Timer Knob with Clip WH1X2754

Part came in after a couple days and it was a simple push on to the stem and it was done! Not the most difficult fix. Getting the right part first time was the best part!

Used needle nose pliers to pull out clip on control knob. Removed control knob. Removed broken pieces of the dial the were still on the metal wand. Inserted new dial in the correct place. Put on new knob. Done!

Removed old clip and remnants of old shaft. The key is.to keep the clip in the new knob and push it over the cycle shaft.

Took back panel off dial section and luckly slide dial mechanism back onto it's bracket and tightened it down. Closed panel section back up. Clipped new dial part on front panel and it worked!

I read all the other inputs before I started the job. It was a very simple repair.

could not have been easier. It took a pair of pliers and a few minutes time to remove the remaining portion of the old knob from the spindle. Then simply push the new knob into place.worked perfectly

used pliers to pull broken portion of knob off timer shaft then pushed new timer knob with clip onto shaft.

Replaced the knob. Identified the appropriate knob which was easy because of the drawings on your site (PS271124 Timer Knob with Clip). Ordered knob, arrived the next day. Slipped the knob on the washing maching controller. Perfect.....took 2-seconds.

Slipped the new knob on and inserted the clip and we were ready to wash

First off, the repair part arrived in only two days. The schematic was very detailed and accurate on your web site. Once the part arrived and removed from the bag, it was a snap to install with just a needle nosed pliers. Total time was less than 5 minutes. This was the first time I had used PartSelect and you can bet I'll be back. Thanks ... Read more again. Gary K. in IN.