Electrolux Range Igniters

Your Price

$44.24

Electrolux Range Flat Style Oven Igniter

★★★★★

67 Reviews

PartSelect Number PS470129

Manufacturer Part Number 5303935066

This is a flat style oven igniter used to light the oven burner in a gas range. When the element in this igniter glows white hot, the gas is released from the safety valves, which lights the oven burner. If your range is not heating properly, or not heating at all, it might indicate a problem with this part. If the element in the igniter is only glowing red or orange, or not glowing at all, it will need to be replaced. This is a shorter style igniter. It is 3.72 inches in length, and it features an 18-inch wire lead. This kit includes the igniter, an instruction sheet, a mounting bracket, and the two ceramic wire nuts needed for installation. This part has an amperage range of 3.2 to 3.6. Unplug your appliance before you start any repair work.

Fixes these symptoms

Element will not heat
Gas igniter glows, but will not light
Gas smell
See more...

Installation Instructions

John from Darlington, SC

Oven quit heating.

After reading up on the problem of the gas oven not lighting I decided I needed to install a new igniter. I had read where some people just pulled a panel off the back and installed a new one.. yeah, no such luck with this model so I had to crawl into the broiler drawer space [which I had to clean out first]. Note, if you wear trifocal glasses you might as well close your eyes and replace it by feel because there is no way to tilt your head back enough to see what you are doing and still get both arms and your chest in a broiler. Also be sure to remove all cats and dogs from the area before starting. They seem to think they can help or it's a game of hide and seek and they want to hide with you.. they were no help at all.
Other than that, it was quite easy. Read more...

Videos!

Your Price

$88.47

Electrolux Range Oven Igniter

★★★★★

35 Reviews

PartSelect Number PS2364063

Manufacturer Part Number 316489403

The oven burner igniter simply ignites the gas so it can heat the oven burner. The igniter does this by drawing electrical currents through the oven safety valve to open it. If the element shortens out, is no longer glowing, or is only glowing red or orange, replacing the igniter is the solution. You will need a wire splicing tool to do this repair. First, disconnect the wire harness from the igniter by removing the access panel on the rear of the stove. Next, access the front of oven and take out the racks before removing the bottom of the oven. For the rest of the installation instructions refer to the diagram provided by the manufacturer. Remember to unplug your oven from the power source before beginning this project.

Fixes these symptoms

Element will not heat
Gas igniter glows, but will not light
Gas smell
See more...

Installation Instructions

Sparky from ACCOMAC, VA

Stovetop worked, oven did not.

First, remove the warming drawer. This allows access to the igniter's plug. Unplug the igniter. The rest of the job is performed within the oven. Remove the bottom (1/4 inch socket). Then remove the next, v shaped piece. The igniter is bolted to the aerator. Remove bolts, and it pulls right off. Reverse these to install new igniter. Read more...

Your Price

$76.95

Electrolux Range Ignitor Bake

★★★★★

16 Reviews

PartSelect Number PS17219382

Manufacturer Part Number 5304534663

This gas oven bake igniter is designed to initiate the heating process by activating the burner during baking cycles. It functions by heating up until it reaches the ignition point, allowing gas to ignite and maintain consistent oven temperatures. A failing igniter is a common cause of heating issues, including longer preheat times, uneven baking, or complete failure to heat. Replacing the igniter restores proper oven function and ensures reliable performance. Installation should be performed with the appliance disconnected from power and gas supply for safety.

Fixes these symptoms

Element will not heat
Gas igniter glows, but will not light
Gas smell
See more...

Installation Instructions

Debbie from Rockford, MI

Oven wouldn't heat - broiler and burners worked fine-Bake Burner Igniter didn't work

It was the week before Thanksgiving and we didn't know what to do without an oven. I did some research on Google and of all the websites out there, I found a decent price here at Parts Select and ordered it on Friday. I was shocked when FEDEX pulled up to the door on Saturday afternoon. I went online to youtube and found a step by step video specifically for this part. It's posted by the Repair Clinic. http://www.youtube.com/watch?v=cLxKoF16gac. I was able to fix the part and probably saved at least $150.00 for a service call and repair time. The part cost about $90 and I was done in less than 15 minutes. We just got this stove about 2 years ago and I'm thinking maybe we could have saved my old stove since it had the same problem. Great job Parts Select - I got just what I needed and saved a ton of money in the process. Thanks also for their great informative video online. We had a great Thanksgiving and were very thankful for all our hot food fresh from the oven. Read more...

