All Installation Instructions for General Electric Dishwasher GSD6000G02WW

Leaking at the valve

Just like the video and replaced it

Parts Used:

Water Inlet Valve

Brian from DERRY, PA
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers, Wrench (Adjustable), Wrench set

1 person found this instruction helpful.

Was this instruction helpful to you?

No water in

Pulled washer out. Found water inlet valve in lower left. Shut off power and water. Replaced valve with new.

Parts Used:

Water Inlet Valve

Everett from FREDERICKSBRG, VA
Difficulty Level:
Easy
Total Repair Time:
1- 2 hours
Tools:
Nutdriver, Pliers, Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

Would only drain intermittenly

Thought it might be check flapper valve on drain pump, so I replaced fairly easily, per instructions. When doing, I noticed the attached relay wires were not secure. When it was on the drain cycle one of the relay wires vibrated badly and loosened the connection enough to only work occasionaly. Would like to put new relay on the pump but they do not sell separately from the pump. (one assembly). I resecured connection and will wait till relay gives out and buy new assembly, but for now it's working perfectly!

Parts Used:

Check Valve Flapper

C. from Lexington, KY
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

wouldn't drain

Removed the dishwasher to get at the defective parts and removed,than replaced the two check valves and reassemble.

Parts Used:

Check Valve Flapper

JOHN D. from GOSHEN, IN
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Nutdriver, Pliers, Screw drivers, Wrench (Adjustable)

3 of 7 people found this instruction helpful.

Was this instruction helpful to you?

Detergent dispenser did not work

Followed the instruction video on your website. It was accurate and valid. The repair should have taken 15 mins., instead one of the screws holding the dispenser was frozen. Tried DW-40, and liquid wrench. Neither worked because the screw was in plastic.Finally got out the Dremel and cutting wheels. Had to cut away enough of the unit until I could get at the screw (it was the center bottom one). Sliced through some more of the housing, then cut a notch in the screw head deep enough so I could apply enough pressure with a flat blade screwdriver to open it. After that things went as smoothly as could be expected.A bad design and cheap materials.

Parts Used:

Detergent Dispenser with Rinse Cap

ARTHUR from OAK PARK, IL
Difficulty Level:
Very Difficult
Total Repair Time:
More than 2 hours
Tools:
Pliers, Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

Roller Broken on dishwasher

Popped out Old Roller, put in new one, pushing it together with a pair of pliers.

My only regret is that i didn't check the other side of the dishwasher... the other roller was broken also, and now i have to pay 5.95 shipping & handling for a .29 cent item

Check all your rollers before you buy just one!!!!!

Parts Used:

Dishwasher Dishrack Rollers and Axles

Sean from Cicero, NY
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers

1 person found this instruction helpful.

Was this instruction helpful to you?

plastic snap retainers broken

Although the replacement part was different that the original, the replacement is a better design and attached with no difficulty.

Parts Used:

Dishwasher Dishrack Rollers and Axles

Bill from GOLDEN, CO
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

Bottom door seal leaking

Do not overlook the two screws on the bottom of the outer door panel.

Parts Used:

Short Bottom Door Seal

ROY G from GAINESVILLE, VA
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Dishwasher was stopping mid-cycle and beeping every 15 seconds (as if the door had been opened)

I watched this video: https://www.youtube.com/watch?v=-k0iZGwMOGc
And then I did exactly what it said! It was easy. Plus, when I opened the panel I could see the old switch interlock assembly was melted on one side, so I knew I had gotten the right part!

Parts Used:

SWITCH INTERLOCK Assembly

Anna from BRIDGEPORT, WA
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

Water and soap leaking out the bottom of the door while operating.

I Googled bottom door gasket replacement on GE model and found several videos walking me through the process. I followed one of them and successfully replaced the gasket without pulling the appliance out.

Parts Used:

Short Bottom Door Seal

Larry from NAPLES, FL
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

Hinge arm link wore out

Used Phillips screwdriver to undo brackets that keep dishwasher in place. Pulled out dishwasher from underneath the counter. Placed hinge arm in spring, hooked spring onto clip, placed hinge arm in clip. Put back dishwasher under the counter and screwed in place. Took all of 15 minutes. Saved 185.00 for service call.

Parts Used: