Thermador Range Elements and Burners
- Search your model number to find:
- Genuine OEM parts guaranteed to fit
- Free manuals and guides
- Repair instructions and videos
Popular Thermador Range Elements and Burners
Thermador Range HEATER-ELEMENT
PartSelect Number PS8704893
Manufacturer Part Number 00367648
This OEM heater element, or bake element, is approximately 22 inches wide and generates heat in your oven for cooking and baking. It is commonly located at the bottom of the oven. The element is secured to a bracket with two screws and connects to the power source. You may suspect a faulty element if your oven cooks food unevenly or fails to heat up. If the element has breaks, bulges, or holes in the heating coil, it needs to be replaced. To check if it has shorted out, use a multimeter in continuity mode or the lowest ohms setting. Touch the probes to the wire terminals. A functioning element should cause the multimeter to beep or display a reading of approximately 10 to 75 ohms. To replace the element, start by shutting off the oven at the circuit breaker and unplugging the appliance. Open the oven door and pull out the racks. Unthread the screws at the back of the oven using a screwdriver. Gently pull the element out to access the wiring behind it, ensuring not to pull out any insulation or lose the wires in the insulation or behind the stove. Please keep in mind that this replacement part does not come with any accompanying hardware.
Thermador Range Cooktop Burner Base
PartSelect Number PS8723014
Manufacturer Part Number 00494134
This burner base is for cooktops. Burner base holds the orifice and directs the gas to the burner head.
Thermador Range Surface Burner Base Assembly
This resulted in needing to replace the venturi tube and its holder. Easy once you have access. Internal cooktop pieces are super simple and easy to install.
CLUE - It you must replace a Venturi Tube - you cannot find one to purchase. You must buy the full "Repair-Set" (kit comes with 6 tubes). Bosch (Thermador) Part Number 11016284. Read more...
PartSelect Number PS8730333
Manufacturer Part Number 00645412
This surface burner base assembly is for ranges. Surface burner base assembly holds the orifice and directs the gas to the burner head.
Installation Instructions
John from HUNTINGTN BCH, CA
Random igniter sparking and burner light always on.
The seriously tough parts of this job is removing the five Venturi Tubes that hold the burners in place and the cooktop surface down. One had corroded badly so the brass nut (it is the venturi tub itself) have to be removed by drilling. Luckily, the other four unscrewed.This resulted in needing to replace the venturi tube and its holder. Easy once you have access. Internal cooktop pieces are super simple and easy to install.
CLUE - It you must replace a Venturi Tube - you cannot find one to purchase. You must buy the full "Repair-Set" (kit comes with 6 tubes). Bosch (Thermador) Part Number 11016284. Read more...
Related Thermador Range Parts
- All Thermador Range parts
- Thermador Range Brackets and Flanges
- Thermador Range Caps and Lids
- Thermador Range Doors
- Thermador Range Drawers and Glides
- Thermador Range Ducts and Vents
- Thermador Range Fans and Blowers
- Thermador Range Fuses
- Thermador Range Handles
- Thermador Range Hoses and Tubes
- Thermador Range Knobs
- Thermador Range Latches
- Thermador Range Motors
- Thermador Range Panels
- Thermador Range Seals and Gaskets
- Thermador Range Springs and Shock Absorbers
- Thermador Range Switches
- Thermador Range Trays and Shelves
- Thermador Range Valves