Your Price

$74.05

Electrolux Range Igniter, Broil

PartSelect Number PS12584919

Manufacturer Part Number 5303935059

This is an OEM broil igniter, which works with ranges.

Fixes these symptoms

Gas igniter glows, but will not light
See more...

Installation Instructions

Edward from NORWOOD, PA

Replace igniter

New part needed to be spliced to old connector with porcelain wire nuts then removed lower oven drawer to access the connection for igniter Read more...

Videos!

Your Price

$79.68

Electrolux Range Broiler Igniter

★★★★★

3 Reviews

PartSelect Number PS11770500

Manufacturer Part Number 5304506545

This igniter has a short wire harness. The wire length is approximately 6 inches long.

Fixes these symptoms

Gas igniter glows, but will not light
Little to no heat when baking
Will Not Start
See more...

Installation Instructions

Mike from PROVO, UT

replace bad oven ignitor

Oven ignitor is on the bottom gas unit. Ignitor is in oven and plug is in warmer oven on left wall at very back of warmer oven. It has duel function to light both upper and lower gas burners (in oven). Wires of new plug that I received were shorter than existing wires and would not reach the plug from ignitors center mount location to plug at far back of warming unit on left wall. Even if the wires would have been long enough, I couldn't figure out how to "release" the existing plug. Easy solution: Cut old wires at junction of old ignitor (leaving wires as long as possible). Cut new wired as close to new male plug as possible (leaving wires as long as possible on new ignitor). Strip ends of old and new wires and wire nut with porcelin wire nuts (hardest part of job was locating porcelin wire nuts)! After placing wires out of the way of burner and ignitor, reassemble stove parts. AVOID touching new element as oil from hands will decrease the life of the element. Good Luck.. Read more...

Your Price

$66.25

Electrolux Range Spark Ignitor

★★★★★

1 Review

PartSelect Number PS11728608

Manufacturer Part Number 808608802

The function of the ignitor in your range is to create the spark that ignites the gas on the burners. If your spark ignition system is not functioning properly, you may need to replace the ignitor. This part is approximately 3 inches in length. The ignitor is located in the rear of the range, so you will need to remove the back panel in order to access it for this repair. Before beginning this repair, be sure that the gas valve for the range is shut off. You should also disconnect the power source to the range before you begin.

Fixes these symptoms

Will Not Start
See more...

Installation Instructions

Colin from MORGANTOWN, WV

Stove pilot not clicking on any burner, oven works fine

Unplug the range. Remove screw to Take of the back panel on upper right corner. Unclip the old spark module, unplug the wires with the needle nose pliers and plug them into the new spark module same as the old module. Clip it on. Replace the back panel. Read more...

Your Price

$86.44

Electrolux Range Front Burner Igniter/orifice Assembly

★★★★★

3 Reviews

PartSelect Number PS2332312

Manufacturer Part Number 316237805

This igniter and orifice assembly is a legitimate OEM replacement part for your gas stove, and includes the igniter, orifice assembly, and gas tube. This part may need replacing if the igniter fails or the tube is leaking gas. It is a very easy repair. Remove the grates and burners from the range. Unscrew the existing assemblies and pry off the cooktop. Locate the assembly you are replacing and undo the nut holding it in place. Pull out the igniter wire by hand, and install the new one, replacing the rest of the parts in reverse order.

Fixes these symptoms

Element will not heat
Gas igniter glows, but will not light
Gas smell
See more...

Installation Instructions

Steve from NORTH PEKIN, IL

the new burners had no threads for the screws

had to use a tap and cut new threads. Also had to remove the top of the range, and the metal cover under the top. Read more...

Your Price

$120.18

Electrolux Range Surface Burner Igniter And Orifice Holder - Rf 17k

★★★★★

1 Review

PartSelect Number PS2368573

Manufacturer Part Number 316536622

This range surface burner igniter and orifice holder assembly is designed for use on a gas range and is commonly positioned at the right-front burner, often the high-output cooking zone. The assembly combines the igniter electrode and gas orifice to regulate fuel flow and generate a spark, producing a strong, consistent flame rated at 17,000 BTUs for reliable high-heat cooking. Constructed from heat-resistant metal, it is typically replaced when a burner will not ignite, no longer clicks, produces a weak or uneven flame, or shows visible damage such as cracks or carbon tracking on the electrode. Installation generally involves shutting off the gas supply and power to the appliance, removing the burner components, and securing the new igniter and orifice holder in place to restore proper burner ignition and flame performance.

Installation Instructions

James from RACINE, WI

Easy

Repair was east but the price I paid through you was 3 times what I found elsewhere. I made a mistake ordering through your expensive company Read more...