Frigidaire Dishwasher Circuit Boards and Touch Pads

No Longer Available

Electronic Control Board

★★★★★

(1)

PartSelect Number PS11758074

Manufacturer Part Number 5304504782

Electronic control board 5304504782 manages the functions of the dishwasher such as washing, draining and drying

No Longer Available

Control Panel with Touchpad

★★★★★

(1)

PartSelect Number PS2379423

Manufacturer Part Number 5304475578

Fixes these symptoms

Will Not Start
See more...

No Longer Available

CONSOLE ASSEMBLY

PartSelect Number PS9865008

Manufacturer Part Number 5304496526

No Longer Available

Control Board With Selector

★★★★★

(3)

PartSelect Number PS2352995

Manufacturer Part Number 154712101

This is a 4-button board. This part would be the main "brains" of the appliance which is activated by selecting a certain function with the touchpad.

Fixes these symptoms

Will Not Start
See more...

Installation Instructions

Jonathan from Stamford, CT

Drain Motor would not run

I remove the 5 or 6 screws that hold the plastic decorative top front cover in place (the screws are on the inside of the door). Lifted and pulled the cover off of the door. Pushing in the two side clips, detached the control module power/control connector from the door. Removed two screws that hold the control module to the cover, then released the snapping clips that hold the control model in place. Reversed all the steps and ran a test cycle. It worked! Thanks PS! Read more...

No Longer Available

Electronic Control Board

PartSelect Number PS2379414

Manufacturer Part Number 5304475569

No Longer Available

Control Board

PartSelect Number PS2373397

Manufacturer Part Number 154776601

Fixes these symptoms

Will Not Start
See more...

Installation Instructions

Travis from OAK PARK, IL

Dishwasher not going through the wash cycle

First disconnect the power. Open the dishwasher door. Unscrew all of the screws except the top two screws. Unscrew the top two screws last and slide the door off. Unscrew the housing for the control board. Disconnect the wires from the control board(take a picture or mental note where the wires are positioned for reinstalling). Unscrew the control board. Put the new board in and go in reverse order until the job is complete. Good luck. Read more...