All Installation Instructions for Hotpoint Range RGB745BEA6WH

Burnt burner

Just put it on. Quite proud of myself for figuring out what and how to get the part however! The website was very helpful.

Parts Used:

Burner Head - Medium - 9500

Janine from Wind Gap, PA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

7 of 12 people found this instruction helpful.

Was this instruction helpful to you?

Needed To Replace Burner

Took longer to open the box.

Parts Used:

Small Burner - 5K

Robert K from York, PA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

5 of 6 people found this instruction helpful.

Was this instruction helpful to you?

Oven didn't work properly - stopped preheating, the started on its own when turned off

The part is not an exact replacement for the original. But it does fit perfectly. The electric connections are in different places, but they are marked (and so was the original), so that was easy enough. Part has a different look compared to original, but once installed, it is fine. Hardest part was figuring out how to take apart the control panel. New part solved all our problems. Make sure you order the new knob. The shaft is different, so your original knob will not work.

Parts Used:

Electronic Control

Thermostat Knob - Black

Michael from MARQUETTE, MI
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Wrench (Adjustable)

4 of 4 people found this instruction helpful.

Was this instruction helpful to you?

old blackened oven racks

Replaced old with new.

Parts Used:

Oven Rack

Roger from Falls Church, VA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

8 of 17 people found this instruction helpful.

Was this instruction helpful to you?

Wife broke gas lines when trying to clean under hood

Removed old line with wrench and attached new line to gas valve first. Then lowered hood to the stop and attached gas line to burners.........very easy and works fine now.

Parts Used:

Burner Tube - Left Front

Burner Tube - Right Front

Scott from Corinth, MS
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Wrench set

4 of 6 people found this instruction helpful.

Was this instruction helpful to you?

Burner on stove not working correctly

Order parts and installed - no tools needed - completed repairs less than 1 minute

Parts Used:

Burner Head - Medium - 9500

Trevor from Eldersburg, MD
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

4 of 6 people found this instruction helpful.

Was this instruction helpful to you?

none

slid the old ones out and slid the new ones in. done

Parts Used:

Oven Rack

Michael from Laughlin, NV
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Oven will not preheat. Pulses on an off.

Turned off the gas. Disconnected gas inlet, burner supply line and oven supply line from regulator. Unscrewed regulator from its bracket. Replaced with new regulator in reverse order and added teflon tape suitable for gas lines to all threads.

Unfortunately, the regulator was not the cause of the problem and the oven still does not prehead - acts exactly the same.

Parts Used:

Pressure Regulator

Paul from San Francisco, CA
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers, Socket set, Wrench (Adjustable), Wrench set

7 of 15 people found this instruction helpful.

Was this instruction helpful to you?

couldn't set clock or turn oven on

removed 4 screws in the back to access circuit board.unplugged connector and four wires.removed 4 screws that held circuit board.installed new board and reverse procedures

Parts Used:

Electronic Control