Front Upper Felt Seal with Adhesive 5303937182

Timothy from OWINGS MILLS, MD
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins

2 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

dryer had vibration after couple minutes of running

i read reviews and finally found a person that replace the motor, rear bearing, front top glides, and tension arm/pulley.. i had cleaned the fan motor with a tooth brush best i could the 1 time i had it apart. after the 4th time apart and reading a different review that said replace the fan motor housing/fan. i did and noise gone.

Other Parts Used:

Drum Support Bearing

Troy from ROYALTON, MN
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

DRYER MADE A LOT OF NOISE

Took the top dryer cabinet apart to replace all the above parts plus the dryer belt. Because of its age decide to replace all the parts from the above list.
Three major problems: none of the video reviews showed this type of dryer. Some parts were practically impossible to get back together. Difficult getting the top square. The top ... Read more

Read less

Other Parts Used:

Dryer Drum Bearing Bracket

Heater Assembly

Jerry from ROCKWALL, TX
Difficulty Level:
Very Difficult
Total Repair Time:
More than 2 hours
Tools:
Nutdriver, Pliers, Screw drivers, Socket set, Wrench (Adjustable)

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

High pitched squeal from dryer during use...

Followed directions of another website...had to replace ball and socket joint that attached the drum to the back frame of the dryer...removed top outside metal cover of dryer to facilitate attaching ball/socket kit to the drum...this allowed us to secure the ball/socket kit to the drum without cross threading the screws...with the top of ... Read more

Read less

Other Parts Used:

Multi-Rib Drum Belt

Robert from OCEAN SPRINGS, MS
Difficulty Level:
A Bit Difficult
Total Repair Time:
More than 2 hours
Tools:
Screw drivers, Socket set

2 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Dryer had a terrible squealing & thumping noise

Both my husband and I had watched the videos for the parts we ordered. While we had a small space to work in, the repair on our dryer went fine. We are very happy with the parts we ordered along with the short amount of time it took to arrive. Thank you very much for the videos. Purchasing these parts and having the videos really saved u ... Read more

Read less

Other Parts Used:

Drum Belt

Rear Drum Bearing Kit

Karen from GREENVILLE, FL
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers, Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Noisy and clothes getting caught

The repair requires the front panel to be removed. First remove the top by removing two screws in the back of the top panel. Once the top is removed, you have access to all of fasteners for the front panel. I removed the control panel to give myself more room. Simply remove the wire connectors on the panel and two connectors in the up ... Read more

Read less

Other Parts Used:

John from CHAMPAIGN, IL
Difficulty Level:
Easy
Total Repair Time:
1- 2 hours
Tools:
Screw drivers

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Very loud squeaking

Opened top, removed front cover, removed belt, took out drum, replaced bearing on drum and bearing guide on back of dryer. Reinstalled drum and belt, then replaced drum glides and upper felt,let glue set with clamps over night.

Other Parts Used:

Rear Drum Bearing Kit

Drum Support Bearing

william from hackettstown, NJ
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers

2 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Making a squiking noise and letting lint into the cavity of the dryer

pulled appliance away from wall and unplugged the electrical cord and then used putty knife to pop up the top. Then removed the screws that held the front in place. Disconnected the wire to the switch on the door and then front on a rug and used acetone and scraper to remove the old glue and felt. Cleaned the area thoroughly and apply ... Read more

Read less

Other Parts Used:

Robert from Rice Lake, WI
Difficulty Level:
Really Easy
Total Repair Time:
1- 2 hours
Tools:
Screw drivers

2 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Replacement of broken dryer belt and other parts.

My wife was able to easily do the repair before I could get home from work to do it. She watched the PartSelect video on her iPad as she did the necessary steps to get the belt replaced. We only needed one glide replacement, as one was still attached and intact. We should have purchased both sets of felt seal replacements, though that ... Read more

Read less

Other Parts Used:

Drum Belt

David from Three Rivers, MI
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers

4 of 6 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

terrible shrieking noise and drum stopped moving when under a load

flipped up the top of dryer, turned it 180 so it sat on the washer. next I took out the two screws that held the front panel on. panel popped off and drum came up and then out of bearing assembly. two screws and the bearing assembly came off; it was melted and deformed. The metal on the back of drum was also deformed and worn oblong. ... Read more

Read less

Other Parts Used:

Drum Belt