MDB9150AWQ Maytag Dishwasher - Instructions

I pulled the unit out its bay and saw that one spring was missing. I looked up the parts online and ordered replacement springs and linkages. Using the existing spring and linkage as models, I easily installed the new parts. I ordered spare parts in case the other linkage broke.

I placed the distributer cap on and tightened with the housing nut and snapped the cap on and it was fixed. Very easy, no tools involved.

popped the two end caps off of the runners (the hardest part of the installation was figuring out how to pop them without braking them). Turns out just using a flat screw driver to start opening the cap lock did the trick. Once the end caps were off it was just a matter of rolling the old one off and the new one on and then putting the end caps back on.

The new basket wasn't an exact match, it's lighter weight and doesn't have the exact same configuration as far as the rows of tines. This will do us fine until it's time to replace the unit.

Open the door and remove old basket. Place the new basket in its plave. Time elapse approximately 20 seconds

Just replaced with new basket. Fit like a charm!

Took old one out And placed new one in dishwasher.

opened door---- took out old basket--threw it away. set new basket in its place!!!!

watched the video instructions and followed them. ;Very easy.

Very simple. Just replaced the old one with the new one. Voila!!!

removed the 2 stops that held in the upper basket. rolled the old one out and slid the new one in. the replaced the stops. cake and pie!!

No Tools Required! unclip the end caps of the slide rails, slide the upper rack out of the dishwasher. Remove the broken Wheel Mounting Strip from the rack and replace with the new unit. Re-assemble the rack into the dishwasher and re-fasten the end caps. Don't forget to get the appropriate accolades from your spouse!

Simply took old parts off and replaced them with new parts - no tools required.

Removed the handle from the old basket and put it onto the new basket. The new basket is great!

I asked my husband if I ordered the parts would he change them for me, and when they arrived, it looked so simple I did it myself. I removed the washer arm by unscrewing the disk that holds it in place. I took the metal heat deflectors off the old arm (they just easily pried off) and put them on the new. I lifted off the large round "plate" that the arm rests on and cleaned the underside. Then put it back together in reverse order.

I decided to do some regular maintenance on the dishwasher. The spray arm and components have been caked from our hard water and soap. I unwittingly broke the seal on a portion of the spray arm to try and clean. I did not know it was sealed, thought it could snap. The broken seal created a high pressure stream that pushed the door enough to let water leak out.

Replacing it was easy. Unscrewed the plastic nut, lifted out spray arm and disc, unsnapped arm from disc and replaced new one. Leak is now fixed. This part was much much cheaper than i imagined and brought new life to our dishwasher. Best.Store.Ever.