Timer Knob with Clip

Used a screw driver and needle nose pliers to remove clip from behind the timer knob. Took 2 minutes to remove clip, i admit it was a little tricky but once you get a grip on the clip very easily removed. Replaced with new knob, old knob gear was completley stripped . put the new clip on and presto, Like brand new.A normal service call would of ran me 45.00 just to tell me what was wrong with the machine.

All I had to do was pull out the broken timer dial assembly and push in the new one.

had to replace the timer assy. the removal of the clip on the back of the timer knob was a little tricky. i removed the 4 torx screws from the top of the washer. disconnected the gang plug from the timer assy. reinstalled timer, gang plug, reinstalled top panel and put on new knobs.
total time was 10 minutes. if all repairs could be this easy i would change professions

First off, the repair part arrived in only two days. The schematic was very detailed and accurate on your web site. Once the part arrived and removed from the bag, it was a snap to install with just a needle nosed pliers. Total time was less than 5 minutes. This was the first time I had used PartSelect and you can bet I'll be back. Thanks again. Gary K. in IN.

I read all the other inputs before I started the job. It was a very simple repair.

I simply ordered the new part from Parts Select.com. It arrived quickly. I opened the package and easily pushed the knob onto the selecter. Opening the package was harder to do than the actual repair.

Just took the dail off and put the knob on and slid the clip on. It was harder to take the glue off that we put on the knob!!

It was really easy. I removed the broken part of the knob from the metal center knob assembly. Cleaned out the "teeth" of the inner knob assembly to remove any debris from the plastic part that broke. I made sure that the metal center knob assembly was pulled out all the way (using the pliers). I inserted the new knob making sure that the knob lined up with the arrow on the dial. Then turned it slightly to ensure that the "teeth" fit together properly. While holding the handle in place, I used the pliers to slide the clip into the slot to keep the knob in place. Once it clicked into place... I was DONE!

Replaced the knob. Identified the appropriate knob which was easy because of the drawings on your site (PS271124 Timer Knob with Clip). Ordered knob, arrived the next day. Slipped the knob on the washing maching controller. Perfect.....took 2-seconds.

Unplugged washing machine from wall. Removed screws from top of control panel and lifted it forward. Removed knobs. Unplugged timer. Unscrewed bolts holding timer and lifted the old timer out. Inserted the new timer in the slots and tightened the bolts. Plugged the timer in. Lift the control panel back into place and replaced screws on top. Replaced knobs. The White Timer Knob came with a clip in the same bag and did not have to be purchased seperately. Now I have an extra clip in case this breaks but I would not have bought the clip if the description for the timer knob said that a clip was included.