DWXR485EB2CC General Electric Dryer - Instructions

Started out by unplugging appliance then pulled off knob, removed 4 screws that held cover in place, removed wires from switch, rotated switch to remove. reversed steps to replace.

r/r parts unit runs great

Repair was VERY easy - 4 screws total! Used google to find a video online that showed the steps.

All is necessary is remove 3 philip screws, remove the switch knob, lift a tab on the switch, rotate the switch counterclockwise and it was out. Pull wires off switch and immediately put them on the corresponding terminals of the new switch before reversing the above steps. Simple!!!

I was teaching my associate how to do this repair so I showed him how to take off the top of the dryer. Then I showed him how to replace the drum slides. I had him clean out the dryer since we had it apart, and I also showed him how to remove the drum and then reinstall it. This was a very easy repair, and he learned a lot that he otherwise would not have known. Thanks for getting the parts to me so quickly. Rob from Clarks Summit.

Your instructions were execellent
Problem is solve
Thank you

First I got the front bearing, found out I needed the slides too. It was binding at first, so I undid an earlier misadjustment I made (on the back drum mount). and it works!

very simple , unplug dryer and unhook the back of the top of dryer using a screwdriver on 6 screws. unhook clip to the rotary starter switch and unhook the three pronged plugs that go to the starter switch. replace new one that snaps into place, plug back in the three wires. screw the back of the dryer back on and your done. 6 minute job that saves you 40-50+ dollars for a repair man plus the extra money they mark up the parts

1. Unplugged dryer
2. Removed 6 phillips screws from back control panel
3. removed wires one at a time and installed on new switch
4. removed knob
5. lift lock lever and rotate switch ccw
6. installed new switch , rotate cw and be sure lock lever secures switch.
7. install back panel and knob

Pulled front panel off, popped off the old switch, popped on the new switch. Good to go.

pulled off the top, pulled off the front then replaced the plastic that was supporting the front side of the drum. fairly easy to replace although the little plastic 'slides' (you need 4 of them)

I followed the great tips from the other repairs and that part was easy. Turned out not to be the exact problem. The problem was the rear bearing shaft which in another 20 min I had the drum out and repaired. Now the dryer is like new and will hopefully last another 5 yrs.
Thanks Parts Select for your help!

I followed the directions from the previous post. It was much easier than described. I got the part, removed 4 screws, removed the top, pulled the front and replaced the part. It was all together again in 15 minutes. Dryer sounds great again! I'm so glad I didn't call a repair man!

We removed the top of the the dryer and then removed the front part. Then put the traps in place, put the other parts of the dryer back on, and turned the dryer back on. Just as simple as that. No extra fees.

Unscrewed screws took off new parts and replaced with new parts and put back together. Works great now! No Noise!