model number AEQ6700FS0

Hi Dave, Thank you for the question. The lubricant is only sold as part of the kit, Rear Drum Bearing Kit PartSelect Number: PS459829.Hope this helps!

15 people found this helpful.

Did this question help you?

Randy

November 11, 2021

How do I get the washer front or top panel off

For model number GLEH1642FS2

Hello Randy, Thank you for the question. Here is a link to a How to Video that may help. Good luck with the repair!

1 person found this helpful.

Did this question help you?

George

June 9, 2023

What is the high temp grease needed with the bearing drum support #131825900. It did not come with the part.

For model number CRER7900AS0

Hi George, Thank you for the question. The high-temperature grease is only sold as part of the rear drum bearing kit, part number PS459829. We hope this helps!

Did this question help you?

Related Parts: