Cold Water Valve W11168740

Hi Roger, Thank you for your question. The selector switch or water temperature switch selects the water temperature for the wash and/or rinse portions of the cycle. The switch provides a circuit to supply power to the correct solenoids on the water inlet valve. If you do not have power at the solenoids on the water inlet valve, then the temperature selector switch may be at fault. Since you will be removing and testing electrical components, ensure that you unplug your washer before starting. Remove the selector switch from your appliance in order to test it, you will need to disassemble all or part of your washer’s cabinet to access it. In most models, it is attached to the frame of the washing machine. You will be testing the buttons on the switch one at a time. Begin by placing the probes on the terminals for one button, your reading should be infinity at this point, press in on the button, this should change your reading to zero, press in on another button, this should change the reading back to infinity. If the readings you receive are different than those described above, you will need a replacement selector switch. I hope this helps. Thank you and have a great day!

Hello Kenny, thank you for your question. If the water is not coming out of the cold water valve at a full capacity the valve should be replaced. The part is PartSelect Number: PS12348073. Please enter the part number into the site for current price and availability. Good luck with your repair!

Hello J.S, Thank you for the question. Over time the Valve can become "stuck" open or worn and allow water to leak through. If you need help placing an order, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you!

Good Day George. Thank you for your question in regards to your unit (Model Number MVWX600XW0). We do apologize but we were not able to locate the information you requested. For more specialized assistance or to speak with someone about this, we recommend calling the manufacturer of the equipment directly. They may be able to provide you with the part number that you need. Once you have this information, please feel free to check back with us for pricing and availability information. Best Regards.

Hello Frred, thank you for your question. It is normal for some of the load to be above the water line in this particular washer. We hope this helps.

Hello Jim, thank you for your inquiry. We suggest the issue is likely electronically based, so the Electronic Control PS11751502. If you need help placing an order, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you.

Hi Mike, thank you for reaching out. A faulty Water Inlet Valve can result in the washer filling up by itself, even when not in use. We would recommend replacing it, the part number is PS12348073. Please reach out to customer service if you need help placing an order, anyone will be happy to assist you. We hope that helps.