GTW335ASN2WW General Electric Washer - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Threads on an inlet valve deteriorated; couldn't tighten the hot hose.
Unplug the cord and shut off hot and cold water faucets.
headache avoidance: The male threads of the inlet valve are plastic. Gently turn the female hose ends onto them at the kitchen table with the eventual position in mind then tighten.
1. Remove 4 screws holding shiny metal backplate w/ 1/4" socket (easy)
2. Pry tabs loose, top of plate (easy).
3. Pull electric leads from 2 solenoids (easy).
4. Remove 2 long screws holding upper painted structure (easy).
5. Remove 2 screws holding valve in place (easy).
6. Tilt and slide the valve loose and pull it out (easy).
7. Replace valve and reverse steps 6-1.
n.b. no inside water tubes; water drips straight into tub
Also, an hour should be enough. I spent more time than needed guessing, dealing with a few issues, opening the machine again, starting over, etc.
ps. I guessed at the age.
headache avoidance: The male threads of the inlet valve are plastic. Gently turn the female hose ends onto them at the kitchen table with the eventual position in mind then tighten.
1. Remove 4 screws holding shiny metal backplate w/ 1/4" socket (easy)
2. Pry tabs loose, top of plate (easy).
3. Pull electric leads from 2 solenoids (easy).
4. Remove 2 long screws holding upper painted structure (easy).
5. Remove 2 screws holding valve in place (easy).
6. Tilt and slide the valve loose and pull it out (easy).
7. Replace valve and reverse steps 6-1.
n.b. no inside water tubes; water drips straight into tub
Also, an hour should be enough. I spent more time than needed guessing, dealing with a few issues, opening the machine again, starting over, etc.
ps. I guessed at the age.
Parts Used:
-
Craig from TOLEDO, OH
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:More than 2 hours
-
Tools:Socket set
2 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
inner part of fabric softener dispenser base broke off
looked up part not exactly easy. that was the hard part. it was delivered next day and just had to pop into place extremely easy instalation
Parts Used:
-
Joyce from BOSSIER CITY, LA
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
2 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Replaced GE Washer lid
Removed parts from old lid (bumpers, switch component and hinges), removed old lid, then replaced parts on new lid. The new lid fit perfectly and looks great.
Parts Used:
-
William from Naples, FL
-
Difficulty Level:Very Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Washer wouldn’t drain
Remove old pump install new one. Three bolts and an electrical connection
Parts Used:
-
Ronald from Chickasha, OK
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Pliers, Screw drivers
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!