Jenn-Air Refrigerator Doors
- Search your model number to find:
- Genuine OEM parts guaranteed to fit
- Free manuals and guides
- Repair instructions and videos
Popular Jenn-Air Refrigerator Doors
Your Price
$9.40
In Stock
Jenn-Air Refrigerator Pivot Block
PartSelect Number PS11743531
Manufacturer Part Number WP67003405
This is a replacement pivot block for your refrigerator. It is made of white plastic and is approximately 4 inches long and 1 inch wide. The pivot block catches and holds the door mullion cover when you close the door. If your refrigerator door will not close properly, you may need to replace the pivot block. This part is sold individually and is an OEM part sourced directly from the manufacturer.
Fixes these symptoms
- Door won’t open or close
- See more...
Installation Instructions
Elijah from Killeen, TX
I had several broken appilances broken with parts to be replaced.
I had ordered the parts from Part Select and came with in a week. I ahd a Whrilpool microwave that had a door panel and vent grille that needed to be replaced and that was rplced with ease took less that five minutes to do. My Maytag refridgerator had it kickplate grille replace along with the pivot block that took all of about two minutes. The longest job that took about 5 minutes was my Whirlpool glass oven door that needed to be replaced, but that was pretty ease to replace also with an extra hand from my son. I just didn't want to break another glass door or I would have done it myself plus I was teaching him how to do self reparts.
Read more...
Your Price
$148.00
In Stock
Jenn-Air Refrigerator Vertical Mullion Rail - Black
PartSelect Number PS11738596
Manufacturer Part Number WP12722803B
Commonly referred to as the flapper assembly, the door mullion is an important part of a double, or triple door refrigerator.
Fixes these symptoms
- Door Sweating
- Door won’t open or close
- See more...
Installation Instructions
Don from Alpine, TX
Broken Rail-Mullin
The mullin requires only one screw removal, then LIFT the entire mullin upwards. Pop the wire harness loose, and replace with new mullin. Simple job,
Read more...
Jenn-Air Refrigerator Verticle Mullion Rail - Apollo Gray
- Remove the screw from the center hinged cover.
- Remove the mullion rail by pushing upward. The top and bottom hinges slide over tabs attached to the door. I had to bump it gently from underneath.
- Disconnect the three wire connector that's underneath the center hinged cover.
Install the new mullion rail by reversing the above steps:
- Connect the three wire connector and snap it into its holder.
- Slide the new part over the top and bottom hinges. Be sure that all three hinges are correctly lined up before sliding the rail over the tabs.
- Push it down far enough that the hole for the screw in the center cover is lined up with its corresponding receptacle in the door.
- Replace the screw. Read more...
PartSelect Number PS11738595
Manufacturer Part Number WP12722803AP
The vertical mullion rail with a built-in mullion heater creates a tight seal between the doors of a French-door refrigerator. This helps prevent air leaks and excess moisture buildup. If you notice condensation or an improper door seal, replacing the mullion rail can help restore efficiency. Always disconnect power before installation and ensure compatibility with your model.
Fixes these symptoms
- Door won’t open or close
- See more...
Installation Instructions
Michael from FALLBROOK, CA
When right hand door was opened first, and then left hand door, the mullion rail did not move all the way to the "open" position so that if the left hand door was closed after the right hand door the rail would bang against the right hand door and not close all the way until manually pushed into pos
Remove the existing mullion rail:- Remove the screw from the center hinged cover.
- Remove the mullion rail by pushing upward. The top and bottom hinges slide over tabs attached to the door. I had to bump it gently from underneath.
- Disconnect the three wire connector that's underneath the center hinged cover.
Install the new mullion rail by reversing the above steps:
- Connect the three wire connector and snap it into its holder.
- Slide the new part over the top and bottom hinges. Be sure that all three hinges are correctly lined up before sliding the rail over the tabs.
- Push it down far enough that the hole for the screw in the center cover is lined up with its corresponding receptacle in the door.
- Replace the screw. Read more...
Your Price
$139.30
In Stock
Jenn-Air Refrigerator Flipper Assembly
PartSelect Number PS11749098
Manufacturer Part Number WPW10151713
This flipper assembly is for refrigerators.
The flipper assembly creates an airtight seal between the doors on a French-door refrigerator.
