LMXS286 LG Refrigerator - Instructions

I just followed the instruction on the part , and everything was very easy.

Pulled the fridge out.
Unscrewed the back cover and the one screw holding the value assemble.
undid the 2 hoses and replaced the part.

Super SImple/

Took pics of original install, removed old valve, water tubes & plugs. Installed new valve, reconnected electronic plugs, water tubes, turned water back on and all has been well since. Thank you for your timely delivery!

The interior of the right door of LG Model LFXC22526S/08 side by side refrigerator with freezer drawer was damaged when we crossed an excavated concrete bridge span. The refrigerator is mounted in the rear of a 2022 Vanleigh Vilano. The contents of the baskets were violently lifted and dropped in to the baskets destroying the hangers that the plastic basket hung from and shatter the baskets as well. I lift the cover over the top right hinge, disconnected a 2 wire molex connector, loosened the bottom hinge bolts and the two screws at hinge right-side. The door was very light. I removed the hardware including the handle and door gasket from the damaged door and re-installed the gasket, handle and hardware (including the LG badges which I removed with a straight razor) and re-hung the replacement door in reverse order finishing with re-connecting the molex connector. I had no instructions, but the work was very straight forward. I like fixing things so this was very satisfying. And my wife was thrilled. Delivery was fast too!

The assembly sent is different than what is on the unit. The connectors do not match. We called and it seems you don’t have the correct part. The only part we have found will only connect the ice maker or the water. It will be a shame if I have to buy a new refrigerator.

Just like on YouTube very easy to do

Removed ice dispenser and display with small screwdriver from front of the fridge. Pried out the whole piece slowly. This exposed the motor that activates the chute. Plugged in the new motor before any removal to verify the motor was the problem. When it worked, removed old and installed new. 3 screws. Piece of cake.

Gave model number on website, found picture of icemaker section. Ordered part that came in 3 days and switched old for new

Repair was pretty easy but be ready to possibly switch out the wiring harness. The new ice maker had a smaller connector that would not fit the connector built into the door of the fridge. I had to pull the harness from my old ice maker and swap it onto the new maker. After that was done, everything mated up perfectly and worked fine.

Removed the damaged tube and replaced the it with a new one.

Uncoupled the old connector, replaced with new connector and attached supply line. Repair easy with right part, prior to ordering the right part I had tried a compression fitting and it still leaked. U-tube and others demonstrating repair assured me I was on the right path.

unfortunately my fridge stopped working. I purchased another but wanted to try and repair the old one. when ew one arrived, the old one was supposed to be put in garage but instead was hauled away. Had delivery return next day but they had as already removed and lost the handle screw for the bottom freezer and the screw that holds handle in place. ordered the handle screw and picked up the nut. very simple to install the screw and put handle back on.

Remove push plate for water/ice maker switch, remove 2 screws and 2 wires for switch. Replace with new.