KitchenAid Refrigerator Wheels and Rollers

Find your part

Enter your model number or a part number and click "Search"
Need help finding your model number?
KitchenAid Appliance Parts
Shop By Part Type

Popular KitchenAid Refrigerator Wheels and Rollers

Your Price
$42.50
  In Stock
Ice Auger Motor Shaft
★★★★★
★★★★★
(14)
PartSelect Number PS11739142
Manufacturer Part Number WP2188917
This part is the drive shaft for the auger.
Fixes these symptoms
  • Ice maker not making ice
  • Ice maker won’t dispense ice
  • See more...
Installation Instructions
terry from panama city beach, FL
ice would not drop
removed the shaft that had worn end-replaced with new one- ok now Read more...
Your Price
$28.90
  In Stock
Front Roller
★★★★★
★★★★★
(3)
PartSelect Number PS11738962
Manufacturer Part Number WP2166108
Sold individually. Hardware not included. Roller only.
Installation Instructions
Tony from Chicago, IL
Right front wheel broke
Definatly a two man job. I suggest you put a pad down to protect your floor. Remove the filter, grill, and bolts per instructions. Everything is straight forward. Move the frame back 1/2 to 1 inch then tilt the frig back on it's side about 4 inches. If the frame doesn't drop down, move it back until the front of the frame comes of the front lip of the frig. Place a block under the frig lip NOT the frame and WATCH YOUR FINGERS. The wheel should be hanging down. Just pull out the pin, replace the wheel (make sure you have it facing the correct way) and tilt back and pull the blocks. Move the frig back in place and replace the bolts. Took me and a buddy less than 30 minutes. Read more...
Your Price
$5.67
  In Stock
Single Roller
PartSelect Number PS11738235
Manufacturer Part Number WP10450603
This wheel is sold individually. It is located on the bottom of the refrigerator.
Installation Instructions
mike from holly springs, NC
Left front plastic wheel was broken
Pop loose the plastic grate at the bottom.

Locate and remove the wheel leveling screw from the front bottom corner.

Remove cotter pin from the pin that mounts the wheel assembly to the refrigerator. Tap out the mounting pin.

Lift out the wheel assembly.

Remove the Roller pin from the wheel assembly. I used a Dremel tool with a cutting disk. A hack saw will also probably work.

Install the new roller pin and wheel into the wheel assembly. Use a hammer or vice to peen over the end of the roller pin.

Reinstall and adjust wheel assembly. Read more...
Your Price
$50.93
  In Stock
Single Roller - Right Front
PartSelect Number PS11755875
Manufacturer Part Number WPW10515762
Sold individually.
Your Price
$47.49
  In Stock
Single Roller - Left Front
★★★★★
★★★★★
(2)
PartSelect Number PS11755876
Manufacturer Part Number WPW10515763
Sold individually.
Installation Instructions
Daniel from BOCA RATON, FL
Original bracket foot brake screw hole was stripped and foot brake would not extend
The repair seemed simple, I just needed to remove the old bracket -- 4 screws -- and slip the new one on.

The tricky bit is that the roller bracket holds the weight of the fridge. So in order to make sure that the fridge did not fall over, and to keep the installation point off the ground so that I could align the screw holes, I needed to shim up the side of the fridge that I was working on.

To tap in the shims, I used a hammer and a spare chunk of wood. I ultimately used 3 shims, and kept tapping until the roller wheel could roll freely. Then I knew that the fridge was high enough. After that, it was pretty easy to remove the 4 screws, align the new bracket, and replace the screws. After that, in order to get the shims out I could just extend the foot brake as it was designed, and that lifted the fridge enough for me to easily slide out the shims. After that I just had to level out the fridge by adjusting the two feet. Read more...
Your Price
$13.70
  In Stock
Roller Eyelet
★★★★★
★★★★★
(1)
PartSelect Number PS11738999
Manufacturer Part Number WP2174478
This roller eyelet is sold individually.
Your Price
$25.39
  In Stock
Axle
PartSelect Number PS11751309
Manufacturer Part Number WPW10257246
Sold individually.
Installation Instructions
Kent from OVIEDO, FL
Ordered new crisper pin for refrigerator
After finally getting the wright parts sent to me I took out old bin added the parts to the new bin slid it in and I’m done. Read more...
Your Price
$66.44
  On Order
Refrigerator Front Roller Kit
★★★★★
★★★★★
(2)
PartSelect Number PS370711
Manufacturer Part Number 4386774
Support wheel assembly with bracket. Kit of 2.
Installation Instructions
Jeff from Midway, GA
Front wheel was broken when moving refrigerator
Lifted the front up onto a scrap 2x4 to get it off the ground and it had 1 bolt that you removed to get the old item off and replace with new assymbly and 1 bolt to re attach. This sat broke for over a year becuase I thought it would be alot harder to fix, found the part on parts select ordered it recieved it in approx 2 days and had it fixed in less than 15 minutes. I would recommend parts select to anyone who told me that they had a appliance broken.
Thanks Read more...
Your Price
$23.92
  In Stock
ROLLER-CAB
★★★★★
★★★★★
(2)
PartSelect Number PS11755335
Manufacturer Part Number WPW10475495
Sold individually.
Installation Instructions
Hans from OGDEN, UT
Raise side of fridge and slide 2x4 under side with broken wheel.
Remove back side cardboard access cover. About 6 dcrews need to be removed. Remove 9/16” bolt and lower compressor tray frame down to slide out wheel axel. Place wheel in slot and replace axel. Lift compressor tray and replace 9/16” bolt. Replace cardboard cover. Remove 2x4. Read more...
Your Price
$30.90
  On Order
Rear Roller
PartSelect Number PS11751112
Manufacturer Part Number WPW10250570
Sold Individually.
Installation Instructions
chester from Tampa, FL
Compressor making excessive noise
One front roller was flat on one side. Decided to replace all rollers at same time. Placed shims under unit and removed mounting screws for one front and one rear roller. With new rollers in place, I was able to level the refrigerator side to side, but unable to do so, front to back. Left the new front roller in place and reinstalled the old rear roller. Have decided to replace refrigeratorin the near future. This is one of my few repair failures! Read more...

Related Parts

Back to Top