All Installation Instructions for General Electric Range J35002

Broiler Element burned out.

The replacement was straightforward, six screws. Instructions were provided with the part along with the necessary screws to fit the new element terminals.
Open the breaker, verify power is off, remove the old burner. Install the new burner and mounting bracket. Restore power and test. In and out in less then thirty minutes.

Parts Used:

Broil Element

George from Lecanto,, FL
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

old units did not fit properly, and looked aged

followed instruction that came with the parts. Looks great and was easy to install.

Parts Used:

8 Inch Surface Burner

William from Yukon, OK
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Screw drivers

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

Burner not heating properly

1. The infinite switch had several knobs which would fit the switch shaft. Read the directions included with the switch in order to have the shaft fit the proper knob. You can break the shaft with two pairs of pliers. 2. Move the stove away from the wall and unplug it. 3. Remove the 1/4 screws from the back side of the stove and remove the back panel, exposing the switch. 4. Remove the wires one at a time and put them on the new switch. The terminals are L1, L2, P, H1 & H2. The Pilot (p) has a smaller terminal so you don't get it mixed up. Generally L1 is black, L1 is red, P is yellow, H1 and H2 can be blue, brown, yellow, orange or one of these colors striped on a white wire. 5. Remove the old switch from the stove and be sure to save the two mounting screws. 6. Position the new switch so that the side of the switch marked "top" is on top. 7. Install the screws on the new switch and put the knob on it. 8. Carefully test the burner. 9. Unplug the stove and put the back cover on.

Parts Used:

Range Infinite Heat Switch Kit

Stephen from Kokomo, IN
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers, Screw drivers

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

electric burner burned out

First I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires...)

Easy has falling off a log!!!!!!!!!!!!

Parts Used:

8 Inch Surface Burner

Mark from Scranton, NC
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

both oven and broiler coils were burnt out

extremelyquick delivery on standard mail and so easy to install and really the lowest price. so happywith this company

Parts Used:

Broil Element

margaret from lantana, FL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

broil element had a "burn through", w/n turn on

less than 15 minutes R2 the part, ops ck'd good. 4ea 1/4" screw/nuts, they didn't fight me...

Parts Used:

Broil Element

BRIAN from WEST POINT, UT
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers, Socket set

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

top element in oven was broken ,not working

Removed 4 screws and removed the old element and replaced in the reverse order.

Parts Used:

Broil Element

David from Tulsa, OK
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

needed to replace drip bowl and trim ring

The replacement drip bowl and trim ring fit perfectly.

Parts Used:

Drip Bowl - 8 Inch

Trim Ring - 8 Inch

Stephanie from Kitty Hawk, NC
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

replaced trim rings and drip pans

Simple replacement on an old "built in" range in good condition but drip pans and trim rings soiled beyond cleaning. Stove top, although 20+ years old, now looks like new. So glad to find parts were still available as "universal" replacement parts for the 8 inch burner do not fit. Delivered to my door in days.

Parts Used:

Drip Bowl - 8 Inch

Drip Bowl - 6 Inch

Trim Ring - 8 Inch

Trim Ring - 6 Inch

Louise from Wesley Chapel, FL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

Old drip bowls and trim rings badly stained and dirty

It was so easy to find the correct items on your web site and they arrived in a very timely manner. Perfict fit. Now I know how to get parts when I need them.

Parts Used:

Drip Bowl - 8 Inch

Drip Bowl - 6 Inch

Trim Ring - 8 Inch

Trim Ring - 6 Inch

Ruth from Wells, ME
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

broiler element wa burned out

I shut down the electric to the oven at the circuit breaker. Then i loosened the mounting screws and pulled the element from the back wall of oven. Then i disconnected the two leads to the element with a phillips screwdriver and removed element. Installation was done in reverse order.

Parts Used:

Broil Element