GS2125CEEW Maytag Refrigerator - Instructions

piece of cake . removed the cover - one screw in the switch and back together again - maybe 10 minutes.

follow video

Removed drive assembly end of ice bin using socket wrench to get to old ice bin drive ring. Pull drive sssembly back to get ice bin ring out of the other end of ice bin. Installed new ice bin ring and and reinstall drive assembly end.

remove the screw on the front panel---

remove old part --- snap the new piece in

replace screw

Removed front dispenser trim panel by removing 2 torx screws under drip tray. Removed dispenser module by removing 3 torx screws. Unplug electrical connector on LHS of module. Removed the gray actuator pad & the limit switch by removing a small phillips head screw. Removed 2 spade connectors to switch & replaced with new switch. Reverse the steps above to re-assemble the dispenser module & trim panel to the door.

Removed 5 screws, took unit apart, replaced part, put back together. Just be sure to have the solenoid connected to the ice door lever the right way before you reassemble.

it was a cake walk,removed a few screws unpluged assembly installed new switch didnt get shocked, nothing started on fire, ice came out like it should afterwards

I first read the repair hints on your web site and proceeded to follow the instructions that were there. This was a very easy fix and did not take long to repair. I did get a bit of an electrical shock when I accidentally touched the electronic board with the back of my hand. But again, the instructions are very helpful and anything that I would add for instructions would just be repeating what others have said.

I read what other people had done so I tried the easiest solution--Forced, without breaking, the plastic & fit the ring right where it needed to be.

Pried out ice blade bar and removed broken water fill cup and replaced with new one.The whole repair costs $9.52 So I saved $ 190 over the cost of Appliance man visit!
It would have been $150& $50 for visit to replace ice maker unit.

I removed the ice door panel. I use a torque driver to remove the 3 screws holding it on. Quick change of the broken door flap and reassemble the unit. Very quick and easy job. Just be sure to replace the activation piston that opens the door back properly. Good luck with you repair.

Removed overfill tray by sliding out away from door, 2 screws underneath need to be removed and front of tray cover can be slid up and removed unplug 1 small cable if you want to set aside. 4 screws need to be removed to pull complete ice tray door assy. away from fridge door. Ice door can then be remove and new one slipped into solenoid jaws that hold it closed until activation.

I took off the front panel of the ice/water dispenser and replaced the broken round thing that opens to allow the ice to come through the chute.

Generally I followed the instructions left on the website by others who had accomplished the repair. (A couple of them are very good, and I don't see the need to repeat their instructions.) However, I had two problems in the process. First, without any clear drawings, I mistakenly installed the ice chute door backwards. The shape of the door back matches the shape of the chute, so I made a mistake. Once I realized the mistake and placed the rubberized side of the door to face the chute, the project moved quickly. Secondly, I faced the same problem that most others cited. The solenoid plunger is difficult to get in the right location on the chute door strike. You must lift the strike out of its cradle, where it is held only by the pressure of the return spring, in order to seat the strike into the plunger flange. Once I overcame those two problems, the job was easy and quick. Thanks for your quick delivery of the parts.

Disassembled the control facade of the ice maker/water dispenser, then attempted to install the chute cover, only to discover that an arm connecting the chute was broken. Temporarily reassembled the chute with cover, so we can still secure water. Will need to order broken arm to finish the install.