GC2223GEKB Maytag Refrigerator - Instructions

Repair was tremendously easy. All I did was remove old light switch by prying out with screw driver and plugging in the new light switch and pushing it into the hole. Simple! The instructions weren't needed, but they were very thorough.

Ordered from P S and very fast service customer service was great. I would recomend P S to anyone that needs parts.

Remove all door. Snap in new door. No tools required.

Removed 6 screws total and removed the entire Auger and Ice Crusher. The broken Helix just fell off, I put the new one on after a little finagaling to get it lined up right and it just snap into place. Replace the screws, put the bucket back, dumped in the Ice and the dispenser started working Fine.

Shut off water supply. filter is located in the upper right hand corner of the refrigerator on the inside. open the drop-down door. by hand pull the filter downward. then twist it to the left one quarter turn. it should pull out. I replaced it with a filter bypass plug. you can purchase a high quality filter to replace.it don't buy cheap filter.I made that mistake! hope this helps good luck!

removed the ice maker tray and screws and that held the cover to the rotating mechanism that crushes and dispenses the ice. the end cap is then attached to the rotating mechanism and ice container, the cover is replaced;finishing the job.

installed new parts

The best part of the repair was how easy it was to find and order the part. Instead of searching the parts houses around town I just went to the PartSelect web site, quickly found and ordered the part in about five minutes, received the part the next day at my home and was ready to make the repair. Wow! What a pleasure for something to work the way it was meant to. Removed old switch located by prying out with sharp knife or screwdriver. Don't worry about breaking it or cracking plastic. Disconnect(unplug) wires from back of switch. Replace (plug-in) wires on back of new switch. Insert in location of old switch. Finisheed.

Just put the dairy tray were I wanted it. Will do the same with the crisper drawer when it arrives.

Removed ice bucket, removed front of old ice bucker, removed ice auger, steralized new bucket and replaced all parts. Slid new bucket in refrig.

With a socket set wrench this is the second time it happen no problem

Removed the old one put in a new one, fairly simple. Would have been much easier if I had called the manufacturer first then ordered the part. The first part I ordered was the ice bucket, I thought I was getting the crusher mechanism, but it turned out to be the bucket only. When I finally got the right part it was really easy. I went ahead and kept the new bucket anyway.

Just removed old parts and replaced with new parts

I'm a pretty handy person generally but I had to call on my engineer neighbor to help. I've never soldered before so I didn't feel comfortable installing the thermistor. I had everything ready for him so all he did was cut the existing thermistor out, strip the wires on the replacement , solder and tape and he was seriously done in 10 minutes! I replaced everything and plugged the fridge in to find that my fridge still freezes everything. I have now ordered the damper control and gasket to hopefully fix this problem.

removed ice bin from the fridge. snaped off the front plate. Removed 4 screws. this led to freeing up the auger. removed it and put the auger into the new bin and replace the front parts. Put storage bin back into fridge. Done. Might want to keep some ice cubes in a separte container until done. Not hard.