Sump WD18X10026

Hello Glen, the sump is a very easy repair. To do this you would unplug the unit and turn off water supply then uninstall the dishwasher from its position, pull it out completely and put on its side. Remove the top sump clamp, and remove the three other clamps. Pull out the sensor, then remove the sump. You will reuse the clamps from the old sump. Remove the sump plate as well, to be reused. You would reinstall the plate into the new sump, then slide the clamps onto the sump sleeves. Install the new sump. Slide in the check valve first, Push the sump on the top lip and then slide the drain pump into the sump. Tighten the clamps, tile the appliance back upright then reinstall the dishwasher into the opening and reattach the water supply and connect power. I hope this helps!

Hello Mike, thank you for your question. The white rubber connector that is right below the fine filter is part number WD18X10010. Please enter the part number into the site for current price and availability as well as a picture of the part. Good luck with your repair!

Hello Lora, Thank you for your inquiry. This is the white plastic sump inlet. It appears that the part that you are looking for may be part of the pump adaptor part# WD12X10308. Hope this helps!

Hello Lora, Thank you for your inquiry. This is the white plastic sump inlet, the clamps are sold separately. Hope this helps!

Hello Bryan, Thank you for the question. There are a few parts to check. You can start with the Piston and Nut Assembly, PartSelect Number PS260690. Body Valve and Drain Check, PartSelect Number PS260545 and the Impeller and Seal Kit, PartSelect Number PS259598 for any damage or wear. if everything checks out good, you may need to replace the Motor and Pump Kit, PartSelect Number PS260801. Hope this helps!

Hello Juan, thank you for your question. We would recommend cleaning the spray arm blades and filter under the lower spray arm and the sump. If cleaning the unit doesn't fix the problem, we would recommend using this to rebuild the circulation pump which pushes water through the unit. That is PartSelect Number: PS1017766. I hope this helps!

Hello Darrell, thank you for your question. Yes, the sump could be the issue or the Part #: PS1017766 Circulation Pump Impeller Kit that connects the sump to the circulation pump. I hope this helps.

Hello Robert, Thank you for the question. According to the Website Availability, this is a Special Order part. This means we do not keep them in stock and order them in from GE once we have an order for one. As long as GE has stock ready to ship, this takes about 10-15 Business Days for the part to arrive at the Warehouse and approximately 3-7 business days to ship out and arrive top you. We hope this helps!

Hi Daphne, Thank you for your question. The part number listed under your model number for the sump is PS959014. If you need the sump and filter housing, the part number listed for it is PS2370522. If you need help placing an order for these parts, customer service is open 7 days a week and anyone will be happy to assist you. Please feel free to give us a call. We look forward to hearing from you!

Hello Don, Thank you for your inquiry. This is one of the parts that can cause this issue. We would also recommend checking the water inlet valve, the tub gasket, the fine filter, and the drain hoses. We hope this helps and if you need help placing an order, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you!