Whirlpool Microwave Springs and Shock Absorbers

Your Price

$14.25

Whirlpool Microwave Interlock Spring

★★★★★

2 Reviews

PartSelect Number PS1964350

Manufacturer Part Number W10156812

Fixes these symptoms

Door not closing properly
Won’t turn on
See more...

Installation Instructions

Mark from HOMER GLEN, IL

Door switch inconsistent operation for Open/Close sensing.

Ordered top & bottom micro-switches and mounting plate parts. Internet reviews could not find specifics if the issue was due to a top/bottom or combination of micro-switch or mounting plate failure. Pulled the plug. Removed the top vent assembly cover held in by 2 Phillips screws inside the vent. Removed the control panel held in by 1 Phillip screw at the top vent assembly area. Lifted control panel upward to release the catch and moved it off to the side - didn't disconnect any leads. Used a Torx bit to remove the door switch mounting plates at the front and pulled the plates through the opening from the control panel. Documented the wire color code connections, the top plate uses 2 micro's with one using both the closed & open contact. Installed the respective micros on the mounting plates and worked backwards with the wiring and removal steps. Once completed, the open/close sensing has worked every time. Read more...

Your Price

$10.23

Whirlpool Microwave Spring

PartSelect Number PS11742286

Manufacturer Part Number WP4158178

Door open button spring.

Fixes these symptoms

Door stuck closed
See more...

Your Price

$8.17

Whirlpool Microwave Spring

PartSelect Number PS3524603

Manufacturer Part Number 4970WRA001B

Fixes these symptoms

Door not closing properly
See more...

Your Price

$7.36

Whirlpool Microwave Spring

PartSelect Number PS3525457

Manufacturer Part Number 4B72023A

Installation Instructions

LESTER from FOREST HILLS, NY

not all control buttons worked, including button for the light under the microwave

1.Disconnected microwave from power 2.Put spring into middle round opening of the button compartment 3.Snapped in new button. So far 20 second job! 4. Removed front control panel from the microwave. Located Micro Switch,(on the left side connected with two snap-in wires).Pull out wires, pull out the switch. Replaced faulty switch with the new one. Snapped in two wires. Very easy. However, need short 2" philip screwdriver to be able to unscrew screw holding the old switch. Few minutes job! 5. Attached front panel. 6. Connected microwave back to power. Problems gone all work fine. Read more...