Microwave Springs and Shock Absorbers
Find your part
Enter your model number or a part number and click "Search"Here is an example model number plate:
Popular Microwave Springs and Shock Absorbers
Your Price
$37.73
Door Latch Spring
PartSelect Number PS979582
Manufacturer Part Number 5304440316
The microwave door latch spring creates tension, and engages the door latch when the door is closed. This spring is made completely of metal, and is approximately 1 inch long. If your microwave door will not open or close properly, the microwave will not start. You may need to remove the control panel to gain better access to where the spring attaches, so make sure the power is disconnected from the microwave. This part is sold individually.
NOTE: Remember to discharge the capacitor for your microwave before beginning this repair. The capacitor can hold a potentially lethal charge even when the power has been disconnected from the microwave itself.
Fixes these symptoms
- Door not closing properly
- See more...
Your Price
$13.02
Interlock Spring
PartSelect Number PS1964350
Manufacturer Part Number W10156812
Fixes these symptoms
- Door not closing properly
- Won’t turn on
- See more...
Installation Instructions
Mark from HOMER GLEN, IL
Door switch inconsistent operation for Open/Close sensing.
Ordered top & bottom micro-switches and mounting plate parts. Internet reviews could not find specifics if the issue was due to a top/bottom or combination of micro-switch or mounting plate failure. Pulled the plug. Removed the top vent assembly cover held in by 2 Phillips screws inside the vent. Removed the control panel held in by 1 Phillip screw at the top vent assembly area. Lifted control panel upward to release the catch and moved it off to the side - didn't disconnect any leads. Used a Torx bit to remove the door switch mounting plates at the front and pulled the plates through the opening from the control panel. Documented the wire color code connections, the top plate uses 2 micro's with one using both the closed & open contact. Installed the respective micros on the mounting plates and worked backwards with the wiring and removal steps. Once completed, the open/close sensing has worked every time.
Read more...
Your Price
$7.49
SPRING
I found PartSelect and called them. They didn't have the exact problem I had. They had a FAQ about the MW not starting. Mine wouldn't stop.
After describing what was happening, they had it in one. Looked at the plastic latch, bottom was curved out of shape. Door wouldn't close properly, causing it to run. It didn't heat, just ran. I ordered the parts. A spring and a latch. They came in quickly and my son and I began the repair. Found a You Tube on a similar type of door and they posited it might be the latch with step by step to follow. Ran back and forth from computer to kitchen.
Now, we didn't have the right tools to go along with the video we were watching. A long thin blade (about 12 inches) knife was used as the putty knife to pry up the edging that held the door glass. My son's long thin tiny philips screwdriver he uses to fix toys worked for the really tiny screws that held the latch part. We didn't have long nose pliers, but we messed up that part anyway, forgot to put in the new spring with the new latch. We worked it by hand and it went back together. Put it all together and discovered we forgot to put those tiny screws back at the latch. Wrestled the door back on and started it. Almost had a heart attack as it still was running when off. So unplugged,let it reset and it's been fine. Think it probably would have gone smoother with the proper tools. Anyway, glad I found PartSelect and that it was a relatively easy fix, even for those without tools and experience. A am a retiree, so don't feel you can't do it. Thank you so much PartSelect. Read more...
PartSelect Number PS1993448
Manufacturer Part Number 5304464069
Fixes these symptoms
- Door not closing properly
- See more...
Installation Instructions
Patricia from CLEARWATER, FL
MW wouldn't stop running- not heating, just running
Went through some anxious hours when I found that the MW would not turn off. The only way was to leave the door open. Not a solution. Tried a appliance repair that I knew, they didn't work on MWs. Spoke to the manufacturer, for $99 would come out and then tell me the real cost to fix. After more searching, even to maybe getting a new MW, (which necessitates getting a new bracket for the over the stove MW. They evidently are not standard, but proprietary to brands. Not good!)Buying a MW, okay, but someone has to put it in. Where are the good old days of selling, delivery, service? I'm from a small town, that's SOP. I found PartSelect and called them. They didn't have the exact problem I had. They had a FAQ about the MW not starting. Mine wouldn't stop.
After describing what was happening, they had it in one. Looked at the plastic latch, bottom was curved out of shape. Door wouldn't close properly, causing it to run. It didn't heat, just ran. I ordered the parts. A spring and a latch. They came in quickly and my son and I began the repair. Found a You Tube on a similar type of door and they posited it might be the latch with step by step to follow. Ran back and forth from computer to kitchen.
Now, we didn't have the right tools to go along with the video we were watching. A long thin blade (about 12 inches) knife was used as the putty knife to pry up the edging that held the door glass. My son's long thin tiny philips screwdriver he uses to fix toys worked for the really tiny screws that held the latch part. We didn't have long nose pliers, but we messed up that part anyway, forgot to put in the new spring with the new latch. We worked it by hand and it went back together. Put it all together and discovered we forgot to put those tiny screws back at the latch. Wrestled the door back on and started it. Almost had a heart attack as it still was running when off. So unplugged,let it reset and it's been fine. Think it probably would have gone smoother with the proper tools. Anyway, glad I found PartSelect and that it was a relatively easy fix, even for those without tools and experience. A am a retiree, so don't feel you can't do it. Thank you so much PartSelect. Read more...
Your Price
$6.24
SPRING LATCH DOOR
PartSelect Number PS230719
Manufacturer Part Number WB09X10017
Fixes these symptoms
- Door not closing properly
- See more...
Your Price
$28.24
SPRING
PartSelect Number PS8754121
Manufacturer Part Number WB10X21028
Fixes these symptoms
- Door not closing properly
- See more...
Your Price
$6.24
Your Price
$7.76
Spring
PartSelect Number PS11742286
Manufacturer Part Number WP4158178
Door open button spring.
Fixes these symptoms
- Door stuck closed
- See more...
Your Price
$6.24
Your Price
$6.24
Louver Spring
PartSelect Number PS951725
Manufacturer Part Number WB01X10246
Installation Instructions
Ronald from Murphys, CA
Vent over top of microwave wouldn't close
I found the replacement parts by the drawings on the website. The drawings are excellent and very easy to follow. Ordered what I needed and read the previous comments to see how to dismantle the vent and replaced the part. It was slot simpler than expected. Thanks to part select for a great experience.
Read more...
Brands
- Bosch Microwave Springs and Shock Absorbers
- Electrolux Microwave Springs and Shock Absorbers
- General Electric Microwave Springs and Shock Absorbers
- Jenn-Air Microwave Springs and Shock Absorbers
- Kenmore Microwave Springs and Shock Absorbers
- KitchenAid Microwave Springs and Shock Absorbers
- Whirlpool Microwave Springs and Shock Absorbers
