Middle Spray Arm WD22X10046

Roger from SADDLEBROOKE, AZ
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver

1 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Dishes did not get clean

I watched the video, read the instructions and went to work. This was the easiest repair I have ever done. I'm 71 and if I can do all 3 spray arms in a total of 15 minutes, anyone can. The hardest part was getting up off the floor when I was finished. The spray arms were all clogged, we have very hard water.

Other Parts Used:

Dennis from ELOY, AZ
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Wrench set

5 of 5 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Lower spray arm falling apart, dishes not cleaned

This was very easy. 1) roll out lower rack, 2) rotate lower arm slightly counter-clockwise and lift it out, 3) install new lower arm by dropping into position and rotating clockwise. 4) roll in lower rack, and roll out upper rack, 5) use a nut driver to remove the retaining bolt/screw from the upper arm - it's in the center of the upper ... Read more

Read less

Other Parts Used:

David from Lincoln University, PA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver

7 of 10 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

dishes where not clean after washing

change the nozzles and filter

Other Parts Used:

Fine Filter

Daniel from Maurice, LA
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver

7 of 18 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Dishwasher wasn't cleaning properly

My dishwasher was doing a terrible job of cleaning. It was leaving food on dishes, and wasn't dissolving all the detergent. I replaced all the spray arms and the filter, as they seemed clogged, and god knows how old. It's a super easy repair, and the dishwasher now works as if it were brand new.

Other Parts Used:

Fine Filter

Taylor from Scotia, NY
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Wrench set

22 of 30 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Broken middle spray arm

Unscrewed the screw holding it in place and removed it, out the new one in place and screwed it on. Very quick and simple.

Pamela from Bakersfield, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Wrench (Adjustable)

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

the spray arm was off and without brackets

I looked at the diagram on the web site, the same one that I ordered from, and figured out how all the parts were suppose to go together. The spray arm has 2 brackets so it was a matter of aligning the tube that feeds the spray arm with the supply line on the back of he dishwasher. I had to move it once to get it properly aligned but foun ... Read more

Read less

Other Parts Used:

SCR B-16 HXW 1/2 Stainless Steel

Middle Spray Arm Hub

Middle Spray Arm Conduit Carrier

Joel from Temple, TX
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver

7 of 21 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Would not spray water or rotate

Took the old ones off and put the new ones in.

My water has a lot of calcium and the spray arms clog.
Second time in 3 years

Other Parts Used:

ken from crestwood, KY
Difficulty Level:
Really Easy
Total Repair Time:
1- 2 hours
Tools:
Nutdriver

3 of 9 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Diswasher wasn't cleaning the dishs because the spray arms were clogged with calcium deposits.

Replacement of the arms is very simple, the bottom arm pulls out after turning it counter clockwise, no tool needed. The upper arms need the use of a nut driver or simlar tool to remove the hex screws holding them to the water supply tubes. The hardest part of the repair will be removing the top dish tray. This requires twisting the door ... Read more

Read less

Other Parts Used: