Whirlpool Microwave Filters

Whirlpool Appliance Parts
Shop By Part Type

Popular Whirlpool Microwave Filters

Your Price
$14.64
  On Order
Charcoal Filter
★★★★★
★★★★★
(26)
PartSelect Number PS1871363
Manufacturer Part Number 8206230A
This Charcoal Filter traps grease from your oven's exhaust to help prevent it from entering the vent, which could cause damage over time. If the exhaust fan on your microwave is not working, you may need to replace your charcoal filter. This charcoal filter is located within the intake grille of your microwave, which will need to be unscrewed and opened to gain access to the filter. The manufacturer recommends that you change your charcoal filter every six months. This filter measures 5 inches by 5.375 inches by 0.375 inches. Be sure to measure your current filter to assure correct replacement. This product is sold individually. We recommend the use of gloves during installation to protect your hands from messy grease during your repair. You should also unplug your appliance at the electrical outlet or switch it off at the breaker. Using a Phillips screwdriver, unthread the screws securing the grill. Open the door and slide the grill to the left and lift it up to remove it. This will allow access to the filter so it can be either replaced or cleaned. Remember to insert the tabs of the grill into the frame and slide it to the right when you are done. To finish, shut the oven door and secure the grill with the screws.
Fixes these symptoms
Installation Instructions
Richard from San Antonio, TX
Mounting brackets are fragile and plastic support is easily broken
Replaced the intake grille. The grille should be removed prior to cleaning. The entire part is plastic and easily broken so that the two tabs for the mounting screws are shattered and will not hold the part in place. If one attempts to clean the grille using only a moderate amount of pressure with a cloth the fragile plastic will break. The part is poorly designed. When the vent is removed to replace the charcoal filter, one may discover that the grille has already been broken in a previous cleaning operation. Read more...
Your Price
$20.10
  In Stock
Grease Filter
★★★★★
★★★★★
(42)
PartSelect Number PS3650910
Manufacturer Part Number W10208631A
This Grease Filter is constructed of Acrylonitrile Butadiene Styrene and is used to trap grease and help eliminate odors from the exhaust air while cooking. It attaches onto the exhaust and is rated as easy to install. The part is 12 15/16" x 5 3/4", and comes in silver. Refer to your make and model number to ensure this part is right for you. If the exhaust fan of your appliance is not working, this part is the most likely cause. This part is sold individually, and it should be noted that many microwaves require two filters, so you may need to replace both at the same time by purchasing two of this part. You should consider gloves during this simple repair (which requires no tools) to save yourself from getting greasy hands.
Fixes these symptoms
Installation Instructions
Mark from SCHAUMBURG, IL
Dirty filters
Remove top grill assembly and replaced filters,parts were delivered on time and fit as expected, Job well done! Read more...
Your Price
$21.55
  In Stock
Charcoal Filter
★★★★★
★★★★★
(14)
PartSelect Number PS1957304
Manufacturer Part Number W10120840A
The charcoal filter, used in microwaves, removes food odors from the air. If your filter is damaged or you notice strong odors coming from your microwave, it is best to replace it. This part is metallic and measures about 12 inches wide and 6 inches deep. The tool required for this repair is a Phillips screwdriver. First, remove screws at the top of microwave to access the filter. Next, remove the old filter and insert new filter by pushing it all the way back, so the edges connect to the two tabs. The front edge of the filter should rest at the bottom of the cavity. Do not forget to replace the grill after installing new filter. Remember to unplug your microwave from the power source before installation process.
Installation Instructions
duane from san diego, CA
Fire in microwave melted several parts
Remove the filters and use a Torx driver to remove two screws holding the motor. The wires on on the motor are held in place by a plastic clamp that must be pried open on one side. That's all it takes to replace the drive motor. Everything else that makes the turntable spin lifts off from inside the microwave. Read more...
Your Price
$23.55
  In Stock
Grease Filter
★★★★★
★★★★★
(11)
PartSelect Number PS1847969
Manufacturer Part Number 6802A
If the microwave exhaust fan is not circulating air properly, there could be an issue with the grease filter. A dirty filter will cause your microwave to run less efficiently and can alter the taste or smell of your food. Filters should be changed every six months for maximum performance. These silver, aluminum filters are sold separately, and are approximately 13 3/8 inches long x 5 7/8 inches wide. Measure your current filter to assure correct replacement. Check your grease filters regularly for particles and grease buildup to see if cleaning is necessary. If there is any visible damage to the filter, it should be replaced straight away.
