KitchenAid Refrigerator Brackets and Flanges

Your Price

$18.31

In Stock

Control Bracket

★★★★★

(97)

PartSelect Number PS11739027

Manufacturer Part Number WP2180226

This is a control bracket for your refrigerator, and may also be known as the dispenser control bracket. The function of this part is to hold the micro switches and the light socket in the freezer dispenser section in place. Its measurements are roughly 9 inches long and 5 inches high, and this model comes in white. The tools you will need in order to do this repair include a Phillips screw driver, a quarter-inch nut-driver, and a pair of needle-nose pliers. If your ice dispenser is not working properly, your bracket could be the problem.

Fixes these symptoms

Ice maker not making ice
Ice maker won’t dispense ice
Not dispensing water
See more...

Installation Instructions

BILL from BATESVILLE, MS

Front Door Ice Wouldn't Work And Air Going Into Freezer

Thanks to the pictorial diagram, I was able to order correct parts. It was just a matter of removal of broken parts and replacing them. Ice maker now working and air is no longer getting into freezer which was freezing up ice maker. Thanks for timely delivery, now I am able to use ice dispenser, which I haven't used for long time. Thanks Read more...

Your Price

$5.67

In Stock

Ice Maker Cover Bracket

★★★★★

(6)

PartSelect Number PS11739245

Manufacturer Part Number WP2198641

This is the replacement ice maker cover bracket for your refrigerator. It is made of white plastic and is approximately 5 inches wide and 2 inches long. The ice maker cover bracket holds and supports the ice maker cover. If the ice maker cover is loose or missing, you may need to replace the bracket. You will also want to replace the bracket if it will not stay in place, or if it is cracked or broken. To replace the cover bracket, simply remove the ice maker cover, then use a ¼ inch nut driver to loosen and remove the bracket. Screw in the new bracket and replace the cover to complete your repair. This is an OEM part that is sold individually.

Installation Instructions

brian from fresno, CA

broke tab on cover bracket

removed old bracket and replaced with new one - two screws and it was done - simple Read more...

Your Price

$5.67

In Stock

Holder

★★★★★

(1)

PartSelect Number PS11739144

Manufacturer Part Number WP2188919

Fixes these symptoms

Ice maker won’t dispense ice
See more...

Installation Instructions

Vincent from INDN HBR BCH, FL

Ice Maker Bucket would not rotate arm to dispense ice

This was a very easy repair. First, remove the Ice Bucket off the refrig door. Unfasten the white plastic shaft holder held in place by 2 hex head screws using a nut driver. Remove old shaft and insert the new shaft. Fasten back up with the holder and 2 hex head screws and install the ice bucket and you are ready to dispense ice again. Read more...

Your Price

$5.67

In Stock

Bracket, Dispenser

PartSelect Number PS11740253

Manufacturer Part Number WP2304673

Installation Instructions

Sean from Boise, ID

Water dispenser hose tip broken.

The part to fix this was a $50.00 part.
I purchased this Bracket Dispenser for $6.00 and it fit on My fridge perfectly. I just used the screw hole that was a little higher on the water dispenser. Simply cut off the broken end / or Buy a new Hose (Cost at Lowes about $6.00) guide hose along the bracket and use a socken set to reinstall the screw. Water is not squirting on people any more. Read more...