MDB9150AWQ Maytag Dishwasher - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
old guide rails split in half
placed new guide rails on upper racks and clicked them closed.
Parts Used:
-
Judith from New City, NY
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
broken bottom on silverware basket and broken hinge on rack
I removed old hinge and snapped in new one.The new basket was identical to the original and PartSelect.com was the only source I found that had it in stock. I took the old handle off the broken basket with a screw driver and snapped it in place on new basket, job done.
Parts Used:
-
Richard from Essexville, MI
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Used Dishwasher In Our Condo Had No Silverware Basket.
Ordered silverware basket, placed into the proper position. Easy as pie.
Parts Used:
-
James from Anaheim, CA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Old parts had worn out
Replaced and repaired in less than five minutes using No tools
Parts Used:
-
John from Mission Viejo, CA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
hole in spray diverter
just put the three parts together . I had the old parts to go by .
You have a terrific web site for research into exact parts needed for any appliance Keep up the good work !
You have a terrific web site for research into exact parts needed for any appliance Keep up the good work !
Parts Used:
-
george from atkinson, NH
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
old spray arm broke
held spray arm to arm connector and replaced snap retainer, works like a new machine
Parts Used:
-
Phyllis Van from LODI, WI
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Replaced silverware basket. No problems!
Lifted out old silverware basket. Set new basket in. Took approximately 20 seconds.
Parts Used:
-
Janet from STURGIS, KY
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Wheel axle had broke and the wheel was not connected.
-
Jeff from BURLINGTON, WI
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
upper spray arm won't stay attached to dishwasher ceiling
remove damaged retainer clip. Install new one. Note: the upper spray arm screws onto the ceiling of the dishwasher with a reverse thread. That is, you need to turn it counter-clockwise to tighten it.
Parts Used:
-
Mark from MILPITAS, CA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Replaced wheel on rack
-
Lane from ITASCA, IL
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Upper rack rusted with many missing tines.
Remove the old rack and slip in the new one. Took 5 min to figure out how to remove the upper rack. Now have "new" dishwasher. Great service by PartSelect.
Parts Used:
-
Robert from Ashland, MA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
2 of 4 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The spray diverter assembly came off and was locater under the rack next to the heating element - heat melted the plastic diverter and lid
My nephew actually put the new part back on for me. The main problem I had was getting both parts of the diverter ordered at the same time. I had to order the lid after the diverter came in the mail! I did not realize it was a two-part replacement piece. I learned later that the lid was a separate part.
Parts Used:
-
Doris from CONCORD, NC
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Some of bottom wire in the silverware basket had rusted out allowing silverware to fall through and interfere with rotating arm.
The "repair" was actually a replacement. My wife did it. She took out the old, damaged basket and dropped in the new, replacement basket. She removed the slotted lids because she doesn't think they are necessary and she doesn't like them. I got the old basket for holding small items in my workshop. The lids will be thrown away, unless I can come up with a use for them.
Parts Used:
-
William from MARBLEHEAD, MA
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Our utensil basket had holes in the bottom and silverware fell through.
-
Steve from Shoreline, WA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
plastic in silverware basket cracked so utensils kept falling through/getting stuck
The basket did not include the handle (something I didn't notice when I ordered it). I simply removed the handle from the old basket and placed it on the new basket.
Having utensils falling through was really getting old. This was $25 well spent.
Having utensils falling through was really getting old. This was $25 well spent.
Parts Used:
-
Alan from Ballwin, MO
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!