Fixes these symptoms
Installation Instructions
Joseph from Las Vegas, NV
Dirty Grease Filter
Slide grease filter about 1/2 inch to right (or left) using the d-ring attached to one side and then pull down and out. Push charcoal filter frame slightly to rear and pry down from front. Install new charcoal and grease filters by reversing process. No tools - 5-minutes max!! Read more...
Your Price
$23.55
  In Stock
Grease Filter
★★★★★
★★★★★
(8)
PartSelect Number PS1957060
Manufacturer Part Number W10113040A
This grease filter, used in microwaves, can be located underneath the microwave. The filter traps grease from the exhaust air and removes it from the air stream. This helps prevent grease sticking to the inside of the exhaust hood. Please note that most microwaves require two grease filters and they are both sold separately. This is an easy replacement done by simply pulling out old filters and sliding in the new ones. For further instructions and guidance, refer to the manual provided by the manufacturer. Unplug the microwave from the power source before starting this installation.
Installation Instructions
M. Rose from Miami, FL
The grill-vent broke and the grease filters needed to be replaced.
I simply placed the grill-vent in hood area, pulled out the dirty grease filters and slid in the replacement ones. Read more...
Your Price
$17.51
  In Stock
Grease Filter
★★★★★
★★★★★
(3)
PartSelect Number PS1871362
Manufacturer Part Number 8206229A
This filter collects grease particles in the air from cooking. Sold individually.
Installation Instructions
Myra from WATERFORD, ME
when putting my grease filter back in place it dropped behind my stove.
I placed a thick towel by the opening at the top of my stove and was able to fit the new grease filter in with no problem Read more...
Your Price
$22.75
  In Stock
Air Filter
★★★★★
★★★★★
(1)
PartSelect Number PS1957303
Manufacturer Part Number W10120839A
Sold individually.
Installation Instructions
Papkin from Glendale, CA
Surface lights and filters needed replacement
By pulling the filter screens units down and out with a pair of pliers I had access to the surface lights. Pulled the lights out of their sockets and replaced the bulbs. Real easy. Since the filter units were out, replaced the filters and reinstalled the filter units. The whole operation took less than 15 minutes. Read more...
Your Price
$23.55
  In Stock
Grease Filter
★★★★★
★★★★★
(5)
PartSelect Number PS8769987
Manufacturer Part Number W10535950
INCLUDES ONE FILTER
Your Price
$21.55
  In Stock
Charcoal Air Filters
★★★★★
★★★★★
(14)
PartSelect Number PS382960
Manufacturer Part Number 6800
The charcoal filter is used in microwaves to remove food odors from the air. If your filter is damaged or strong odors are coming from your microwave, it is best to replace this part. The only tool needed for this repair is a Phillips screwdriver. First, remove screws at the top of microwave to access the filter. Next, remove filter and insert new filter by pushing it all the way back, so the edges hit the two tabs. The front edge of the filter should rest at the bottom of the cavity. Make sure to replace the grill after installing the new filter. Remember to unplug your microwave from the power source before the installation process. This part is metallic and measures about 12 inches wide and 6 inches deep.
Fixes these symptoms
Installation Instructions
Joseph from Las Vegas, NV
Dirty Grease Filter
Slide grease filter about 1/2 inch to right (or left) using the d-ring attached to one side and then pull down and out. Push charcoal filter frame slightly to rear and pry down from front. Install new charcoal and grease filters by reversing process. No tools - 5-minutes max!! Read more...
Your Price
$16.25
  In Stock
Grease Filter
★★★★★
★★★★★
(8)
PartSelect Number PS364628
Manufacturer Part Number 4358853
This is a vent hood grease filter manufactured for a variety of microwave models. It is made entirely of metal with a built-in tab for easy installation and removal. The vent hood filter collects grease particles that are in the exhaust air from cooking. Be sure to keep your filter clean. A clogged or dirty filter is a fire hazard and can cause your appliance to run inefficiently. This filter is approximately 7.5 inches wide and 5 inches deep. This replacement part is a genuine OEM part, is sourced from the original manufacturer, and is sold separately.
Installation Instructions
Audrey from White Plains, NY
I Had A Hard Time Finding This Filter
I pulled out the old filters and just put in the new ones with ease, it was that simple. No screws was needed. Read more...

Related Parts