External Ice Guide Broke a Tooth and Fell Off
We waited two years to do this because we didn't want to hassle with a repair man to come out and charge us arm+leg for something so simple. Finally we searched and found the part on line. It came two...read more

Front Door Ice Wouldn't Work And Air Going Into Freezer
Thanks to the pictorial diagram, I was able to order correct parts. It was just a matter of removal of broken parts and replacing them. Ice maker now working and air is no longer getting into freeze...read more

Kitchenaid refrigerator shelf frames were cracking, needed replacement
I had to purchase two shelves and adjustable brackets - though I only needed the slidign glass shelves . Customjer service rep was helpful and pleasant, though the replacements shelves did not bear th...read more

Water dispenser not working, Ice dispenser chute icing up
I removed the outer ice/water dispenser cover following directions I found on-line (push down and gently pry out at the bottom). I then removed several nut-head screws which were holding a plastic pl...read more

Grille had permanent water marks
I discovered recently that the grille was removable. The protective coating had been removed because of using a scrub brush to remove hard water stains. It looked horrible and was very hard to keep ...read more

Ice wouldn't dispense from the door.
Simple. Removed the outer ice/water dispenser cover with two screws on the bottom, then removed the ice door mechanism and replaced the small sealing door and door motor. Reassembled and tested . W...read more

Water Dispenser Grille was stained with water minerals where water had evaporated over the years
Removed the old grille, replaced it with the new grille....read more

Lower hinge on door, watrer filter and ice/water tray
The notches that create the closing power on the lower hinge was worn out. A few bolts at the top of the door and it was off. One nut to hold the plastic hinge and it was on. Door works perfectly n...read more

Water dispenser got stuck on one function, couldn't get water to work
Removed two screws and took off water dispenser front panel. Unplugged wires to old control board and removed it from brackets holding it to inside of dispenser panel. Aligned and pushed new control (...read more