All Installation Instructions for General Electric Dishwasher GLDL500N10CC

Rack roller and JetDry cap were missing

Opened the package, opened the plastic parts bag, installed the roller and the cap.

Whew!

Parts Used:

Lower Rack Wheel Kit - 8 Pack

Rinse Cap Assembly

Michael from Cincinnati, OH
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

a couple of retaining ears were broken from the cover allowing the the switches and plunger to move out of place

took screws from inside door panel and replaced the cover taking care not to allow plunger and spring to pop out put panel in place and screwed down

Parts Used:

Interlock Cover

charles from royal oak, MI
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Dishwasher would only 'partially' drain; dishes needed more rinsing.

Called repairman: announced that the drain pump was gone. Did not seem right. Went to the website. Found what I was looking for. 49% of the time it was a check-valve issue; only 26% of the time was the pump the problem. Took the unit from under the counter; got it on its side; removed the drain pump. Found my first check-valve, but thediagram showed a second lower one toward the sump. Having located both and purchased two valves and and the lower holder piece, I was ready to finish the job. Quarter-inch nut driver and a screw driver and the valves were in and the drain pump re-installed. Most difficult in my case was getting the dw back into its spot and lashed down! Thanks for the good guidance!

Parts Used:

SEAT CHECK VALVE

Check Valve Flapper

James from SEDONA, AZ
Difficulty Level:
Easy
Total Repair Time:
1- 2 hours
Tools:
Nutdriver, Screw drivers, Wrench (Adjustable)

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

NONE

UNPACKED WHEELS AND CLIP. USING NEEDLE NOSE PLIERS SQUEEZED WHEEL TIP TO INSERT IN WHEEL. REMOVED OLD WHEELS AND RETAINER BY HAND. INSTALLED NEW WHEELS INSTALLED AND NEW RETAINERS

Parts Used:

Lower Rack Wheel Kit - 8 Pack

Edward from GRAND BLANC, MI
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers

3 of 5 people found this instruction helpful.

Was this instruction helpful to you?

Lost cap to rinse aid disoenser

Just screwed it on.

Parts Used:

Rinse Cap Assembly

MarilynNegri from BLAIRSTOWN, NJ
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

basket for silverware was broken

opened the box , new one was an exact fit, pulled out the old one and dropped the new one in place??, this is more of a review, the new part was the exact same one...perfect!

Parts Used:

Silverware Basket with Lids

Mary from Sykesville, MD
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Jet dry rinse cape destroyed.

Got the part the next day.. opened it and just screwed into place!
Easy as could be. Thank you!!

Parts Used:

Rinse Cap Assembly

Jessie from TYLER, TX
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Rinse aid cap leaking

Opened the door on dishwasher and installed the rinse aid cap. Checked for leaks. None found

Parts Used:

Rinse Cap Assembly

David from BURKBURNETT, TX
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Lower wheels kept falling off

Installed new lower rack wheel kit

Parts Used:

Lower Rack Wheel Kit - 8 Pack

helmut from EAST KINGSTON, NH
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

3 of 5 people found this instruction helpful.

Was this instruction helpful to you?

The soap dispenser would not close.

This was simple. I took the door apart with a portable screw driver. Then I detached the wires and unscrewed the old module and replaced it. I then put the door back together, loaded the dishwasher and it cleaned my dishes. Even for this `old dog' it was easy.

Parts Used:

Detergent Dispenser with Rinse Cap

tim from prior lake, MN
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Old parts showing wear

Watched a YouTube video on disassembly, parts replacement, and reassembly.

Parts Used:

Fine Filter

Fine Filter Hub Nut

Suzanne from CHEYENNE, WY
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Leaking from front

I removed the old gasket very easily as there wasn't even glue holding it in place. The new gasket just pressed right into a slot and makes a water tight seal.

Parts Used:

Tub Gasket

David from North Charleston, SC
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

3 of 5 people found this instruction helpful.

Was this instruction helpful to you?

Broken middle spray arm

Unscrewed the screw holding it in place and removed it, out the new one in place and screwed it on. Very quick and simple.

Parts Used:

Middle Spray Arm

Pamela from Bakersfield, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Wrench (Adjustable)

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Rollers and axles were worn out

Removed the stops at the end of the upper rack, removed the old rollers. Replaced with new rollers and installed the stops back in place. Very easy, finished in less than 15 minutes. Replacement rollers very much improved with design from the original rollers.

Parts Used: