Electrolux Range Sensors

Videos!

Your Price

$57.15

Electrolux Range Temperature Sensor

★★★★★

53 Reviews

PartSelect Number PS1528542

Manufacturer Part Number 316490000

This genuine OEM oven probe is also known as an oven temperature sensor or range probe. This part is manufactured for a range, stove, or oven to detect the temperature within the oven cavity. The probe allows the oven to maintain the set temperature by sensing the temperature and sending the information to the ovens motherboard. You may need to replace this part if oven is not heating or is heating unevenly. Be sure to disconnect power to oven before replacing, as it is an electrical part. Tools needed are 1/4 inch nut driver and needle nose pliers.

Fixes these symptoms

Element will not heat
Gas igniter glows, but will not light
Little to no heat when baking
See more...

Installation Instructions

Tim from ASHAWAY, RI

oven did not heat up

Replaced the probe because that's what this site recommended.The oven still does not heat up. Read more...

Your Price

$53.85

Electrolux Range Temperature Sensor

★★★★★

9 Reviews

PartSelect Number PS11758156

Manufacturer Part Number 5304504897

The temperature sensor, also known as an oven probe, helps measure the temperature within the oven cavity. If your oven is too hot, not heating evenly, has little to no heat when baking, or flashing F3/F4 error messages on your control board, you may need to replace this part. This part measures 6" long and is made of metal. Please make sure to disconnect the power to your oven range before starting this repair. This temperature sensor is a genuine OEM part.

Fixes these symptoms

Element will not heat
Little to no heat when baking
Oven is too hot
See more...

Installation Instructions

Ronald from NEVADA, MO

Top oven overheating

Have a double wall oven and the top oven would not shut off or broiler part would stay on and burn tops of food. Since bottom oven was not having any issues felt like it could
Not be control panel so decided to try the temp sensor. Since replacing oven has worked properly. Read more...

Videos!

Your Price

$62.65

Electrolux Range Temperature Sensor

★★★★★

22 Reviews

PartSelect Number PS820208

Manufacturer Part Number 316217002

The oven temperature sensor for your range may also be called a probe. The quick connect on this part may differ than your original piece. If the temperature sensor does not fit you will have to cut off the quick connect, and then wire together with porcelain wire nuts. The function of the oven temperature sensor is to measure the temperature in the oven and signal the other heating components. Before you begin this repair make sure to disconnect the power to the range. The tools required for this installation include a number two Phillips screwdriver or a number two square head screwdriver, and maybe a pair of wire strippers and crimpers.

Fixes these symptoms

Element will not heat
Little to no heat when baking
Little to no heat when broiling
See more...

Installation Instructions

Dan from Bellevue, ID

Oven not heating to desired temperature

Replaced clock control by removing surface burner control knobs and plastic nuts, and then the cover over the oven control. Two screw hold the clock in place, after removal and disconnecting the plug-in you can reinstall the new clock control. The Heat Sensor inside the oven will also need to be replaced. It is located inside the oven and attached with two screws; the back of the oven will need to be removed to unplug. Reverse removal procedure and turn the power back on to the stove. Read more...

Videos!

Your Price

$68.15

Electrolux Range Oven Temperature Sensor

★★★★★

7 Reviews

PartSelect Number PS1528543

Manufacturer Part Number 316490001

The temperature sensor detects the temperature within the oven cavity. If there is a limited amount of heat, it is not heating evenly, or the oven will not start, this might indicate that your temperature sensor requires a replacement. If you are working with your oven this part is found on the right side when facing the back of the oven. This part is can be found in a range, wall oven, and microwave-oven. You will need to remove the panel located on the back of the oven, unplug the sensor, remove the screw, and pull the sensor out. The new one slides into place.

Fixes these symptoms

Element will not heat
Little to no heat when baking
Oven is too hot
See more...

Installation Instructions

Russell from Lake Havasu, AZ

Above 400 beeper went off & code numbers came up on read out

Cut off power at fuse panel. pulled stove out from wall went behind stove removed back panels in area of sensor that I could see from the front side, inside oven. Located sensor from rear & unpluged senser from wiring bundle reached inside oven & removed screws from sensor. Pulled sensor out & threaded wire through hole. Took old & new sensors to bench in shop. Plug on new not the same as old. Had to change plug Cut and stripped wires. Wire is very small, need to use a good stripper. Twisted wire together & soldered connection, used shrink wrap to insulate wire. Took part inside and reinstalled in reverse order. Used 1/4 inch nutdriver on total job start to finish. Read more...

Your Price

$86.02

Electrolux Range Meat Probe Sensor

★★★★★

3 Reviews

PartSelect Number PS11757868

Manufacturer Part Number 5304504202

This meat probe sensor is an authentic manufacturer replacement part for cooking appliances that have a built-in meat probe feature. It is plugged into the receptacle assembly for use inside the appliance. The sensor measures the internal temperature of meat during the cooking process and sends the readings to the control panel where they can be viewed in real time. This ensures that the food is cooked to your desired level of doneness. Over time the internal sensor components may become faulty or the probe can fail due to mechanical damage resulting in inaccurate temperature readings, and failure to communicate with the control panel. Follow the sensor cable to the insertion point in the oven cavity and disconnect the faulty sensor. Install the new sensor into the insertion point and reattach the connectors to complete the repair.

Installation Instructions

john from PITTSFIELD, MA

Original Meat Probe insulation separated on the probe end

I searched the web for a replacement and Parts Select had a picture and part number for the exact same probe. I ordered the probe and it arrived very quickly. The problem was that the probe I received didn't match the picture as shown on the web site. Instead I received a probe that was a different color and the actual probe was about 2" shorter than the one I was replacing. I called customer service and was told that the probe I received was the new version that the older version was discontinued. If they had updated their pictures on the web site I would not have ordered the probe. Parts Select customer service did apologize for the issue and offered to have me return for a refund.

I will order from Parts Select but I will call first to verify that the item pictured is the actual item being shipped. Parts Select please update the part pictures to show the actual items being sold. Read more...

Your Price

$87.11

Electrolux Range Probe

PartSelect Number PS11728445

Manufacturer Part Number 5304503737

Introducing the genuine Frigidaire PROBE, MEAT TEMP, BLACK - a robustly designed tool crafted for several Frigidaire, Electrolux, White Westinghouse, and Tappan models. This meat probe ensures the precise measurement of internal temperature of meats during cooking, thus enabling you to attain accurate results every single time. The size and shape of this practical accessory are tailored to fit your appliance perfectly; however, do verify the part number for your specific model before securing your purchase. Follow your owner's manual to get this part installed correctly. This meat probe is your essential cooking companion, catering to all your meat temperature measurement needs effectively. Discover the joy of exactness in culinary pursuits with the reliable and user-friendly Frigidaire meat probe.