KHEV01RSS0 KitchenAid Dryer - Instructions

Removed the bottom front panel. The difficulty was in locating and testing the components because of access. Removing the heater required removing the heat shield and bracket and restraining screws, and then pulling out the heater with pliers which was stuck because of age. Dryer now works fine.

My dryer is one of the energy efficient models (HE). The video for the installations was knowledgeable, but getting into the front of mine only required removing to screws from the bottom left & right corner (not using a putty knife to pop the springs). the plate on the front drops after that. Also when taking out the tube with the dryer element in it took a lot more twisting inside the frame to get it loose. Still turn it after the wire connections have been pulled off a little bit better than 1/4 of a turn. Also the heating element was in there really, really tight. It required tapping on the plate with a screw driver and a rubber hammer to take it out & put in (not that tough). After putting it in a 1/4 of a turn so that the tab was inside the blower tube. everything after that was pretty easy. The video showed this all being done in a clean dryer. It has been my experience that before all is running & closed back up that a vacuum or shop vac needs to go thru there to clean things up & prevent a future fire.

Opened up unit and followed tech directions on inside pocket to isolate the problem to the heating element. Pulled it out and sure enough it was broken in one place. Found the part on PartSelect and ordered it on Saturday, received it on Wednesday. Replaced the new heating element into the assembly, reinstalled the assembly and connected the wires. Works like new now!