Safely store any food that could deteriorate while the power is off and unplug the refrigerator before installing this part. Wear work gloves to protect your hands.
Fixes these symptoms
- Door won’t open or close
- See more...
Installation Instructions
George from Washingtonville, NY
Broken top mount mullion, broken pin and deli tray lid
Parts arrived quick and installed easy. One reveiwer said his wife did theinstall and that was my inspiration. Thank you.
Read more...
Jenn-Air Refrigerator Ice Door Motor & Bracket Assembly
PartSelect Number PS11756149
Manufacturer Part Number WPW10546285
Discover the genuine Whirlpool replacement part, a vital Ice Door Motor & Bracket Assembly, synonymous with quality and durability. Engineered for a variety of Whirlpool models, this part ensures the optimal functioning of the Ice Door on the Ice Dispenser Chute. Ordinarily, this part is responsible for the opening and shutting mechanism in your refrigerator's ice dispenser chute. Remember to safely store any food that could deteriorate and unplug your refrigerator prior to installation. Don't forget to protect your hands with a pair of quality work gloves during installation. For optimal performance, verify this genuine OEM part is the correct fit for your model before usage, considering part size and shape variations.
Installation Instructions
Robert from SAN DIEGO, CA
Ice Dispenser worked poorly causing frequent frost buildups and poor dispenser operation
This built-in model requires complete removal of stainless steel door "Cover". A trim piece that covers the screws on the left side of the door requires lowering the refrigerator on to the rolling legs and moving it forward for access. The tipover strap on top of the refrigerator must be removed first. One the door is slowly lowered and then pulled out you need to remove the trim piece then remove the screws on the bottom, top, and lft side. Then remove the four screws from the internal side of the dispenser. With assistance slowly pull the entire front cover from the door which gives access to the internal electronic pad. Be very careful with the door cover as the edges are razor sharp stainless steel. Remove the electronic pad (4 socket screws) and move it to provide access to the motor bracket assembly. Remove assembly (2 screws) and replace with new. This includes removing the connector plug which came off easily. The replacement assembly was a new design from the original which appeared to be much better design. This was very simple to replace. Now the hardest part is "popping" the front door cover back on the front which is a two person job. I taped the trim attachment strips to the inside of the cover (left and bottom sides had the strip) so the screw holes would line up when the cover is replaced. All four sides must slide on at the same time with a slight advantage to the side with the handle. Note: this can be dangerous because of the sharp edges and very precise fit...a blood donation was required because of an errant hand and the quick snap in popping the door in place. Once its back on, reverse the process of replacing the screws and carefully moving back in to position and raising back up to previous height. I had very little information on how to do this so I did it slowly and deliberately so it took me about two hours. The dispenser now works better then ever and I have had no frost build up....I wish I had done it 4 years ago.
Read more...
Your Price
$59.11
In Stock
Jenn-Air Refrigerator Dairy Door
PartSelect Number PS11743546
Manufacturer Part Number WP67003637
This Refrigerator Dairy Door is a genuine replacement cover designed to protect dairy items stored in the door bin, such as butter, cheese, and yogurt. Made from clear, durable plastic, it helps maintain a slightly cooler environment within the compartment to preserve freshness. The approximate dimensions are 11" wide by 7" high, with technical specifications listed as about 11.75" L x 5.25" W x 5.75" H. Installation is simple—just snap the cover into place on the designated bin.
Installation Instructions
Mark from DEARBORN, MI
Our old plastic dairy door had a broken part and it kept coming undone
The new door just popped into place. Took seconds to complete. Fast delivery too.
Read more...
Jenn-Air Refrigerator Door Mullion Rail
PartSelect Number PS12348487
Manufacturer Part Number W11177241
This door mullion rail, also known as a flipper assembly, is designed to create a tight seal between the doors of French door refrigerators. Finished in white and built for durability, it helps maintain optimal internal temperatures by preventing air leaks. If your refrigerator is too warm or the doors aren’t sealing properly, replacing this component may restore performance. Installation is straightforward, but be sure to confirm compatibility with your appliance model before purchasing.
Fixes these symptoms
- Door won’t open or close
- See more...
