KUDA22ST5 KitchenAid Dishwasher - Instructions

Warm rollers and holders in warm water for 2 min each slide on all done

slid old tube pieces off slid new hose on

After checking for blockages in the drain line and finding none, I disassembled the wash wand assembly and discovered a gasket that had really deteriorated. Since there was nothing else apparently wrong, I took a chance and went shopping for the gasket. None of my local stores could provided me one so I searched on line and found it at Partselect. It had to be special ordered and that took a while, but when it arrived, I put the new gasket in and had a perfect dishwasher again for less than 15 bucks. The schematic I was able to print from your website was invaluable.

I was trying to avoid having to buy a new dishwasher before the holidays. I went on YouTube and found the dirty dishes may mean bad water inlet valve. So, I used my meter to see if the valve was bad and sure enough it was. I ordered the part from Part Select. Once I received the part I removed the old one. Be sure to put a towel down to catch the excess water. The bracket that came with the new prt was a different configuration, but i swapped the new with old and it worked. I addition to the valve being bad the dishwasher upper and lower arms were somewhat clogged. I looked online again and followed YouTube instructions to clean. The dishwasher is cleaning like it is new. I would recommend to anyone doing work on their dishwasher to use part select and thoroughly clean the upper and lower arm.

Removed the old tube with the aid of a knife to cut one end off the fitting. Then I lubed each end of the tube with dish washing soap and slipped them on. Done in 10 minutes. Easier to do if the top rack is removed for better access to the hose connections.

I placed the hose on one side after placing one end in boiling water. I placed the other end in the hot water and pushed it on.

took old tube of and heaten new tube to soften it. put some plumber grease on ends and slipped it on. longest time was boiling the water.

All I had to do was remove the damaged hose and replace it with the new hose. It took all of 5 minutes. The dishwasher is working like new!

Everything worked perfectly---thanks to the suggestion of your call center agent. She suggested that since the replacement door handles were no longer available, I should consider repainting them--it worked like a charm. Please tell her she was a life saver. We rent that house in Fl and my returning tenants had complained about the discoloring refer handles. Thank you

While replacing the water valve I broke the float switch. Ordered the switch....it was here in 2 days. Great service! Will use this company again....I hope not all that much. lol
I am a retired Sears service tech, but not a dishwaher tech.
Love Parts Select!
Thanks guys,
Doug

I simply removed the broken wheel brackets and snapped new ones on. then the wheel just sliped on. It took some good hand strength.

Removed the door cover and replaced the bi-metal.

put new switch and new gasket on old float stem with old nut. but it still overflows about 1/2 cup of water through stem

Went very well. The repair tech had to pull out dishwasher, check for a clog drained the water out of dishwasher by pumping into a container. All good, not sure why it did not drain for me. Repair tech got it working. I am happy.

Took off front panel and removed the faulty part, installed the new one and started it up.