Fine Filter WD12X10109

Hi Hollie, Thank you for the question, Sounds like you need to replace the Circulation Pump Impeller Kit. This pump is what sends the water to the spray arms to wash the dishes. If the water is not circulating during the wash cycle then the Circulation Pump may need to be replaced. Hope this helps!

Hello Luigi, thank you for inquiring. For this symptom you will want to replace either the Check Valve Flapper part PS258167, the Drain Pump part PS260804, or the Impeller and Seal Kit part PS259598. We hope this helps.

Hi Sterling, thank you for your question. It does sound like it would be the pump that is the issue. However if it is the sump, you could actually inspect that part to see if there are any blockages in it. From what you mentioned you did not see any, but if you wanted to take another look that would not hurt. The sump is more of like a physical housing part that helps direct water and holds other electrical parts. So if there is something wrong with it, that would be something that you could see physically. I hope that helps. Good luck with your repair.

Hi Cliff, Thank you for your inquiry. There are some parts that you will need to check to see which one is causing the issue. You will need to check the check valve flapper, the drain pump, the sump filter and housing, the sump, the circulation pump and impeller kit and the drain tub. I hope this helps. Thank you and have a great day!

Hi Joseph, Thank you for the question. It sounds like the water is not spraying or circulating within the appliance. First I suggest the spray arms You will need to remove them to see inside to see if there is anything built up and blocking the water from flowing through. If they are clear, you may need to replace the circulation pump, PartSelect Number PS3511326. Hope this helps!

Hello John, thank you for your question. If just the rinse aid cap was replaced, that would not fix the issue of the soap dispenser not opening. The whole dispenser assembly should be replaced, part number WD12X10163. If that was replaced and the issue is still happening the issue would be with the control board itself, part number PS783633. Unfortunately, that board has been discontinued by the manufacturer. Good luck with your repair!

Bonjour Annie, Merci pour la question. Vous devrez retirer le bras gicleur inférieur pour accéder au filtre. Vous devrez faire pivoter le bras dans le sens inverse des aiguilles d'une montre et le soulever. Si vous avez besoin d'aide pour passer une commande, le service client est ouvert 7 jours sur 7. N'hésitez pas à nous appeler. Nous avons hâte d'avoir de tes nouvelles!

Hi Ruth, thank you for reaching out. The fine filter, part number PS958919, is used to remove food particles and debris from the water to prevent the drain from clogging. It can be cleaned. We hope this information helps!

Hello Denise, thank you for the query. According to our research, we would recommend checking the water inlet valve, part number PS3654179, to fix the issue. We hope this helps!

Hello Doris, Thank you for your inquiry. Researching your model, if it does not seem to be filling on the wash cycling, we would recommend checking the spray arms for any clogs, and clean them with a wire brush to remove any debris from the holes. Check the water manifold at the back of the washer for any clogs. We would also recommend checking the water inlet valve and wash pump motor to see if they are starting to fail and not getting enough water to the upper spray arm. We hope this helps you.