Jenn-Air Refrigerator Door-comp
PartSelect Number PS11752673
Manufacturer Part Number WPW10316885
This part is the replacement compartment door for your refrigerator. It is made of clear plastic and is approximately 14 inches wide and 4 inches long. The compartment door connects to the refrigerator shelf and it can be raised and lowered to access the shelf. The main reason you would want to replace the compartment door, is if your old door is cracked or missing. This part is sold individually and is an OEM part sourced directly from the manufacturer.
Your Price
$15.70
In Stock
Jenn-Air Refrigerator Natural Door Closer
PartSelect Number PS2059251
Manufacturer Part Number 61003647
This part is the replacement natural door closer for your refrigerator. It is black in color and is approximately 3 inches by 2 inches in size. The natural door closer allows your refrigerator door to open and close smoothly. If your door won’t open or close, the door is sweating, or the refrigerator is too warm, it could be an indication that you need to replace the door closer. You will also want to replace the door closer if it is cracked, broken, or missing. This part is sold individually and is an OEM part sourced directly from the manufacturer.
Fixes these symptoms
- Door Sweating
- Door won’t open or close
- Fridge too warm
- See more...
Installation Instructions
Eva from Macomb, IL
The food side of my Maytag wide by side refrigerator was 80 degrees.
Okay all you ladies out there, listen up. Yep, I am a girl and had never worked on a refrigerator before. I googled the model of frig and the problem. Finding that one of two things were probably wrong, I went to parts select and ordered both parts. Two days later they arrived. I replaced the coil and thermostat and waited one day -- the food side still did not cool down. I replaced the frost board and immediately the unit started to cool. I had called a repairman on Saturday and was told that they couldn't make an appointment until the following Friday because of a tremendous work load. I had the refrigerator running by Thursday, the day before anyone could even take a look at my refrigerator. Even though I spent $30 on a part I didn't need, I saved a bundle, the house call would of been more than $30.
Read more...
Jenn-Air Refrigerator Door Compartment
PartSelect Number PS16620397
Manufacturer Part Number W11553221
Introducing the DOOR-COMP Door Utility Bin by Whirlpool! As a genuine OEM part, it fits seamlessly with specific models of Whirlpool-designed fridges. This door bin cover shields your stored items in the door bin and keeps them from falling out while providing an aesthetic finish to your appliance. The product design may have minor aesthetic differences but rest assured, the fit and function will be as you expect. So begin your DIY project with absolute confidence using this genuine Whirlpool DOOR-COMP Door Utility Bin. Remember to follow the installation instructions carefully as mentioned in the owner's manual.
Related Jenn-Air Refrigerator Parts
- All Jenn-Air Refrigerator parts
- Jenn-Air Refrigerator Brackets and Flanges
- Jenn-Air Refrigerator Caps and Lids
- Jenn-Air Refrigerator Circuit Boards and Touch Pads
- Jenn-Air Refrigerator Compressors
- Jenn-Air Refrigerator Deflectors and Chutes
- Jenn-Air Refrigerator Dispensers
- Jenn-Air Refrigerator Drawers and Glides
- Jenn-Air Refrigerator Ducts and Vents
- Jenn-Air Refrigerator Elements and Burners
- Jenn-Air Refrigerator Fans and Blowers
- Jenn-Air Refrigerator Filters
- Jenn-Air Refrigerator Grilles and Kickplates
- Jenn-Air Refrigerator Handles
- Jenn-Air Refrigerator Hardware
- Jenn-Air Refrigerator Hinges
- Jenn-Air Refrigerator Hoses and Tubes
- Jenn-Air Refrigerator Ice Makers
- Jenn-Air Refrigerator Insulations
- Jenn-Air Refrigerator Knobs
- Jenn-Air Refrigerator Lights and Bulbs
- Jenn-Air Refrigerator Motors
- Jenn-Air Refrigerator Panels
- Jenn-Air Refrigerator Seals and Gaskets
- Jenn-Air Refrigerator Sensors
- Jenn-Air Refrigerator Switches
- Jenn-Air Refrigerator Tanks and Containers
- Jenn-Air Refrigerator Thermostats
- Jenn-Air Refrigerator Trays and Shelves
- Jenn-Air Refrigerator Trims
- Jenn-Air Refrigerator Valves
- Jenn-Air Refrigerator Wheels and Rollers
- Jenn-Air Refrigerator Wire Plugs and Connectors